Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Nanostructure characterization of high k materials by spectroscopic ellipsometry

In this work, the optical and structural properties of high k materials such as tantalum oxide and titanium oxide were studied by spectroscopic ellipsometry, where a Tauc-Lorentz dispersion model based in one (amorphous films) or two oscillators (microcrystalline films) was used. The samples were deposited at room temperature by radio frequency magnetron sputtering and then annealed at temperatures from 100 to 500 °C. Concerning the tantalum oxide films, the increase of the annealing temperature, up to 500 °C does not change the amorphous nature of the films, increasing, however, their density. The same does not happen with the titanium oxide films that are microcrystalline, even when deposited at room temperature. Data concerning the use of a four-layer model based on one and two Tauc-Lorentz dispersions is also discussed, emphasizing its use for the detection of an amorphous incubation layer, normally present on microcrystalline films grown by sputtering.     

Electronic structure of Ti metal and TiO2 powder studied by hard and soft (Cu Kα1 and Al Kα1) X-ray photoelectron and Auger spectroscopy

High-energy X-ray photoelectron spectroscopy (XPS) is of particular importance for minimizing the effects of surface contamination by increasing photoelectron escape depths. In this study high-resolution high-energy Cu Kα₁ and soft Al Kα₁ XPS and Auger electron spectroscopy were used to compare the electronic structure of Ti in TiO₂ powder and Ti metal. The Ti 1s in TiO₂ XPS line is narrower and more symmetric than in Ti metal. A comparison of the relative intensities of the L₂₃M₂₃M₄₅ and L₂₃M₂₃M₂₃ Auger transitions in Ti metal and TiO₂ is consistent with the expected transfer of Ti 3d electrons away from the Ti site in the oxide. The satellites accompanying the Ti 1s XPS line excited by Cu Kα₁ X-rays occur at the same energies as the satellites accompanying the Ti 2s and 2p XPS lines excited by Al Kα₁ X-rays indicating that they do not depend on the core-level, the experimental resolution or inelastic scattering processes.     

养殖池塘沉积物的重金属分布及污染特征

浙江省淅西北地区淡水养殖池塘沉积物重金属调查研究表明，养殖池塘沉积物中7种重金属元素分布不均衡，差异也较大，除Hg和Cr元素外，其余重金属元素已大大超过土壤本底值．虽然其实测含量都未超出国家规定的标准值范围，但沉积物中重金属元素对养殖水环境、养殖品种存在的潜在污染与危害值得关注．污染指数评价显示，养殖池塘沉积物中主要污染物质为Cu和Cr，而Hg、Pb污染程度相对较轻．     

基于Internet/Intranet的大学物理实验系统

利用计算机技术、传感技术和校园网，将现代教育技术引入大学普通物理实验教学中，实现实验数据的自动采集，基于网络的实验预习和实验报告写作、递交、批改及管理等功能．     

An effect of application of chiral aluminium alkoxides and amides as adducts to zirconium catalyzed carbo- and cycloalumination of olefins

This paper is dedicated to a study of properties of the following novel optically active organoaluminium compounds (OACs): (1S,2S)-l,7,7-trimethyl-2-[(dialkylalumina)oxy]-bicyclo[2.2.1]heptanes and (1S)-N-(dialkylalumina)-6,7-dimethoxy-1-methyl-1,2,3,4- tetrahydroisoquinolines. The synthesis of the chiral OACs was carried out in the reaction of either natural camphor or salsolidine with both AlEt₃ and i-Bu₂AlH. The main goal of the research was to investigate the stereodifferentiating activity of the chiral OACs in the olefin carbo- and cycloalumination reactions, catalyzed by Cp₂ZrCl₂.     

用迈克耳逊干涉仪测量气体折射率的误差的研究

研究在用迈克尔逊干涉仪测量气体折射率时存在的系统和方法误差，提出了误差修正方法。     

On the role of the interface charge in non-ideal metal–semiconductor contacts

The bias dependent interface charge is considered as the origin of the observed non-ideality in current–voltage and capacitance–voltage characteristics. Using the simplified model for the interface electronic structure based on defects interacting with the continuum of interface states, the microscopic origin of empirical parameters describing the bias dependent interface charge function is investigated. The results show that in non-ideal metal–semiconductor contacts the interface charge function depends on the interface disorder parameter, density of defects, barrier pinning parameter and the effective gap center. The theoretical predictions are tested against several sets of published experimental data on bias dependent ideality factor and excess capacitance in various metal–semicoductor systems.     

Catalytic Hydrosilylation of Furan, Thiophene, and Pyridine Aldimines

The addition of hydrosilanes (HSiEt₃, HSiMe₂Ph, H₂SiPh₂) to the CH=N bond of heterocyclic azomethines has been studied in the presence of monovalent complexes of rhodium and palladium. The effect on the reaction of the CF₃ group of the aldimines, which were obtained from O-, S-, and N-heteroaromatic aldehydes and 2-trifluoromethylaniline, has been clarified, as were other regularities of the processes being studied. A series of corresponding furans, thiophenes, and pyridine amines has been synthesized.     

遥感器CCD驱动器热设计及其在摄像过程中的温度变化

CCD驱动器是航天成像遥感器摄像过程中的主要热源之一。防止CCD驱动器过热是保证其正常工作的重要方面。介绍了遥感器的工作模式和对CCD驱动器采取的热控制措施。通过热平衡试验,利用回归的方法,对CCD驱动器在摄像过程中的温度变化规律进行了分析,同时对热控制效果进行了评估。CCD驱动器工作时升温速率在0.85℃/min左右,整个摄像过程中最高温度约为26℃,所实施的热控制措施效果理想。