发展中的我国中学物理"四个类型实验"

分析总结了半个世纪来我国中学物理教学“4个类型实验”的历史、内涵、功能和教法。     

提高大学物理实验教学质量的措施与设想

本提出了提高大学物理实验教学质量的一些措施与设想。并加以简要论述。     

数码相机引入科技照像实验

介绍了数码相机的系统结构和工作原理，通过与传统相机的对比分析，在科技照相实验中应该使用数码相机。     

LED汽车前大灯散热器正交优化设计与分析

设计了一种LED汽车前大灯散热器结构,该结构主要由一条通风管和一台无叶风扇组成.在SolidWorks软件中建立该散热结构模型,并导入FloEFD软件进行散热仿真,得到LED结温温度为148℃.提出在通风管中填充矩形翅片和填充蜂窝结构两种改进方案.仿真结果表明,采用两种改进方案后LED汽车前大灯的结温温度分别下降至102.01℃和86.20℃.对填充蜂窝结构方案进行正交优化试验,分析得出影响该系统散热性能的因素依次为:蜂窝等效直径、蜂窝类型、填充长度、壁厚和通风管长度.按照该顺序优化参数值,得到最优散热结构.仿真结果表明,经过正交优化后,LED汽车前大灯的温度降为75.17℃,进一步提高了整体结构的散热性能.最后分析了该结构的基板温度与风速的关系,结果表明当风速低于5m/s时,温度随着风速的增大急剧降低,当风速高于5m/s时,温度下降趋势相对缓慢.     

A review of research progress in air-to-water sound transmission

International and domestic research progress in theory and experiment and applications of the air-to-water sound transmission are presented in this paper. Four classical numerical methods of calculating the underwater sound field generated by an airborne source, i.e., the ray theory, the wave solution, the normal-mode theory and the wavenumber integration approach, are introduced. Effects of two special conditions, i.e., the moving airborne source or medium and the rough air-water interface, on the air-to-water sound transmission are reviewed. In experimental studies, the depth and range distributions of the underwater sound field created by different kinds of airborne sources in near-field and far-field, the longitudinal horizontal correlation of underwater sound field and application methods for inverse problems are reviewed.     

Heat Transfer Evaluation Method in Complex Rotating Environments Employing IR Thermography and CFD

This article presents a measuring method for determination of convective heat transfer in rotating environments. The method is used to obtain temperature and Nusselt number distributions on optically accessible objects inside real operating environments, without the need for implementation of complex surface heat flux measurements. Temperature maps of the observed surfaces are acquired non-intrusively by infrared (IR) thermography, whereas heat flux data is computed numerically by computational fluid dynamics (CFD) tools. The method was employed on a rotating hollow blade, heated internally by secondary air flow. Experimental and numerical results for the observed blade side are compared in terms of surface temperature 2D distributions. Temperature distributions are further statistically evaluated and show good agreement, which is the basic precondition for combining experimental and numerical data by the method. Results are presented in terms of combined experimental-numerical Nusselt number shown as two-dimensional distribution on the blade pressure side.     

教学与科学研究交融的物理实验创新设计

以应用复合型人才为培养目标,以教学与科学研究交融的育人观为指导,通过科研内容提取移植、由企业生产和日常生活实际提升、由已有教学研究成果固化等多种渠道,在较高层次物理实验课程与实践教学中创新设计出一批物理与社会应用、物理与海洋、物理与生物、物理与环境等多学科交叉的具有海洋特色的实验项目,使实验教学内容与科研、工程、社会应用实践密切联系。通过这样的实验项目开设,培养学生学习兴趣,提高学生学习能力、实践应用能力、研究创新能力。     

On the scale-to-scale coupling between a full-scale wind turbine and turbulence

The scale-dependent response of an instrumented full-scale wind turbine is studied under neutrally stratified conditions. The analysis is focused on the linkage between the incoming flow, turbine power output and foundation strain. Wind speed, measured from sonic anemometers installed on a meteorological tower, and foundation strain were sampled at 20 Hz, while the turbine power was sampled at 1 Hz. A wavelet framework and structure function are used to obtain cross correlations among flow turbulence, turbine power and strain across scales as well as to quantify intermittent signatures in both flow and turbine quantities. Results indicate that correlation between the streamwise velocity component of the wind flow and turbine power is maximised across all scales larger than the rotor radius for wind measured at the turbine hub height. The characteristic time lag associated with maximum correlation is shown to be consistent with the Taylor’s hypothesis for turbulent scales smaller than the separation between the meteorological tower and the turbine. However, it decreases with increasing scale size and diminishes to zero at scales on the order of the boundary layer thickness. Turbine power and strain fluctuations exhibited practically the same behaviour at scales larger than two rotor diameters. At those scales, the cross correlation between these quantities resulted ～0.99 and remains still over 0.9 at the scale of rotor radius. Below this scale, the correlation decreases logarithmically with scale. The strong linkage between power and strain for all the relevant scales would eventually allow the analysis of dynamic forcing on the foundation based on the power output. Intermittency on the flow is shown to be transferred and amplified by the turbine, leading to highly intermittent power output.     

Terahertz planar antennas for future wireless communication: A technical review

With the monotonic increasing demand of the higher bandwidth for the next generation wireless communication system, the extension of the operating frequency of the communication system to the millimeter/Terahertz wave regime of the electromagnetic spectrum where several low-attenuation windows exist is inevitable. However, before the commercial implementation of the wireless communication in these low-attenuation windows, there are various obstacles which need to be addressed by the scientists and researchers. The atmospheric path loss is the main obstacle to the full-fledged implementation of the terahertz wireless communication. The remedy to this problem is the use of high-power sources, efficient detectors and high gain antenna systems. This paper reviews these technical issues with the special attention to the planar antennas which might contribute to the compact, inexpensive, and low profile future terahertz wireless communication system design.     

GC-MS测定血清胆固醇及其标志物前处理条件正交试验优化研究

采用正交试验优化GC-MS测定血清胆固醇及其标志物的样品前处理条件,并对最优试验方案进行方法学评价。采用L₁₆(211)正交设计对影响GC-MS测定血清胆固醇及其标志物前处理的3个关键步骤共7个因素——皂化(KOH-乙醇浓度、皂化温度和时间)、萃取(正己烷用量)和衍生化(衍生化温度、时间和用量)进行优化。得到最优前处理条件组合如下：KOH-乙醇溶液浓度为1 mol·L-1;皂化温度70 ℃;皂化时间60 min;萃取剂用量2 mL;衍生化温度70 ℃;衍生化时间60 min;衍生化试剂用量100 μL。所建方法准确性和精密性良好,方法学评价指标优于文献报道。