Continuous chromatographic separation process: simulated moving bed allowing simultaneous withdrawal of three fractions

Continuous counter-current chromatographic separation has been carried out in a simulated moving bed system (SMB). We have worked with a SMB pilot plant (8 columns, 4.4 litres of resin each) which allows the continuous withdrawal of two different fractions. A mixture of glucose-fructose has been separated. To calculate the concentration profile within the separator an axial dispersed plug flow model and an equilibrium stage model have been employed; software has been created to simulate the behaviour of the separator. The necessary parameters of the mode: the adsorption equilibrium constant, the height equivalent to a theoretical plate and the bed voidage, have been acquired experimentally from elution chromatography measurements. The results calculated by simulation give a good representation of the experimental concentration profiles; other separations like xylitol-arabitol have been simulated. The influence of some factors like desorbent flow-rate, feed flow-rate and the bed voidage have been studied using the software. Once the system has worked in a two withdrawal way, an extension of the pilot plant has been constructed so as to obtain a third one. The necessary parameters of the three withdrawal model will be studied.     

气-固流化床反应器内双流体力学模型及其验证 Ⅱ.单组分两维射流床内流场特性分析

由以质量、动量和能量三大守恒定律为基础的湍流两相流理论出发,建立了描述气固流化床内两相流动的数学模型;在微型计算机上编写了相应的数值计算和图形处理程序;为了验证模型的可靠性,本文着手模拟与分析了单组分颗粒体系两维射流流化床内气、固相速度场、空隙度和压力场随时间、空间变化规律;得到了与前人实验结果相吻合的结论。     

大型射流流化床气化炉的数学模拟Ⅰ.模型的建立

本文是在充分考虑了流动特性、质量平衡、能量平衡和动量平衡以后，建立了一个基于大型射流流化床气化炉（直径大于１米）的模型。通过与实验结果比较、证明该模型可用于大型气化炉的模拟工作。     

Synthesis and activity measurement of some water-gas shift reaction catalysts

The effect of calcination temperature on the activity and some properties of low temperature water gas shift reaction catalysts has been investigated. The activities of catalysts have been determined using a fixed bed catalytic reactor. The following results may be deduced from the present study. 1. The catalysts' total surface area decreased with increasing calcination temperature, presumably due to the partial sintering of the catalysts particles. 2. The presence of an amorphous CuO phase within the structure of some catalysts may be related to the desirable conditions prevailing during synthesis of the latter. 3. Observation of a similar trend between the increase in copper crystallite particle size and enhancement of catalyst activities with increasing calcination temperature demonstrates the important contribution made by the copper crystallite phase to the overall activities of water gas shift reaction catalysts. This revised version was published online in June 2006 with corrections to the Cover Date.     

生物质在流化床中的空气-水蒸气气化研究

以流化床为反应器，对生物质的空气-水蒸气气化特性进行了研究。考察了一些主要参变量，如温度 (700 ℃～900 ℃)、水蒸气/生物质比(0～4.04)、空气当量比(0.19～0.27)以及生物质粒度(0.2 mm～0.9 mm)等对气化结果的影响。在实验研究的条件范围内，生物质产气率在1.43 m3/kg～2.57 m3/kg范围内变化，产气的低热值在6 741 kJ/m3～9 143 kJ/m3范围内变化。实验结果表明：较高的气化温度有利于氢的产生；但气化温度过高会使气体热值下降；与常规的空气气化相比，水蒸气的加入使生物质气化产气率显著提高，但水蒸气加入量过多使气化温度下降，产气率和产气热值降低；生物质颗粒粒度的大小对产气组分的分布和产气率均有影响，较小颗粒的生物质会产生较多的CH4、CO和较少的CO2。     

悬浮床加氢裂化水溶性催化剂的筛选与表征

催化加氢作用, 当金属组分A和组分B浓度分别为 15 μg/g ～ 25 μg/g 和 1100 μg/g～1300 μg/g时催化剂具有较好的催化加氢活性。两元水溶性催化剂硫化后的XPS、XRD和TEM分析结果表明：活性组分经硫化反应后生成了金属硫化物,但组分A硫化率不足50％;组分B易硫化结晶,其晶粒成为组分A的硫化物晶粒或颗粒分散的“载体”,使组分A的硫化物具有较高的分散度,提高了催化剂的加氢活性;A-B双金属水溶性催化剂经硫化反应后所形成的颗粒尺寸在100 nm左右,说明两元金属催化剂在硫化结晶过程中确实存在相互分散和抑制晶粒增长的作用。     

CATALYTIC WET PEROXIDE OXIDATION OF HYDROQUINONE WITH Co（II）/ACTIVE CARBON CATALYST LOADED IN STATIC BED

Catalysts based on Co（II） supported on active carbon were prepared and loaded in static bed. The hydroquinone would be degraded completely after treated by Catalytic wet peroxide oxidation method with Co（II）/active carbon catalyst. After activate treatment, the active carbon was immerged in cobaltous nitrate solution, then put into a drying oven, Co（II） could be loaded on the micro-surface of carbon. Taking the static bed as the equipment, the absorption of active carbon and catalysis of Co（II） was used to reduce activation energy of hydroquinone. Thus hydroquinone could be drastically degraded and the effluent can be drained under the standard. Referring to Fenton reaction mechanism, experiment had been done to study the heterogeneous catalyzed oxidation mechanism of Co（II）. The degradation rate of hydroquinone effluent could be achieved to 92% when treated in four columns at H2O2 concentration 10%, reaction temperature 40 ℃, pH 5 and reaction time 2.5h.     

C302铜基催化剂上甲醇合成的动力学研究 Ⅱ.动力学模型的工业检验

以Ｌｕｒｇｉ型甲醇合成反应器一维非均相数学模型和单颗粒催化剂反应－扩散模型为基础,通过模拟分析及与工业生产数据相对照的方式,对六种具有不同结构的Ｃ３０２催化剂动力学模型进行了工业应用检验,将六种模型用于非等温工业反应器性能分析时,有的模型模拟结果偏离实际情况较远,表明动力学模型结构对反应器模拟结果有较大的影响,有必要对用等温动力学实验数据和方法确立的动力学模型从工业应用角度做进一步检验。基于这一观点,最终确定了三种比较适宜于工业应用的Ｃ３０２催化剂的动力学模型。     

生产银杏黄酮的模拟移动床色谱工艺

世界各国银杏黄酮类药品的标度为总黄酮含量24％,生产工艺主要是浸取。现在国内有厂家提出制备高纯度银杏黄酮产品——总黄酮含量44％,生产工艺主要包括浸取和提纯两步,提纯主要采用树脂柱层析法。本文用模拟移动床色谱(Sinulated Moving Bed Chromatography,简称SMBC)提纯生产工艺,所得黄酮纯度可达90％以上。