无机胶体法制备Pt/C催化剂及其性能表征

采用无机胶体法制备用于质子交换膜燃料电池(PEMFC)的Pt/C催化剂。研究了影响PtO₂胶体生成和稳定性的因素(溶液的pH值、浓度和温度条件等)以及不同还原剂浓度对Pt/C催化剂性能的影响。透射电子显微镜测试结果表明，采用经优化的工艺条件所制备的Pt/C催化剂平均粒径为3 nm，且分散性好、粒度均匀。X-射线衍射分析表明，催化剂中Pt(111)晶面的相对含量较高，有利于加速氧还原反应。单体PEMFC的电压/电流密度曲线测试表明，所制备的Pt/C催化剂具有良好的电化学性能。     

NdOx作为助催化剂对PtRu/C电催化氧化甲醇活性的影响

采用沉积-还原法制备了PtRu-NdOx/C催化剂, 借助TEM、EDS和XRD等测试手段对其进行了微结构和组成的表征. 结果表明, 催化剂中Pt与Ru以合金形式存在, 而Nd的氧化物则以无定形形态存在. 催化剂粒子的平均粒径在2 nm左右, 晶胞参数为0.3896 nm, Nd氧化物的加入对PtRu合金的晶体结构影响不明显. 采用循环伏安法和计时电流法, 比较了PtRu-NdOx/C催化剂和PtRu /C催化剂对甲醇氧化的电催化活性, 结果表明, 加入Nd的氧化物作为助催化剂能明显提高PtRu /C催化剂对甲醇氧化的电催化性能.     

直接甲醇燃料电池阴极电催化剂的研究进展

直接甲醇燃料电池(DMFC)功率密度高，燃料甲醇价格低廉、储存和携带方便，特别适合作为电动车和小型电子设备的电源，是目前燃料电池研究领域的一个热点。本文介绍了40年来DMFC阴极电催化剂的发展历史及现状，并针对目前严重影响DMFC性能的“甲醇透过”问题，阐述了研制耐甲醇阴极电催化剂的重要性，讨论了今后DMFC阴极电催化剂的发展趋势。     

吸热碳氢燃料裂解镧改性混合型催化剂的研究

制备了吸热型碳氢燃料NNJ-150和镧离子交换改性的USY、ZSM-5分子重申及混合分子筛，考察了NNJ-150在USHY、HZSM-5和两者混合物以及镧改性单分子筛和混合分子筛催化剂上的裂解反应。结果表明，ZSM-5分子筛中添加镧，对NNJ-150的单分子裂解反应有明显影响；混合分子两种分子筛之间存在协同作用，低温（500℃）下，LaUSY LaZSM-5（75：25）混合分子筛对低碳烯烃的选择性较高（41.48％），催化剂寿命较长（35min以上），能有效提高吸热型碳氢燃料NNJ-150的吸热能效。     

聚合物共混物脆韧转变性能研究 Ⅲ.分散相形态参数之间的关系

为了研究形态（特别是分散状态）对聚合物共混物韧性的影响，建立了准网络形态模型，定义了分散相分布系数（ξ，０＜ξ１），并给出其物理意义，推导了基体层厚度的计算公式，研究了形态参数的变化对基体层厚度的影响．对于常见的无规形态，ξ≈１．对于准网络形态，ξ＜１，并且不是常数．计算结果表明，减小ξ和分散相粒径及其分布、增大其体积分数有利于减小基体层厚度．从理论上证明了准网络形态比无规形态更有利于减小基体层厚度．     

Dielectric studies of binary mixtures of n -propyl alcohol and ethylenediamine

Dielectric constant (ε’) and dielectric loss (ε") of n-propyl alcohol (PA), ethylenediamine (EDA) and their binary mixtures, for different mole fractions of ethylenediamine have been experimentally measured at 11.15 GHz microwave frequency. Values of density (ρ), viscosity (η) and square refractive index (n _D ² ) of binary mixtures as well as those of pure liquids are reported. Excess square refractive index, viscosity and activation energy of viscous flow have also been estimated. These parameters have been used to explain the formation of complexes in the system.     

Thec logc contribution to the electrolyte conductance and Onsager's reciprocal relation

The differential equations and the boundary conditions for the nonequilibrium binary distribution function of an unsymmetrical binary electrolyte are derived from the Ebeling-Falkenhagen continuity equation. The connection between the Onsager reciprocal relation and the binary distribution functions is shown. Further, Feistel's result for thec logc contribution to the conductance is extended to unsymmetrical binary electrolytes. The reason for the difference between Feistel's and Chen'sc logc term is explained, and the significance of Onsager's reciprocal relation for the calculation ofc logc and higher-concentration contributions of the conductance is discussed.     

Determination of percolation threshold electroactivity and phase behavior study on conducting blends of thermotropic polyesters and polyaniline

The new thermotropic polyester/polyaniline (PIn/PAni) blends have been prepared by solution blend of synthesized liquid crystalline poly[4,4′‐bis (ω‐alkoxy) biphenylisophthalate]s having four and six methylene units in spacer (PI4 and PI6) with PAni doped with camphorsolfonic acid (CSA). The percolation threshold electroactivity of prepared blend films has been determined by cyclic voltammetry. The effect of the PAni concentration, solvent nature and polyester structure on the electroactivity of the blends has been investigated. The extremely low percolation threshold of prepared PIn/PAni‐CSA blends from dimethylformamide (DMF) and m‐cresol solution was 3% weight of PAni‐CSA. The amount of conducting polymer necessary to retard the formation of the liquid crystalline (LC) phase is up to 45% by weight. Phase behavior studies by differential scanning calorimetry and polarizing microscopy show that blends with 45% of conducting polymer are both liquid crystal and conductive. The morphology of the blends has been investigated by scanning electron microscopy. Copyright © 2004 John Wiley & Sons, Ltd.     

Cellulose-precursor synthesis of nanocrystalline Ce<Subscript>0.8</Subscript>Gd<Subscript>0.2</Subscript>O<Subscript>2−δ</Subscript> for SOFC anodes

Developments of intermediate-temperature solid oxide fuel cells (IT SOFCs) require novel anode materials with a high electrochemical activity at 800–1070 K. The polarization of cermet anodes, made of nickel, ceria and yttria-stabilized zirconia (YSZ) and applied onto a YSZ solid electrolyte, can be significantly reduced by catalytically active ceria additions, the relative role of which increases with decreasing temperature. Further improvement is observed when using Ce_0.8Gd_0.2O_2– (CGO) having a high oxygen ionic conductivity instead of undoped ceria, owing to enlargement of the electrochemical reaction zone. Nanocrystalline CGO powders with grain sizes of 8–35 nm were thus synthesized via the cellulose-precursor technique and introduced into Ni–CGO–YSZ cermets, and tested in contact with a (La_0.9Sr_0.1)_0.98Ga_0.8Mg_0.2O_3– (LSGM) electrolyte at 873–1073 K. The results showed that the anode performance can be enhanced by additional surface activation, in particular by impregnation with a Ce-containing solution, and also by incorporation of YSZ, which probably acts as a cermet-stabilizing component. The overpotential of the surface-modified Ni–CGO (25 wt%–75 wt%) anode in a 10% H₂/90% N₂ atmosphere was approximately 110 mV at 1073 K with a current density of 200 mA/cm².Presented at the OSSEP Workshop Ionic and Mixed Conductors: Methods and Processes, Aveiro, Portugal, 10–12 April 2003