低能离子束横向发射度的测量及分析

The transverse emittance of an ion beam describes its transverse size as the particles are transported from a source to a target.It allows for predicting beam losses in limiting apertures and the beam focus size at the target.Various definitions and issues are discussed.The most common and emerging measuring techniques are presented,including their advantages.Several methods of emittance data analysis,their accuracy and trustworthiness,are discussed.     

Research on a novel compact linac

This work looks at a new type of electron linear accelerator.Compared with the traditional electron linac,it has only two main parts:a klystron and an accelerating tube,without the electron gun element.This new kind of linac could perform just like its predecesors but reduce cost and space.The preliminary design and simulation have been accomplished.In this paper,an overview discussion about the performance tests and some improvements to increase the beam current are presented.     

ELECTRON GUN FOR LARGE ORBIT GYROTRON (LOG) WITH DECREASED INFLUENCE OF CATHODE PLASMA ON ELECTRON BEAM PROPERTIES

High power Large Orbit Gyrotron (LOG) [1] is now under development at FIR FU. First version of this device was recently manufactured and then assembled with power supply ETIGO-IV [2]. Results of preliminary tests of electron-optic system are presented. The conditions when stableflat form of current pulse realized are discussed. Analytical estimations of cathode-anode distance to achieve small influence of cathode plasma during high voltage (HV) pulse are performed. Two new electron gun versions with decreased influence of the cathode plasma on its impedance and pulse form are suggested and optimized. New optimal magnetic field distributions are found. First gun has quiasi-flat cathode configuration near the anode diaphragm and provides operating current about 60 A. Second one uses blade cathode with operating current about 30 A. Beam quality for both guns is suitable for LOG operation.     

宽频带激光自由空间传输的调制特性研究

基于惠更斯-菲涅耳衍射积分公式,研究了宽带光束在菲涅耳衍射区的自由空间传输特性,得到宽带光束传输的调制深度与光束带宽Δλ及菲涅耳数F的变化关系。结果表明:一定的带宽对光束的均匀性有适当的改善;当光束的带宽Δλ<2λ0/F时,带宽越大,光束越均匀;当带宽满足条件Δλ=2λ0/F时,菲涅耳衍射完全消失;在一定的菲涅耳数范围内,宽带光束的调制深度随菲涅耳数振荡变化,振荡曲线的主极大值和次极大值分别出现在菲涅耳数为奇数和偶数处,而极小值则出现在菲涅耳数F=2k±1/3(k=1,2,3,…)处,在极小值处光束的均匀性最好。     

大型固体激光器光束定位稳定性分析

根据 ICF驱动器系统工程的要求 ,建立光学元件运动量与靶点光束定位之间关系 ,对稳定性进行初估。运用 B类评定方法、光线追迹方法和有限元数值模拟方法进行检验和校正 ,使其更具有可行性。并从结构随机振动理论出发 ,将结构用单自由度线性系统的平稳随机振动模拟 ,实现稳定性值激励源的重分。     

HL-2A 装置超声分子束注入缓解偏滤器靶板上边缘局域模热通量研究

在HL-2A 装置上优化和发展了偏滤器靶板上的红外测温系统,并利用该系统分析了高约束模放电期间边缘局域模的热沉积分布特性。在高约束模式放电期间,超声分子束注入使边缘局域模所引起的偏滤器靶板上瞬间热通量峰值下降了~60%,并伴随着边缘局域模爆发频率增加了2~3 倍,而等离子体储能仅下降了~8%。分析结果表明,大幅度的丝状结构在超声分子束注入之后得到了有效抑制,沉积到偏滤器靶板上的瞬间热通量峰值也随之下降。此外,在超声分子束注入之后偏滤器室内的热辐射损失大幅度增加,从而耗散了热输运所携带的部分能量,进一步分散了沉积到偏滤器靶板上的能量,有效地保护了偏滤器靶板。     

强流离子束流聚焦状态的数值模拟

结合空间电荷透镜的原理图以及离子束流的磁流体运动方程对离子束流聚焦状态进行了理论研究。采用层流非碰撞模型数值计算了离子束流不同初始半径以及不同入射角的束流出射角、焦距以及最小焦斑半径。理论分析了能散度、色散像差等因素对束流最小焦斑半径的影响。在离子束流遵循能量和角动量守恒的原则下,对不同入射角度的离子束流的束流最大半径进行了模拟计算。研究表明,束流入射角度增大,会聚角和最小焦斑半径减小,焦距增大。束流半径增大,会聚角、焦距和最小焦斑半径都增大。最佳会聚角所在的平滑区域内束流的发散度以及能散度对最小焦斑半径的影响较大。束流发散度或者能散度的增加,都能导致最小焦斑半径的增大。入射角度绝对值相同的束流,束流最大半径相同。     

Energy levels in doped SiGe quantum well studied by admittance spectroscopy

SiGe/Si quantum wells (QWs) with different Boron doping concentrations were grown by molecular beam epitaxy (MBE) on p-type Si(1 0 0) substrate. The activation energies of the heavily holes in ground states of QWs, which correspond to the energy differences between the heavy hole ground states and Si valence band, were measured by admittance spectroscopy. It is found that the activation energy in a heavily doped QW increases with doping concentration, which can be understood by the band alignment changes due to the doping in the QWs. Also, it is found that the activation energy in a QW with a doping concentration of 2 × 10²⁰ cm⁻³ becomes larger after annealing at a temperature of 685 °C, which is attributed to more Boron atoms activation in the QW by annealing.     

正电子产生靶上初级电子束半径的最小化研究

为获得尽可能高的正电子(e⁺)产额,严格控制初级电子(e^－)束在e⁺产生靶上的束半径是至关重要的.首先分析了使e^－束半径增大的各因素和对这些因素的制约;然后以北京正负电子对撞机(BEPC)的正电子源为例,给出了束半径的实测值和计算值的比较,以具体说明这些因素的影响;最后讨论了北京正负电子对撞机二期工程(BEPC-Ⅱ)的相应优化设计研究,提出了获得靶上最小束半径的若干途径.