Pressure–Volume–Temperature properties of polyolefin liquids and their melt miscibility

The pressure–volume–temperature (P–V–T) properties of a number of metallocene-produced polyolefins were measured experimentally at 10 MPa ≤ P ≤ 200 MPa and 30°C ≤ T ≤ 220°C in a dilatometer-type P–V–T apparatus. These included ethylene copolymers typical of linear low density polyethylene, with several α-olefins as comonomers and a wide range of comonomer content. The experimental P–V–T data were correlated with the equations of state from the Sanchez–Lacombe and Flory–Orwoll–Vrij theories. The solubility parameter map of the polyolefins, at atmospheric pressure, was established on the basis of the thermodynamic data. As the temperature increases, the solubility parameter of the polyolefin decreases. The solubility parameters of copolymers of ethylene with propylene, butene, hexene, and octene under constant temperature are all more or less the same at equal weight percent of comonomer. As the incorporation of branches increases, the solubility parameter decreases. The melt miscibility of the polyolefin blends can be predicted to design various blend products for specific applications from this solubility parameter map. © 1999 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 37: 2835–2844, 1999     

Deposition behavior in a low‐temperature cascade arc torch (CAT) polymerization process

Two kinds of hydrocarbon type monomers and three kinds of organosilicons were polymerized by a low‐temperature cascade arc argon plasma torch. Their deposition behaviors were studied as a function of experimental parameters and monomer elemental compositions. It was found that the normalized deposition rate (DR), expressed as deposition yield of DR/(FM)_m, was determined by a composite operational parameter, W*(FM)_c/(FM)_m, where W is the power input, and (FM)_c and (FM)_m are the mass flow rates of carrier gases and monomers, respectively. Experimental results indicated that the deposition yield is highly dependent on the elementary compositions of monomers. Optical emission spectroscopy study on the argon plasma torch showed that the emission intensity of excited argon neutrals was proportional to the value of the parameter W*(FM)_c. These results further certified that excited argon neutrals are the main energy carriers from the cascade arc column to activate monomers in the argon plasma torch. © 1999 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 37: 967–982, 1999     

中国不同变质程度煤制备水煤浆的性质研究

在相同的制浆条件下,以中国煤种资源数据库为依据,考察了24种不同地区、不同变质程度煤制备成水煤浆的成浆性、流变性及静态稳定性。结果表明,山西阳泉、山东淄博石谷、河北下花园等煤种适宜制浆,这些煤的浆体质量分数均可达到66%以上,浆体呈假塑性流体,且煤浆产生软沉淀的静态稳定性均在15 d以上;山西潞安石圪节、安徽淮南、淮北石台等煤成浆性较好,稳定性在7 d左右,浆体呈胀塑性流体;山东枣庄八一、甘肃靖远红会、河南鹤壁等煤可达到较高的煤浆质量分数,浆体流变性及稳定性均较差,其他的煤则不适宜用于制备水煤浆。     

M-ary information processing via an optimal nonlinear detector

This paper presents a novel approach of M-ary baseband pulse amplitude modulated signal processing via a parameter-optimized nonlinear dynamic system.This nonlinear system usually shows the phenomenon of stochastic resonance by adding noise.To thoroughly discuss the signal processing performance of the nonlinear system,we tune the system parameters to obtain a nonlinear detector with optimal performance.For characterizing the output of the nonlinear system,the derivation of the probability of detection error is given by the system response speed and the probability density function of the nonlinear system output.By varying the noise intensity with fixed system parameters,the phenomenon of stochastic resonance is shown and by tuning the system parameters with fixed noise,the probability of detection error is minimized and the nonlinear system is optimized.The detection performance of the two cases is compared with the theoretical probability of detection error,which is validated by numerical simulation.     

添加硼砂助熔剂煤灰熔融性的量子化学与实验研究

将硼砂按不同比例分别掺入四种高灰熔点煤灰中,对混合灰样熔融特性进行实验研究。 采用密度泛函理论对熔融过程中作为反应物的莫来石反应活性进行计算。莫来石属于正交晶系Pbam空间群。计算结果表明,莫来石很容易与电子接受体结合,不容易与电子给予体结合。当莫来石与电子给予体结合时,Si原子的活性高于Al。因此,向莫来石中加入助熔剂硼砂时,硼砂中的Na＋作为电子接受体,非常容易进入莫来石的晶格中,促使莫来石转变为霞石,降低了灰熔融温度。在还原性气氛下,煤灰熔融特性实验证实了理论计算结果。     

icMRCI+Q理论研究CF离子12个-S态和23个?态的光谱性质

采用考虑Davidson修正的内收缩多参考组态相互作用(icMRCI+Q)方法结合相关一致基组aug-ccpV5Z和aug-cc-pV6Z计算了CF~+离子第一离解极限C~+(~2p_u)+F(~2P_u)对应的12个∧-S态(X~l∑~+,a~3∏,1~3∑~+,1~3Δ,1~1∑~-,1~1∑~-,1~3∑~-,2~1∑~+,1~1∏,2~3∏,2~1∏和2~3∑~+)所产生的23个Ω态的势能曲线.计算中考虑了旋轨耦合效应、核价相关和标量相对论修正以及将参考能和相关能分别外推至完全基组极限.基于得到的势能曲线,获得了束缚和准束缚的9个∧-S态和16个Ω态的光谱常数,并且X~1∑~+,a~3∏~(势阱一)∧-S态的光谱常数与已有的实验结果非常符合.此外,计算了CF自由基X~2∏态到CF~+离子束缚和准束缚的9个∧-S态的垂直电离势和绝热电离势,并且CF~+(X~1∑~+)←CF(X~2∏)和CF~+(a~3∏(势阱一))←CF(X~2∏)的垂直电离势和绝热电离势与相应的实验结果也非常符合.由a~3∏,1~1∏态和其他激发∧-S态势能曲线的交叉现象,借助于计算的旋轨耦合矩阵元,分析了a~3∏~(势阱一),1~1∏~(势阱一)和2~1∑~+态的预解离机理.计算的23个Ω态离解极限处的相对能量与实验结果十分吻合.最后计算了(2)0+~(势阱一)(v'=0-5),(1)1~(势阱一)(v'=0-5)和(2)1~(势阱一)(v'=0)到X0~+态跃迁的Franck-Condon因子和辐射寿命.     

用Hough变换的方法提取图像拐点

拐点特征是模式识别中经常用到的一类不变量．本文利用Ｈｏｕｇｈ变换找出图像轮廓中的直线段，确定其直线方程，将相邻两直线段延长相交得到的交点定义为拐点．由于Ｈｏｕｇｈ变换是统计平均的结果，所以求得的拐点较为稳固，抗噪声性能较好．文中也给出了拐点的具体算法．     

高频地波雷达波形参数设计

根据线性调频中断连续波（FMICW）雷达原理,针对高频地波雷达探测海洋表面动力学要素的要求,给出了雷达信号数据采集与处理过程;分析了被压地波脉冲中断的雷达回波信号可以进行连续采样的原理;设计了无距离混迭和Doppler频率混迭的OSMAR2000雷达工作参数。该雷达主要技术指标为：距离分辨率2.5km,最大探测距离270km,时间分辨率13min,雷达工作比0.44,测量分辨率2－3cm/s。现场实验表明,雷达波形参数设计是正确的。