氧化锶催化性质：Ⅱ.SrO,MgO上异丙醇的分解反应

ＳｒＯ，ＭｓＯ对异丙醇的分解反应有各自的作用形式，因而产物分布也有明显差别．ＭｇＯ上异丙醇分解，在较低温度时，主要产物为丙酮和丙烯；随温度升高，生成丙烯的量增加，而丙酮的量减少，直至消失，在ＳｒＯ上，异丙醇在较高温度时反应，产物几乎为丙酮，丙烯的生成量极少。认为：产物中丙烯来源于异丙醇在催化剂表面强酸中心上的脱水；丙酮在ＭｇＯ上来源于强碱中心和酸中心协同作用异丙醇的脱氢，而在ＳｒＯ上则是ＳｒＯ表面极强的碱中心作用异丙醇而脱氢制得。     

甲烷氧化偶联催化反应的特征

应用程序升温反应（ＴＰＲ）及质谱分析表征了ＣａＯ，Ｓｍ２Ｏ３，０．５－１０％Ｓｍ／ＣａＯ催化剂上的甲烷氧化偶联反应特性。谱图分析表明，在４００－１０００℃范围内，甲烷氧化偶联反应产物的变化呈现三个反应温度区域：（１）完全氧化区，反应主要为ＣＨ３·在催化剂表面完全氧化形成ＣＯｘ和Ｈ２：（２）偶联区，主要为ＣＨ３·的氧化和偶联竞争反应，Ｈ２谱线出现明显的低温峰；（３）氧耗尽区，反应为高温气相反应，产物     

PEO-LiClO_4-ZSM5 composite polymer electrolyte (IV): Polarized optical microscopy study

All solid-state lithium polymer batteries may be one of the best choices for the future electrochemical power source, characterized by high energy densities, good cyclability, reliability and safety[1,2]. Owing to its potential capability to replace the t…     

Complexation of Al(III) by 8-Hydroxyquinoline and Drastic Fluorescence Enhancement in Reverse Micelles

Complexation of Al^IIIby 8-hydroxyquinoline and fluorescence behavior of the quinolinate(s) were studied in reverse micellar systems at low water content, and compared to aqueous media. Two surfactants were used: one was cationic (CTAC: cetyltrimethylammonium chloride) and the other was anionic (AOT: sodium bis(2-ethylhexyl)sulfosuccinate). The results obtained in the CTAC/dichloromethane system (W= [H₂O]/[surfactant] = 0.9) showed that complexation occurred very likely in the oil phase and no micellar effect was observed. On the contrary, in the presence of AOT, specific micellar effects were observed due to the presence of the anionic polar heads: stabilization of the positively charged 1:1 and 1:2 chelates, at the expense of the neutral water-insoluble 1:3 chelate which is formed in aqueous solutions under similar conditions;drastic fluorescence enhancement factorsof 120 and 100 in AOT/heptane (W= 1.5) and AOT/dichloromethane (W= 1.6), respectively. Such factors have never been reported so far in either hydroorganic or direct micellar systems. In return, the length of time for the production of the complex(es) is increased because of the microheterogeneity of the medium and the small sizes of the water pools.     

Cellulose-precursor synthesis of nanocrystalline Ce<Subscript>0.8</Subscript>Gd<Subscript>0.2</Subscript>O<Subscript>2−δ</Subscript> for SOFC anodes

Developments of intermediate-temperature solid oxide fuel cells (IT SOFCs) require novel anode materials with a high electrochemical activity at 800–1070 K. The polarization of cermet anodes, made of nickel, ceria and yttria-stabilized zirconia (YSZ) and applied onto a YSZ solid electrolyte, can be significantly reduced by catalytically active ceria additions, the relative role of which increases with decreasing temperature. Further improvement is observed when using Ce_0.8Gd_0.2O_2– (CGO) having a high oxygen ionic conductivity instead of undoped ceria, owing to enlargement of the electrochemical reaction zone. Nanocrystalline CGO powders with grain sizes of 8–35 nm were thus synthesized via the cellulose-precursor technique and introduced into Ni–CGO–YSZ cermets, and tested in contact with a (La_0.9Sr_0.1)_0.98Ga_0.8Mg_0.2O_3– (LSGM) electrolyte at 873–1073 K. The results showed that the anode performance can be enhanced by additional surface activation, in particular by impregnation with a Ce-containing solution, and also by incorporation of YSZ, which probably acts as a cermet-stabilizing component. The overpotential of the surface-modified Ni–CGO (25 wt%–75 wt%) anode in a 10% H₂/90% N₂ atmosphere was approximately 110 mV at 1073 K with a current density of 200 mA/cm².Presented at the OSSEP Workshop Ionic and Mixed Conductors: Methods and Processes, Aveiro, Portugal, 10–12 April 2003     

SYNTHESIS OF MESOPOROUS POLY(STYRENE-co-MALEIC ANHYDRIDE)/SILICA HYBRID MATERIALS VIA A NONSURFACTANT-TEMPLATED SOL-GEL PROCESS*

Mesoporous poly (styrene-co-maleic anhydride)/silica hybrid materials have been prepared. The synthesis wasachieved by the HCl-catalyzed sol-gel reactions of tetraethyl orthosilicate (TEOS) and styrene-maleic anhydride copolymerin the presence of 3-aminopropyl triethoxysilane (APTES) as a coupling agent and citric acid as a nonsurfactant template orpore-forming agent, followed by ethanol extraction. Characterization results from nitrogen sorption isotherms and powder X-ray diffraction indicate that polymer-modified mesoporous materials with large specific surface areas (e.g. 900 m~2/g) andpore volumes (e.g. 0.6 cm~3/g) could be prepared. As the citric acid concentration is increased, the specific surface areas, porevolumes and pore diameters of the hybrid materials increase.     

