不同温度下复杂介质结构内带电规律仿真分析

卫星上某些介质结构会遭遇较大范围的温度变化, 其电导率会随之出现数量级的变化, 这将显著影响内带电结果. 受限于电导率-温度模型和内带电三维仿真工具, 该温度效应远没有得到深入研究. 为此, 在真空变温(253-353 K)和强电场(MV/m量级)条件下测试了某种星用改性聚酰亚胺介质的电导率, 借鉴Arrhenius电导率-温度模型并考虑强电场下电导率的增强效应, 发现电导活化能取值为0.40 eV时, 可得到良好的拟合结果. 在此基础上, 同时考虑辐射诱导电导率, 采用地球同步轨道恶劣电子辐射能谱, 对该类介质盘环结构进行内带电三维仿真, 发现其内带电程度随温度降低而显著增加, 带电最严重的区域位于靠近辐射源的接地面边线. 温度低于250 K时, 2 mm屏蔽铝板下该区域的场强可达到10⁷ V/m量级, 发生介质击穿放电的可能性较大. 所讨论的电导率-温度模型与内带电三维建模方法对进一步评估卫星介质结构内带电程度和做好防护设计具有重要参考意义.     

Characteristics of Atmospheric Pressure Air Glow Discharge with Aqueous Electrolyte Cathode

We investigated the characteristics of atmospheric pressure (AP) air glow discharge with aqueous electrolyte cathode. Distilled water or aqueous solutions of HNO₃, KCl, KBr and KI were utilized as a cathode. The cathode voltage drop, electric field strength, gas temperature as well as emission intensity of some lines of OI, H, K, Na and bands of N₂, OH, NO were measured at discharge current from 10 to 50 mA. The procedure of gas temperature measurement on the base of non-resolved structure of N₂(C³Π_u → B³Π_g) bands was described. The reduced electric field strength (E/N) was obtained, which showed that the discharge existed in the normal mode. On the base of these data, the regularities of optical emission were discussed.     

Characterization of poly(silylenemethylene)s by positron annihilation lifetime spectroscopy. I.

Amorphous and crystalline poly(silylenemethylene)s with the repeating PhRSiCH₂ (R : Me or Ph) units were characterized by positron annihilation lifetime spectroscopy (PALS) to gain insights into the molecular motions of these polymers. The temperature dependence of the ortho-positronium lifetime (τ₃) and intensity (I₃) was examined from 50 to 470 K for each sample. The glass transition temperature of each polymer was easily distinguished by a change in the slope of τ₃ spectrum. Both polymers exhibited a steep drop of I₃ at 130–140 K being probably assignable to the transition arising from the motions of phenyl groups, which was almost undetectable by means of differential scanning calorimetry or dynamic mechanical analysis. Several other transitions of these polymers detected by PALS are also discussed. © 1998 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 36: 755–761, 1998     

Electrical conductivity of aqueous sodium hydroxide solutions at high temperatures

Electrical conductivities of dilute sodium hydroxide aqueous solutions have been determined at 75, 100 and 150°C at 1.6 MPa using a recently developed DC-measuring technique especially suited for the study of aqueous solutions above room temperature. The data were analyzed with modern theories to obtain the infinite dilution conductivity and the association constant at the three temperatures.     

Thermodynamic quantities for the protonation of amino acid amino groups from 323.15 to 398.15 K

Flow claorimetry has been used to study the interaction of protons with glycine, DL--alanine, -alanine, DL-2-aminobutyric acid, 4-aminobutyric acid, and 6-aminocaproic acid in aqueous solutions at temperatures from 323.15 to 398.15 K. By combining the measured heats for amino acid solutions titrated with NaOH solutions with the heat of ionization for water, the log K, H^o, S^o, and C_p ^o values for the protonation of the amino groups of these amino acids have been obtained at each temperature studied. Equations are given expressing these values as functions of temperature. The H^o and S^o values increase while log K values decrease as temperacture increases. The trends for log K, H^o, S^o, and C_p ^o are discussed in terms of changes in long-range and short-range solvent effects. The trend in H^o, S^o, and C_p ^o values with temperature and with charge separation in the zwitterions is interpreted in terms of solvent-solute interactions and the electrostatic interaction between the two oppositely charged groups within the molecule.     

