Indirect Methods For Determination of The Protective Effects of Coating Films on The Surface of Crystals

The extents of the protective effects of coating films on the surface of crystals were determined. Three different samples were made with different quantities of coating fluid (Sepifilm LP 010 in 10% aqueous solution). Since the atomizing rate was constant, the coating time increased in parallel with the volume of coating fluid applied. The direct measurement of film thickness and smoothness is very difficult, and therefore indirect methods were used. Dimenhydrinate was chosen as model drug; this is a heat-sensitive antihistamine with a low melting point. This temperature can be reached during the tableting process. The behaviour of samples on exposure to heat was examined by differential scanning calorimetry. The water uptakes of the samples were determined with an Enslin apparatus. Plasticity was studied with an instrumented tablet machine. These indirect methods (thermal conductivity, water uptake and plasticity measurements) revealed connections between the results of the various experiments. An overlong coating time decreased the protective effect of the coating film. This revised version was published online in August 2006 with corrections to the Cover Date.     

生长温度对碳纳米管阴极场发射性能的影响

碳纳米管(Carbon Nanotubes,CNTs)场发射平面显示器(Field Emission Display,FED)与其他显示器比较显示了其独特优点,被认为是未来理想的平面显示器之一。碳纳米管阴极作为器件的核心部分,其性能的好坏直接影响显示器的性能。针对30~60英寸(76.2~152.4cm)大屏幕显示器所用的厚膜工艺,即采用丝网印刷法制备了碳纳米管阴极阵列,研究了化学气相沉积法在不同温度下生长的CNTs的场发射电流-电压特性,找到了适合FED用碳纳米管的最佳生长温度。结果表明生长温度越高(750℃),CNTs场发射性能越好。并用荧光粉阳极测试这些CNTs的场发射发光显示效果,验证了上述结论。     

宽带膜厚实时监控过程中膜层折射率的确定方法

为了准确计算出镀膜过程中每层膜的折射率，介绍了实时监控过程中确定膜层折射率的2种方法：一种是由实测的透射比光谱直接反算出膜层的折射率；另一种是用最小二乘法的优化算法实时拟合折射率。试验结果表明：在线反算适合单点监控，所得折射率误差小于2%。然而在实际镀膜过程中,由于宽带内膜层参数误差较大,一般大于25%。为此，采用最小二乘法拟合，即在整个宽光谱范围内采集每个波长点的信息，所得结果误差很小，一般都在2％～5%之间,有时可达到10%,在很大程度上提高了实际镀膜时膜厚监控的精度。     

催化剂薄层内甲烷水蒸气重整反应强化管内对流换热的数值模拟

本文以竖直圆管内壁催化剂薄层内发生甲烷水蒸气重整反应强化对流换热作为研究对象,对其进行了数值模拟．结果发现,催化剂薄层内的吸热化学反应可以有效地强化对流换热,降低流体和壁面温度,从而对壁面起到保护作用;极限热流密度的大小与流体的入口温度有关,存在最佳入口温度使极限热流密度最大．     

两种方法制备ITO薄膜的红外特性分析

比较了用电束加热蒸发法和直流磁控溅射法制备的氧化锡铟(ITO)薄膜在红外波段的光学特性实验发现,通过直流磁控溅射在常温下制备的ITO薄膜在红外波段折射率稳定、消光系数小,比电子束加热蒸发制备的膜有较高的透过率在波长1550nm附近的透过率可达86%以上,消光系数约为004,方电阻最低为100Ω/□.     

相变光盘介电薄膜ZnS-SiO2 的微结构和光学特性

采用射频磁控溅射法制备了ZnS-SiO₂ 介电薄膜,利用透射电镜和椭偏仪研究了溅射条件对ZnS-SiO₂薄膜微结构和折射率n的影响.研究表明,ZnS-SiO₂薄膜中存在微小晶粒,大小为2～10 nm的ZnS颗粒分布在SiO₂基体中,当溅射功率和溅射气压变化时,ZnS-SiO₂薄膜的微结构和折射率n发生显著变化,微结构的变化是导致折射率n变化的主要原因,通过优化溅射条件可以制备适用于相变光盘的高质量ZnS-SiO₂介电薄膜.     

