Rational Screening of High-Voltage Electrolytes and Additives for Use in LiNi0.5Mn1.5O4-Based Li-Ion Batteries

In the present work, we focus onthe experimental screening of selected electrolytes, which have been reported earlier in different works, as a good choice for high-voltage Li-ion batteries. Twenty-four solutions were studied by means of their high-voltage stability in lithium half-cells with idle electrode (C+PVDF) and the LiNi_0.5Mn_1.5O₄-based composite as a positive electrode. Some of the solutions were based on the standard 1 M LiPF₆ in EC:DMC:DEC = 1:1:1 with/without additives, such as fluoroethylene carbonate, lithium bis(oxalate) borate and lithium difluoro(oxalate)borate. More concentrated solutions of LiPF₆ in EC:DMC:DEC = 1:1:1 were also studied. In addition, the solutions of LiBF₄ and LiPF₆ in various solvents, such as sulfolane, adiponitrile and tris(trimethylsilyl) phosphate, atdifferent concentrations were investigated. A complex study, including cyclic voltammetry, galvanostatic cycling, impedance spectroscopy and ex situ PXRD and EDX, was applied for the first time to such a wide range of electrolytesto provide an objective assessment of the stability of the systems under study. We observed a better anodic stability, including a slower capacity fading during the cycling and lower charge transfer resistance, for the concentrated electrolytes and sulfolane-based solutions. Among the studied electrolytes, the concentrated LiPF₆ in EC:DEC:DMC = 1:1:1 performed the best, since it provided both low SEI resistance and stability of the LiNi_0.5Mn_1.5O₄ cathode material.     

GC-MS同时测定油脂性的食品及食品添加剂中16种邻苯二甲酸酯类迁移物

采用气相色谱电子轰击离子源质谱(GC-EI-MS)技术同时分析油脂性食品及油脂性添加剂中16种邻苯二甲酸酯(PAEs)环境激素的迁移量。以GC-EI-MS选择离子检测模式(SIM)进行定性和定量分析,优化出了油脂性基质的系统前处理方法。当样品的加标浓度水平分别为0.25和0.50 mg/kg时,加标回收率为58.9%～111.1%,相对标准偏差为1.0%～4.6%。16种PAEs在0.1～2.0 mg/L浓度范围内16种PAEs都呈现良好的线性关系,r为0.9960～0.9995,检测限(LOD)均为0.07～0.70μg/kg。方法已用于8批油脂性的食品和7批油脂性食品添加剂中16种痕量PAEs迁移物的分析。     

酸洗脱矿对胜利褐煤热解过程中N迁移转化的影响

在石英管流化床反应器中对胜利褐煤进行快速热解实验,考察了773~1 173 K下酸洗脱矿对胜利褐煤热解过程中N迁移转化规律的影响。通过比较原煤和酸洗后煤中N的不同逸出规律可以得出,影响酸洗前后胜利褐煤热解过程中N迁移转化规律的主要是碱金属Na及碱土金属Ca;热解过程中,煤中的Na和Ca促使煤中的N向NH3转化并有效抑制了HCN的生成,金属离子的存在对催化焦油N转化为NH3的作用较为明显;原煤中的碱金属和碱土金属的赋存使半焦裂解反应加剧,降低了固体半焦的产率,半焦N的产率也随之减少;与原煤相比,酸洗煤热解半焦中的吡啶型N(N-6)含量较多,而吡咯型N(N-5)和季N(N-Q)相对较少。     

高效液相色谱法同时测定肉制品中的6种食品添加剂

建立了同时测定肉制品中化学性质差异较大的6种常用食品添加剂的高效液相色谱(HPLC)分析方法。根据6种添加剂(苯甲酸(钠)、山梨酸(钾)、糖精钠、安赛蜜、诱惑红和胭脂红)的化学性质,对HPLC分析条件进行了详细的优化。结果表明:以ZORBAX Eclipse Plus C18柱(150mm×4.6mm,5μm)为分析柱,以甲醇和20mmol/L醋酸铵溶液(pH为6.9)为流动相进行梯度洗脱,在235nm波长下进行检测,可以在18min内完成6种添加剂的同时测定。在高、低两个加标浓度下,样品的回收率为80.7%～94.4%,相对标准偏差(n=3)为2.0%～7.1%。结果表明,该方法快速、准确,能够同时分析测定肉制品中上述6种食品添加剂。     