低温下Na //Cl-,SO42-,NO3-,H2O体系相平衡研究

采用等温溶解平衡法研究了四元体系Na+//Cl-,SO42-,NO-3-H2O在5、0、-5与-15℃下的相平衡关系。结果表明,4个温度下体系无复盐形成,平衡相图的构型基本一致;平衡相图均由3个结晶区(Na2SO4·10H2O、Na Cl和Na NO3)、3条单变量曲线(Na Cl-Na2SO4·10H2O、Na Cl-Na NO3、Na NO3-Na2SO4·10H2O)及1个共饱点(Na Cl-Na NO3-Na2SO4·10H2O)组成;4个温度下的平衡相图相比,随着温度的下降Na2SO4·10H2O结晶区不断扩大,Na Cl和Na NO3结晶区相对缩小;与该体系常温下的平衡相图相比,由于无复盐形成,低温下的相图大为简化。     

A new and reliable model for predicting methane viscosity at high pressures and high temperatures

In recent years, there has been an increase of interest in the flow of gases at relatively high pressures and high temperatures. Hydrodynamic calculation of the energy losses in the flow of gases in conduits, as well as through the porous media constituting natural petroleum reservoirs, requires knowledge of the viscosity of the fluid at the pressure and temperature involved. Although there are numerous publications concerning the viscosity of methane at atmospheric pressure, there appears to be little information available relating to the effect of pressure and temperature upon the viscosity. A survey of the literature reveals that the disagreements between published data on the viscosity of methane are common and that most investigations have been conducted over restricted temperature and pressure ranges. Experimental viscosity data for methane are presented for temperatures from 320 to 400 K and pressures from 3000 to 140000 kPa by using falling body viscometer. A summary is given to evaluate the available data for methane, and a comparison is presented for that data common to the experimental range reported in this paper. A new and reliable correlation for methane gas viscosity is presented. Predicted values are given for temperatures up to 400 K and pressures up to 140000 kPa with Average Absolute Percent Relative Error (EABS) of 0.794.     

Infrared ion spectroscopy inside a mass‐selective cryogenic 2D linear ion trap

We demonstrate operation of the first cryogenic 2D linear ion trap (LIT) with mass‐selective capabilities. This trap presents a number of advantages for infrared ion “action” spectroscopy studies, particularly those employing the “tagging/messenger” spectroscopy approach. The high trapping efficiencies, trapping capacities, and low detection limits make 2D LITs a highly suitable choice for low‐concentration analytes from scarce biological samples. In our trap, ions can be cooled down to cryogenic temperatures to achieve higher‐resolution infrared spectra, and individual ions can be mass selected prior to irradiation for a background‐free photodissociation scheme. Conveniently, multiple tagged analyte ions can be mass isolated and efficiently irradiated in the same experiment, allowing their infrared spectra to be recorded in parallel. This multiplexed approach is critical in terms of increasing the duty cycle of infrared ion spectroscopy, which is currently a key weakness of the technique. The compact design of this instrument, coupled with powerful mass selection capabilities, set the stage for making cryogenic infrared ion spectroscopy viable as a bioanalytical tool in small molecule identification.     

Directed Self‐Assembly of DNA Tiles into Complex Nanocages

Tile‐based self‐assembly is a powerful method in DNA nanotechnology and has produced a wide range of well‐defined nanostructures. But the resulting structures are relatively simple. Increasing the structural complexity and the scope of the accessible structures is an outstanding challenge in molecular self‐assembly. A strategy to partially address this problem by introducing flexibility into assembling DNA tiles and employing directing agents to control the self‐assembly process is presented. To demonstrate this strategy, a range of DNA nanocages have been rationally designed and constructed. Many of them can not be assembled otherwise. All of the resulting structures have been thoroughly characterized by gel electrophoresis and cryogenic electron microscopy. This strategy greatly expands the scope of accessible DNA nanostructures and would facilitate technological applications such as nanoguest encapsulation, drug delivery, and nanoparticle organization.     

Preparation of epoxy-acrylic latex based on bisphenol F epoxy resin

Bisphenol F based epoxy-acrylic latex with different amount of epoxy resin was successfully prepared by semi-continuous seeded emulsion polymerization. The resulting composite latexes had a narrow size distribution of about 105 nm in diameter. The DSC result showed that the epoxy resin and polyacrylate were grafting copolymerization. The FTIR spectra showed that the epoxy group had been introduced into the epoxy acrylic latex system, and the composite latex could be crosslinked with epoxy hardener at room temperature. The crosslinked composite latex film exhibited a high Tg compared to epoxy-acrylic latexes. The surface of the films with the epoxy resin was regular, and diffused into the polyacrylate phase in the epoxy-acrylic latexes films. Since the curing reactions occurred before latex particle coalescence stage, the surfaces of the cured epoxy-acrylate latex films had a number of interface particle. Compared with the acrylic latex, the thermal stability of the epoxy-acrylate latex was increased, and the stability of the cured film increased with increasing epoxy content.