A study on the electrical conductivity of multi-walled carbon nanotube aqueous solution

The electrical conductivity was investigated for multi-walled carbon nanotubes (MWNTs) dissolved in chloroform and toluene, respectively. The electrical conductivity remarkably increased with increase in the content of MWNTs, which is in accordance with Archie's equation . Furthermore, a hypothesis of the electronic transport process was proposed to explain the difference between the solution and the solid compound. In addition, the temperature dependence of the electrical conductivity shows that log σ vs. 1/T exist in a good linear relationship. The activation energy of the electrical conductivity decreased with increase in concentration and an inflexion was observed at 60 °C in MWNT/toluene solution.     

Theoretical Study on the Reaction Mechanism between Dichlorocarbene and Armchair Single-walled Carbon Nanotubes

1 INTRODUCTION Carbon nanotubes have many potential applica- tions due to their unique structures and properties[1～4]. Physicists have been studying their electrical, me- chanical and other properties since their discove- ries[5, 6]. Recently, chemists are interested in carbon nanotubes because their properties can be altered by chemical functionalization[7～14], and these functiona- lized nanotubes can undergo further chemical trea- tment. So the potential application range of such na- …     

Non‐empirical calculations of NMR indirect carbon–carbon coupling constants. Part 4: Bicycloalkanes

A systematic study of the one‐bond and long‐range J(C,C), J(C,H) and J(H,H) in the series of nine bicycloalkanes was performed at the SOPPA level with special emphasis on the coupling transmission mechanisms at bridgeheads. Many unknown couplings were predicted with high reliability. Further refinement of SOPPA computational scheme adjusted for better performance was carried out using bicyclo[1.1.1]pentane as a benchmark to investigate the influence of geometry, basis set and electronic correlation. The calculations performed demonstrated that classical ab initio SOPPA applied with the locally dense Dunning's sets augmented with inner core s‐functions used for coupled carbons and Sauer's sets augmented with tight s‐functions used for coupled hydrogens performs perfectly well in reproducing experimental values of different types of coupling constants (the estimated reliability is ca 1–2 Hz) in relatively large organic molecules of up to 11 carbon atoms. Additive coupling increments were derived for J(C,C), J(C,H) and J(H,H) based on the calculated values of coupling constants within SOPPA in the model bicycloalkanes, in reasonably good agreement with the known values obtained earlier on pure empirical grounds. Most of the bridgehead couplings in all but one bicycloalkane appeared to be essentially additive within ca 2–3 Hz while bicyclo[1.1.1]pentane demonstrated dramatic non‐additivity of ?14.5 Hz for J(C,C), +16.6 Hz for J(H,H) and ?5.5 Hz for J(C,H), in line with previous findings. Non‐additivity effects in the latter compound established at the SOPPA level should be attributed to the through‐space non‐bonded interactions at bridgeheads due to the essential overlapping of the bridgehead rear lobes which provides an additional and effective non‐bonding coupling path for the bridgehead carbons and their protons in the bicyclopentane framework. Copyright © 2003 John Wiley & Sons, Ltd.     

Supercritical CO2 as a superior solvent for the cyclization of diallylmalonate catalyzed by palladium-containing zeolites

Palladium-containing zeolites catalyze the cycloisomerization of diethyl diallylmalonate to dimethylcyclopentenes. When the reaction is carried out in toluene, the performance of the palladium catalyst depends on the pore size of the zeolites. At 60 °C, palladium adsorbed on large pore size Beta zeolite (pore size ∼7.4 Å) is more active than medium pore size ZSM-5 (pore size ∼5.4 Å). This lower activity of ZSM-5 compared to Beta is attributable to the restricted diffusion of reagent and products through the ZSM-5 channels as compared to Beta zeolite. However, due to the gas-like diffusion characteristic of the supercritical state, the activity of ZSM-5 increases and becomes identical to that of Beta zeolite using supercritical CO₂ as medium.