考虑地表反射类型的气溶胶散射偏振特性

采用逐次阶散射法求解矢量辐射传输方程来研究气溶胶在不同地表反射模型下的散射偏振特性.首先,选取单一地表反射模型和耦合地表反射模型两种地表反射模型.然后,根据地表反射模型计算得到相应的地表反射率,进而采用逐次阶散射法对矢量辐射传输方程进行求解,得到散射光的Stokes矢量.最后,由Stokes矢量计算得出散射光的偏振度.仿真结果表明,两种地表反射模型下气溶胶单次散射的散射辐射强度和线偏振度均相等;耦合地表反射模型的总散射辐射强度和线偏振度总是大于单一地表反射模型;单一地表反射模型的气溶胶单次散射相对总散射的贡献总是大于耦合地表反射模型.研究结果对气溶胶光学特性的反演具有一定意义.     

A comparative study of mid-infrared diffuse reflection (DR) and attenuated total reflection (ATR) spectroscopy for the detection of fungal infection on RWA2-corn

An investigation into the rapid detection of mycotoxin-producing fungi on corn by two mid-infrared spectroscopic techniques was undertaken. Corn samples from a single genotype (RWA2, blanks, and contaminated with Fusarium graminearum) were ground, sieved and, after appropriate sample preparation, subjected to mid-infrared spectroscopy using two different accessories (diffuse reflection and attenuated total reflection). The measured spectra were evaluated with principal component analysis (PCA) and the blank and contaminated samples were classified by cluster analysis. Reference data for fungal metabolites were obtained with conventional methods. After extraction and clean-up, each sample was analyzed for the toxin deoxynivalenol (DON) by gas chromatography with electron capture detection (GC-ECD) and ergosterol (a parameter for the total fungal biomass) by high-performance liquid chromatography with diode array detection (HPLC-DAD). The concentration ranges for contaminated samples were 880–3600 g/kg for ergosterol and 300–2600 g/kg for DON. Classification efficiency was 100% for ATR spectra. DR spectra did not show as obvious a clustering of contaminated and blank samples. Results and trends were also observed in single spectra plots. Quantification using a PLS1 regression algorithm showed good correlation with DON reference data, but a rather high standard error of prediction (SEP) with 600 g/kg (DR) and 490 g/kg (ATR), respectively, for ergosterol. Comparing measurement procedures and results showed advantages for the ATR technique, mainly owing to its ease of use and the easier interpretation of results that were better with respect to classification and quantification.     

BEDT-TTF-based radical cation salt with the cyanurate anion: synthesis,structure, conductivity,and polarized reflection spectra

The new conducting radical cation salt, bis(ethylenedithio)tetrathiafulvalene cyanurate, was synthesized. This salt is an organic metal down to 4 K. The crystal structure, conductivity, and optical properties of the salt were studied. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 1, pp. 96–101, January, 2008.     

In situ scanning FTIR microscopy and IR imaging of Pt electrode surface towards CO adsorption

In situ scanning FTIR microscopy was built up for the first time in the present work, which consists of an FTIR apparatus, an IR microscope, an X-Y mapping stage, and the specially designed electrochemical IR cell and computer software. It has been demonstrated that this new space-resolvd in situ IR technique can be used to study vibration properties of micro-area, and to perform IR imaging of electrode surface. The chemical image obtained using this technique fur CO adsorption on Pt electrode illustrated, at a space-resolution of 10~(-2) cm, the inhomogeneity and the distribution of reactivity of micro-area of electrode surface.     

基于逆卷积神经网络的等离子体辐射分布断层重建方法

发展了一种基于逆卷积神经网络的图像级重建方法用于聚变等离子体辐射分布的断层反演.通过引入结构相似度(SSIM)作为损失函数,该方法在模拟数据实验中表现出了较好的重建效果.模拟实验结果表明,在弦积分信号噪声强度为10％、15％及20％时,该方法的重建结果依然具有良好的精确度和鲁棒性.     

Characterisation of Interfaces Between Liquid Tin and Alumina in the Presence of Titanium Alloy Additions

Neutron reflection spectroscopy has been used to characterise the composition of interfaces between liquid Sn-Ti alloys and Al₂O₃. The reflectivity profiles for both 1% and 3% Ti alloys are consistent with the presence of a layer approximately 2 nm thick at the liquid/solid interface, showing extensive segregation of Ti. The composition of this layer is not pure Ti but shows a greater Ti content than any known Ti oxide composition. In all interfaces exposed to liquid metals at elevated temperature (including pure Sn) there is a layer of thickness 20–100 nm on the alumina surface with slightly lower neutron scattering length density than pure alumina. This is interpreted as evidence for surface roughening of the Al₂O₃ surface during exposure to the liquid metal.     

基于单通道反射型电光调制器实现不同路光同时调制的方法

提出了一种利用单通道反射型聚合物电光调制器同时调制不同路光的方法。衰减全反射结构的电光调制器,其每一个衰减全反射(ATR)峰的位置分别对应于一个导波共振模式。实验系统中利用衰减全反射导膜峰作为调制通道,使其每一路光路的入射角分别对应于不同导波共振模式的工作角,就可以实现利用单通道的电光调制器同时调制不同路光。提出了三种实现两路光同时调制的模式,并给出了三种模式的调制结果。结果表明,作为调制通道的导模阶数越低,调制效率越高。在832 nm光波波长下,采用最低阶导模进行调制时可以获得42.9%的调制效率。     

Reflection and transmission at normal incidence onto air-saturated porous materials and direct measurements based on parametric demodulated ultrasonic waves

The present work is related to the characterization of air-saturated porous media by using parametric demodulated ultrasonic waves. One uses two different powerful ultrasonic emitters working either at 47 kHz or at 162 kHz which are electronically amplitude modulated over the 200 Hz-4 kHz or 2 kHz-40 kHz bandwidths respectively. The demodulation process takes place in air, due to its nonlinearity enabling to generate audio range acoustical waves or alternatively low frequency ultrasonic waves which can be used to characterize porous materials in the reflection configuration at normal incidence. Some appropriate theoretical calculations are introduced for three configurations of interest, i.e. a porous slab, a porous layer mounted onto a rigid plate, and a porous half space, in the case of the equivalent-fluid model. Comparisons between theoretical modeling and experimental data are provided and prospective industrial applications are discussed.     

基于经典光学方法的物体表面微观结构的三维成像

设计了基于经典光学方法的物体表面微观结构的三维成像实验装置以及相应计算程序,从记录不同角度平行光照射下的物体表面照度出发,经图片处理后得到物体表面的三维立体结构.     

Dual-axes differential confocal microscopy with high axial resolution and long working distance

We discover that the slight transverse offset of a point detector results in a shift of the axial intensity response curve in a dual-axes confocal microscopy (DCM). Based on this, we propose a new dual-axes differential confocal microscopy (DDCM) with high axial resolution and long working distance, in which two point detectors are placed symmetrically about the collection axis. And a signal is obtained through the differential subtraction of two signals received simultaneously by the two point detectors. Theoretical analyses and preliminary experiments indicate that DDCM is feasible and suitable for the high precision tracing measurement of microstructures and surface contours.