光学薄膜在现代汽车工业中的应用

本文论述应用光学薄膜技术对汽车窗口玻璃和塑料的若干性能进行改进的技术发展水平，这些性能包括塑料表面的硬化，红外区的反射，紫外区的吸收，偏振化作用，双折射，憎水性以及光学角度选择性等，评论等离子体处理和物理蒸汽淀积薄膜工艺近来应用的一些例子。对于物理蒸汽淀积薄膜所提供的异常功能连同实际使用中它们的耐久性作了特殊的强调。     

斜孔气膜冷却数值模拟分析

本文通过数值模拟分析圆柱孔和扩散孔的单斜孔气膜冷却特性,考察复合角、孔型和吹风比对流场和气膜冷却效果的影响。结果表明,复合角的引入使气膜侧向分布更宽,但冷却效果沿主流方向衰减更快。适中吹风比得到的气膜能更有效的保护壁面。在相同吹风比和复合角条件下,扩散孔的气膜冷却效率比圆柱孔更好,且冷却更为均匀持久。     

Influence of silicon on the microstructure and mechanical properties of Zr-Si-N composite films

A series of Zr-Si-N composite films with different Si contents were synthesized in an Ar and N₂ mixture atmosphere by the bi-target reactive magnetron sputtering method. These films’ composition, microstructure and mechanical properties were characterized by energy dispersive spectroscopy, X-ray diffraction, scanning electron microscopy, atomic force microscopy and nanoindentation. Experimental results revealed that after the addition of silicon, Si₃N₄ interfacial phase formed on the surface of ZrN grains and prevented them from growing up. Zr-Si-N composite films were strengthened at low Si content with the hardness and elastic modulus reaching their maximum values of 29.8 and 352 GPa at 6.2 at% Si, respectively. With a further increase of Si content, the crystalline Zr-Si-N films gradually transformed into amorphous, accompanied with a remarkable fall of films’ mechanical properties. This limited enhancement of mechanical properties in the Zr-Si-N films may be due to the low wettability of Si₃N₄ on the surface of ZrN grains.     

离化团簇束法制备c轴取向的ZnO薄膜

为了探索低温可调控ZnO薄膜沉积技术,提出了一种新的ZnO薄膜制备方法,即离化团簇束（ICB）法,并自行设计研制了应用该方法制备ZnO薄膜的专门装置.采用超音速喷嘴获得高速锌原子团簇束,用Hall等离子体源产生氧离子束离化锌原子团簇,获得了较高的离化率.在沉积过程中,可以通过调节衬底偏压、氩氧比、衬底加热温度等参数,来控制成膜的质量;应用这个装置成功地在硅衬底上制备的ZnO薄膜,经XRD和EDS检测,薄膜的c轴取向一致,Zn、O原子百分比接近于1：1,成膜质量好.     

Phosphonate electrochemical recognition by molecularly imprinted deposited film

In this paper, thin films of titanium oxide imprinted with O,O-dimethyl-(2,4-dichlorophenoxyacetoxyl)(3′-nitrobenyl) methinephosphonate (Phi-NO₂) were prepared via liquid phase deposition (LPD) method on a glassy carbon electrode. The imprinted molecular in the films was removed by treatment with immersion in CH₂Cl₂. X-ray diffraction (XRD) and electrochemical methods were introduced to show the evidence of the molecular imprinting phenomenon. It was also found that the recognition ability of the sensor depended on the substituents associated with tridimensional structures of the nitro-compounds. Under the optimized condition, the sensor showed better sensitivity, selectivity and reproducibility to the imprinted molecule and the linear relationship between the current and the concentration of analyte in the range of 0.1-50 μM was obtained. LPD proved to be a powerful method for imprinting titanium oxide thin sense films.     

An Extension Landau-Lifshitz Model in Studying Soft Ferromagnetic Films

In this paper, we propose a model in studying soft ferromagnetic films, which is readily accessible experimentally. By using penalty approximation and compensated compactness, we prove that the dynamical equation in thin film has a local weak solution. Moreover, the corresponding linear equation is also dealt with in great detail.     

500.8 nmNd∶YAG青光激光器光学薄膜的设计与制备

从双波长激光运转及和频的机理出发，对LD泵浦Nd∶YAG，LBO腔内和频500.8 nm〖JP2〗青光激光器所使用的光学薄膜进行了设计和制备.在激光反射镜的设计上，为了达到最佳的和频输出，对膜系要求进行了深入分析.采用对谐振腔一端面反射率固定不变并通过对另一腔镜基频光的透射率进行调谐的方法, 在给出合理初始结构后，利用计算机对膜厚进行了优化.并采用双离子束溅射沉积的方法，通过时间监控膜厚法成功制备出青光激光器所使用的全介质激光反射膜, 在室温下实现946 nm和1064 nm双波长连续运转，并通过Ⅰ类临界相位匹配LBO晶体腔内和频在国内首次实现500.8 nm青色激光连续输出.当泵浦注入功率为1.4 W时和频青光最大输出达20 mW.     

p型未掺杂富锌ZnO薄膜的形成和性能研究

以高纯ZnO为靶材,氩气为溅射气体,利用射频磁控溅射技术在石英衬底上生长出纤锌矿结构的富锌ZnO薄膜.薄膜沿(002)择优取向生长,厚约为1.2μm,呈现电绝缘特性.将溅射的ZnO薄膜在10-3Pa,510~1 000 K的温度范围等温退火1 h,室温Hall测量结果表明ZnO薄膜的导电性能经历了由绝缘—n型—p型—n型半导体的变化.XPS测试表明ZnO薄膜的Zn/O离子比随退火温度的升高而降低,但一直是富锌ZnO,说明未掺杂的富锌ZnO也可以形成p型导电.p型未掺杂富锌ZnO薄膜的形成可归因于VZn受主浓度可以克服VO和Zni本征施主的补偿效应.     

磁控溅射ZnO薄膜的成核机制及表面形貌演化动力学研究

利用原子力显微镜分析了ZnO薄膜在具有本征氧化层的Si(100)和Si(111)基片上的表面形貌 随沉积时间的演化. 通过对薄膜生长形貌的动力学标度表征，研究了射频反应磁控溅射条件 下，ZnO薄膜的成核过程及生长动力学行为. 研究发现，ZnO在基片表面的成核过程可分为初 期成核阶段、低速率成核阶段和二次成核阶段. 对于Si(100)基片，三个成核阶段的生长指 数分别为β₁=1.04，β₂=0.25±0.01，β₃=0.74；对 于Si(11 关键词： ZnO薄膜 磁控溅射 生长动力学 成核机制     

脉冲磁场处理对碳纳米管掺杂MgB2线材临界电流密度的影响

对碳纳米管(CNT)掺杂MgB₂超导体磁场处理后的行为进行了研究. 结果表明，CNT掺杂MgB₂超导体经5T脉冲磁场处理后临界电流密度J_c(H)在低磁场下提高了2—3倍，高场下提高一个数量级以上，扫描电镜结果显示CNT沿着处理磁场方向规则排列并且成为MgB₂基体的形核中心和高效的磁通钉扎中心. 关键词： 2')" href="#">MgB₂ 碳纳米管 脉冲磁场处理