乳化法—火焰原子吸收光谱法测定奶粉中的锌

用乳化剂ＯＰ将奶粉乳化成稳定的乳浊液，喷入空气－乙炔火焰中，以标准加入法测定锌，测定结果与灰化法一致，方法简便，准确。     

氢化物发生电感耦合等离子体原子发射光谱同时测定纯铜中氢化物和非氢化物形成元素

用新型氢化物发生喇叭口Ⅱ型同心雾化器替代Meinhard同心雾化器，溶液雾化为气溶胶和氢化物发生反应生成氢化物气体就可以在雾化系统中同时进行，选用L-巯基丙氨酸(L-cysteine)和硫脲(thiourea)作为基体铜的掩蔽剂，无需分离基体铜，实现了电感耦合等离子体原子发射光谱(ICP-AES)同时测定纯铜样品中氢化物和非氢化物形成元素的目的。研究了酸度、NaBH4的浓度、载气流速及清洗时间对氢化物形成元素的影响，考察了铜基体对氢化物形成元素的化学干扰情况。用本方法测定了纯铜标准样品(NIST SRM400)，结果令人满意。在1000mg/L纯铜样品溶液中，其氢化物形成元素As、Bi、Sb、Sn、Se和Te的检出限分别为0．08、0．15、0．10、0．17、0．21和0．23μg／L。     

流动注射-氢化物发生-原子吸收光谱法测定雪中的微量铅

建立了测定雪中微量铅的流动注射-氢化物发生-原子吸收光谱法。在优化条件下。测定铅的线性范围为0～52．0ng／mL，线性回归方程为A=0．018c 0．016，相关系数r=0．9995，检出限为0．2ng／mL。用于雪中微量铅的测定，加标回收率为94．2％～107．3％，相对标准偏差为1．47％～3．22％。该方法的测定结果与标准加入法基本一致。     

8-羟基喹啉-5-磺酸纤维微柱分离富集电感耦合等离子体原子发射光谱法同时测定多种痕量元素

本文合成了8-羟基喹啉-5-磺酸纤维滤纸片,以此做为微柱填充物同时富集了10种痕量元素,并分离了样品中的高盐组分.本方法可使痕量组分的分离与富集同步进行,因而特别适用于原子光谱测定前样品的预处理.     

氨基羧酸纤维分离富集-电感耦合等离子体原子发射光谱法测定多种痕量稀土元素

本文制备了氨基羧酸纤维滤纸片作为柱填充物，成功地分离和富集了地化样品中的多种稀土元素。富集后的稀土元素采用电感耦合等离子体原子发射光谱法测定，回收率为90％～109％。本文还对基体干扰及其消除进行了研究。     

Indirect automatic atomic absorption determination of sulphate based on its precipitation with barium

A continuous precipitation flame atomization atomic absorption spectrometric method for the indirect determination of sulphate is proposed. By using a reversed flow-injection configuration for precipitation as barium sulphate, this anion was determined in the range 10–150 g/ml, with a relative standard deviation of 2.6%. The sensitivity was increased by a factor of seven by using a nitrous oxide-acetylene flame to measure barium.     

衬钽管石墨炉原子吸收法测定痕量镓时基体改进剂的研究及应用

提出用钒和铜混合基体改进剂衬钽管石墨炉原子吸收测定镓的方法。衬钽管使镓的灵敏度提高6倍左右,钒和铜混合基体改进剂不仅能进一步提高灵敏度,而且能提高灰化温度,降低原子化温度,增强抗干扰能力。测定 GSD 标准样品中的镓时,不需对样品进行预分离即可直接进行测定,结果与参考值相符。     

Temperature Development of Homo- and Hetero-Clustering in Saturated Vapors

Computational findings of temperature increase of clustering degree in saturated vapors are analyzed. A thermodynamic proof is presented and a simple criterion derived. Illustrations are based on saturated steam, magnesium and carbon vapor. The results are applicable to synthesis of fullerenes, metallofullerenes, and heterofullerenes, chemical vapor deposition technique, or atmospheric chemistry.     

Feasibility of using solid sampling graphite furnace atomic absorption spectrometry for speciation analysis of volatile and non-volatile compounds of nickel and vanadium in crude oil

A method for the direct determination of volatile and non-volatile nickel and vanadium compounds in crude oil without previous treatment using direct solid sampling graphite furnace atomic absorption spectrometry is proposed. The crude oil samples were weighed directly onto solid sampling platforms using a microbalance and introduced into a transversely heated solid sampling graphite tube. In previous work of our group losses of volatile nickel and vanadium compounds have been detected, whereas other nickel and vanadium compounds were thermally stable up to 1300 and 1600 °C, respectively. In order to avoid this problem different chemical modifiers (conventional and permanent) have been investigated. With 400 μg of iridium as permanent modifier, the signal started to drop already after two atomization cycles, possibly because of an interaction of nickel (which is a catalyst poison) with iridium. Twenty micrograms of palladium applied in each determination was found to be optimum for both elements. The palladium was deposited on the platform and submitted to a drying step at 150 °C for 75 s. After that the sample was added onto the platform and submitted to the furnace program. The influence of sample mass on the linearity of the response and on potential measurement errors was also investigated using four samples with different nickel content. For the sample with the lowest nickel concentration the relationship between mass and integrated absorbance was found to be non-linear when a high sample mass was introduced. It was suspected that the modifier had not covered the entire platform surface, which resulted in analyte losses. This problem could be avoided by using 40 μL of 0.5 g L⁻¹ Pd with 0.05% Triton X-100. Calibration curves were established with and without modifier, with aqueous standards, oil-in-water emulsions and the certified reference material NIST SRM 1634c (trace metals in residual fuel oil). The sensitivity for aqueous standards and emulsions was close to that for SRM 1634c, making possible the use of aqueous standards for calibration. The limits of detection and quantification obtained for nickel and vanadium under this condition were found to be 0.02 and 0.06 μg g⁻¹, respectively, for both elements, based on 10 mg of sample. Nickel and vanadium were determined in the samples with (total Ni and V) and without the use of Pd (thermally stable compounds), and the concentration of volatile compounds was calculated by difference. The results were compared with those obtained by high-resolution continuum source graphite furnace atomic absorption spectrometry by emulsion technique; no significant differences were found for total Ni and V at the 95% confidence level according to a Student's t-test.     

Hydride generation atomic fluorescence spectrometric determination of ultratraces of selenium and tellurium in cow milk

A sensitive procedure has been developed for selenium and tellurium determination in milk by hydride generation atomic fluorescence spectrometry (HG-AFS) after microwave-assisted sample digestion. The method provides sensitivity values of 1591 and 997 fluorescence units ng⁻¹ ml⁻¹ with detection limits of 0.005 and 0.015 ng ml⁻¹ for Se and Te, respectively. The application of the developed methodology to the analysis of cow milk samples of the Spanish market evidenced the presence of concentration ranges from 11.1 to 26.0 ng ml⁻¹ for Se, and from 1.04 to 9.7 ng ml⁻¹ for Te having found a good comparability with data obtained after dry-ashing of samples.