Search for a precursor crystal-to-crystal phase transition to amorphization in α-GeO2 and α-AlPO4 under pressure

Recent X-ray diffraction studies on α-quartz (SiO₂) by Kingmaet al [1], have shown the occurrence of a reversible, crystalline-to-crystalline, phase transition just prior to amorphization at ≈ 21 GPa. This precursor transition has also been confirmed by our recent molecular dynamics simulation study [2]. In order to investigate the possibility of a similar behaviour in other isostructural compounds, which also undergo pressure induced amorphization, α-GeO₂ and α-AlPO₄ (berlinite form) were studied using energy dispersive X-ray diffraction. In either of these materials, no such phase transition is detected prior to amorphization. The onset of amorphization and its reversal is found to be time dependent in GeO₂.     

Mössbauer study of nanodimensional nickel ferrite – mechanochemical synthesis and catalytic properties

Iron–nickel spinel oxide NiFe₂O₄ nanoparticles have been prepared by the combination of chemical precipitation and subsequent mechanical milling. For comparison, their analogue obtained by thermal synthesis is also studied. Phase composition and structural properties of iron–nickel oxides are investigated by X-ray diffraction and Mössbauer spectroscopy. Their catalytic behavior in methanol decomposition to CO and methane is tested. An influence of the preparation method on the reduction and catalytic properties of iron–nickel samples is established.     

Three-dimensional structure of the calcite-water interface by surface X-ray scattering

The three-dimensional structure of the calcite (104)-water interface has been determined with surface X-ray scattering. Nine crystal truncation rods (including specular and non-specular rods) were measured providing both vertical and lateral sensitivity to the interfacial structure. The results reveal that calcite is nearly ideally terminated with a single surface hydration layer that includes two inequivalent water molecules having distinct heights of 2.3 ± 0.1 and 3.5 ± 0.2 Å, each with a well-defined lateral registry with respect to the calcite surface. No additional layering of water is observed beyond this surface hydration layer. Small displacements in the outer two calcium carbonate layers were also observed. These results are compared with previous experimental and computational results.     

Shape-controlled synthesis of nanocrystalline titania at low temperature

The interesting shape (shuttle-like, sphere with needles, uniform particles) rutile titania were prepared by the hydrolysis of TiCl₄ in high acidic aqueous solution in the absence or presence of PEG-1000. PEG-1000 acted as dispersant, which could control the shape and size of the precipitate of titania. As a result, shuttle-like nanocrystalline appeared and the aggregation was improved with the increase of the amount of acid and the decrease of the concentration of TiCl₄ in the absence of PEG-1000. Uniform nanoparticles were obtained in the presence of PEG-1000 and the diameter of the particles decreased with increasing the amount of PEG-1000. This process simplification will lower production cost and make continuous process possible. The products were analyzed using X-ray diffractometer, transmission electron microscopy.     

MOCVD生长的GaN单晶膜透射光谱研究

采用MOCVD技术在Al2O3(0001)衬底上生长了GaN薄膜，使用透射光谱、光致发光光谱和X射线双晶衍射三种技术测试了五类GaN薄膜样品，实验结果表明：GaN薄膜透射谱反映出的GaN质量与X射线双晶衍射测量的结果一致，即透射率越大，半高宽越小，结晶质量越好；而X射线双晶衍射峰半高宽最小的样品，其PL谱的带边峰却很弱，这说明PL谱反映样品的光学性能与X射线双晶衍射获得的结晶质量不存在简单的对应关系，同时还报导了一种特殊工艺生长的高阻GaN样品的RBS／沟道结果。     

Quantitative methods for nanopowders characterization

The size, shape and surface topology have a strong influence on powders properties, such as: mechanical, optical, catalytic, etc. In addition, when particles have a nanometer size, the dispersion of these features plays an important role.There are a number of techniques, which could be used in order to characterize powders in terms of particle size and shape. However, due to the scale of analysis, well beyond the wavelength of visible light, most of them cannot be applied for investigations of nanopowders.In this paper, transmission electron microscopy (TEM) image analysis and X-ray methods are presented as promising and complementary techniques. An example of their application to ZrO₂ nanopowder is shown. The advantages and limitations of each method are described.     

Nd掺杂的Bi4Ti3O12变温X射线衍射分析

利用变温X射线衍射技术，在预烧过程中分析了Nd掺杂Bi4Ti3O12后生成Bi3.15Nd0.85Ti3O12（BNT）相的形成过程以及微结构的变化．实验观察到以30℃／min的升温速率，BNT相在700℃时开始形成，其衍射峰强度随温度的继续升高而增强，衍射峰半高宽随烧结时间延长而减小．X射线衍射分析结果表明，在900℃恒温条件下，烧结约2h，可形成单一的BNT相．     

Electrocatalytic activity of ordered intermetallic PtSb for methanol electro-oxidation

Ordered intermetallic PtSb had been synthesized by arc-melted and then sintering treatment. The electro-oxidation of liquid methanol on PtSb was investigated at room temperature by cyclic voltammetry and chronoamperometry. The results are compared to those at a polycrystalline platinum electrode surface. It was found that PtSb intermetallic was catalytically more active than pure platinum according to the onset potential and current density. X-ray diffraction (XRD) and XPS technologies had been used to investigate the crystal structure and electron effect.