Thermal behaviour of amorphous Li2ZrO3 prepared by sol-gel technique

The results of the investigations of thermal behaviour of Li₂ZrO₃, prepared in the amorphous state by means of sol-gel technique are demonstrated. The thermal treatment was carried out in air under constant heating rate of 5 deg·min^–1 and cooling rate of 2.5 deg·min^–1. The methods of DTA, TG, Emanation Thermal Analysis (ETA) and dilatometry were used, for characterization of the thermal behaviour in dynamic conditions. The X-ray diffraction patterns were used for characterization of the phase changes observed by TA Methods.

---

Zusammenfassung Ergebnisse aus Untersuchungen des thermischen Verhaltens von Li₂ZrO₃, hergestellt mittels einer Sol-Gel-Technik im amorphen Zustand werden dargelegt. Die thermische Behandlung wurde in Luft bei einer konstanten Aufheizgeschwindigkeit von 5 Grad·min^–1 und einer Abkühlgeschwindigkeit von 2,5Grad·min^–1 durchgeführt. Zur Beschreibung des thermischen Verhaltens unter dynamischen Verhältnissen wurden DTA, TG, Emanationsthermoanalyse und Dilatometrie angewendet. Zur näheren Charakterisierung der bei TG beobachteten Phasenumwandlungen wurde Röntgendiffraktion verwendet.

     

Direct and simultaneous voltammetric analysis of heavy metals in tap water samples at Assiut city: an approach to improve the analysis time for nickel and cobalt determination at mercury film electrode

Tap water samples (Assiut city, lie in the middle north of upper Egypt, approx. 370 km from Cairo, January-March, 2002) were taken from the eight sampling sites of different locations at Assiut city. The samples are analyzed to determine the total content of cadmium, copper, lead and zinc by differential pulse anodic stripping voltammetry (DPASV) while nickel and cobalt are determined by a new simple differential pulse adsorptive stripping voltammetry (DPAdSV), using dimethylglyoxime (DMG) as the complexing agent. This method uses sodium sulfite as the supporting electrolyte, which facilitates the removal of oxygen interference without the traditional necessity of purging with inert gas. The effect of various parameters was studied using DPASV (for Cd, Pb, Cu and Zn) and AdSV (for Ni and Co) methods. Subsequently, under the so found experimental conditions, the stability of calibration curves and the detection limits (μg/l) have been determined. The data achieved (for all metals utility) are comparable to those measured by the graphite furnace atomic absorption spectrophotometric (GF-AAS) method. The effects of the interferences between these metal ions have been investigated. Moreover, the effect of storage was discussed and the obtained results were compared favorably with standard official methods. Statistical analysis of the database exhibits applicability and the accuracy of the techniques. The results obtained from the two techniques (Voltammetry and GF-AAS) are in very good agreements in the most tap water samples.     

非晶SiO2纳米灯笼的制备和表征

在1000 ℃用活性炭把二氧化锡粉末还原成单质锡, 锡作为催化剂, 硅片作为硅源同时作为收集衬底, 在硅片上制备出了非晶SiO2纳米灯笼. 灯笼的一端连在硅片上, 另一端为一个锡球, 中间是一些圆弧状的SiO2纳米线把两端相连. 纳米灯笼具有良好的对称性. 利用扫描电子显微镜(SEM)、高分辨透射电子显微镜(HRTEM)、选区电子衍射(SAED) 和HRTEM自带的能谱分析仪(EDS)对样品的表面形貌、微观结构和成分进行了分析研究. 结果表明, 灯笼中SiO2纳米线为非晶态, 结点是晶态锡, 结点表面覆盖一层非晶态的硅的氧化物. 结合实验条件对纳米灯笼的生长机理进行了讨论, 提出了纳米灯笼生长的一个模型.     

叠氮二乙基铝合成及其相关反应的研究

在芳烃溶剂中用氯化二乙基铝和叠氮化钠反应合成了叠氮化二乙基铝(DEAA),其产率高达87%,比文献值高出17%。在正己烷中没有合成出DEAA,在含30%四氢呋喃(THF)的正己烷中合成出DEAA·THF配合物。在芳烃溶剂中,随着苯环上甲基数目的增加,DEAA的收率增加。测定了氯化二乙基铝、氯化二乙基铝的正己烷溶液、氯化二乙基铝的甲苯溶液的 ²⁷Al NMR谱。由 ²⁷Al NMR谱数 据确定了氯化二乙基铝在甲苯中解离平衡式,计算了氯化二乙基铝在甲苯中解离平衡的热力学数据。用DEAA与苯甲酸甲酯直接合成了苯甲酰叠氮,并表征了其结构。这是一个新反应,至今无文献报导。用实验证明了在正己烷溶液中,用氯化二乙基铝、叠氮化钠与苯甲酸甲酯合成苯甲酰叠氮,没有经过氯化二乙基铝和叠氮化钠反应生成中间体DEAA的这一步。依据实验事实建立了上述三种反应的反应机理。