ON THE MECHANISM OF “HYDROPHOBIC” INTERACTIONS

It is shown that the interfacial attraction between low-energy bodies immersed in aqueous media, known as “hydrophobic” interaction, can be quantitatively accounted for by, mainly, the hydrogen-bonding energy of cohesion of water, plus, to a very minor extent, a van der Waals-Lifshitz attraction between the Immersed law-energy bodies.     

Comparison of Bottom-up Filling in Electroless Plating with an Addition of PEG,PPG and EPE

The bottom‐up filling capabilities of electroless copper plating bath with an addition of additives, such as polyethylene glycol (PEG), polypropylene glycol (PPG) and triblock copolymers of PEG and PPG with ethylene oxide terminal blocks termed EPE, were investigated by the cross‐sectional scanning electron microscopy (SEM) observation of sub‐micrometer trenches. Though three additives had inhibition for electroless copper deposition, the suppression degrees of three additives were different. EPE‐2000 had the strongest suppression for electroless copper deposition, and the suppression of PEG‐2000 was the weakest. The bottom‐up filling capability of electroless copper was investigated in a plating bath containing different additives with the concentration of 2.0 mg/L. The cross‐sectional SEM observation indicated the trenches with the width of 280 nm and the depth of 475 nm were all completely filled by the plating bath with an addition of EPE‐2000, but the trenches were not completely filled by the plating bath with an addition of PEG‐2000 or PPG‐2000, and some voids appeared. Linear sweep voltammetry measurement indicated that three additives all inhibited the cathodic reduction reaction and the anodic oxidation reaction, and the inhibition of EPE‐2000 was the strongest among three additives, which agreed with that of the deposition rate of electroless copper. Significant differences in surface roughness of deposited copper film were observed by UV‐visible near‐infrared for different suppressors, and the bright and smooth of deposited copper film were in accordance with the inhibition of three additives.     

Microstructure and morphology of self‐assembling multiblock poly(ethylene‐1‐butene)‐n copolymers in solution studied by wide‐Q small‐angle neutron scattering and microscopy

Multiblock ethylene‐1‐butene copolymers (PEB‐n) with graded ethylene content (where n is the number of ethyl branches per 100 backbone carbons) represent efficient cold filter plugging point (CFPP) depressants for crude oils and middle distillates. The aggregation behavior and the interaction with wax molecules of a tetrablock PEB‐2.6/PEB‐6.0/PEB‐10.9/PEB‐13.2 and triblock PEB‐6.5/PEB‐8.9/PEB‐10.1 copolymers in decane solutions were investigated over a wide temperature range by combining different small‐angle neutron scattering techniques and optical microscopy. The experimental results revealed in the decrease of temperature formation and evolution of multisized structural levels showing a hierarchical organization on the length scale from 1 nm up to 10 μm. One‐dimensional polymer aggregates arising as initial structures associate and branch that lead to the occurrence of complex macroaggregates with diffusive interfaces and sizes of several microns. The one‐dimensional copolymer structure shows longitudinal density modulation and micellar‐like substructures in neat polymer solutions. When wax is added, this structure becomes more homogeneous in decrease of temperature as a consequence of the cocrystallization of wax and copolymer. The wax crystallization in board‐like objects of much smaller size than required by the CFPP criterion of oil and refinery industry (filter mesh size of 45 μm) is templated and controlled by the assembling features of the crystalline–amorphous PEB‐n multiblock copolymers. © 2010 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2011     

Multielement determination of major elements in polymer additives by microwave induced plasma atomic emission spectrometry after microwave digestion

A method for multielement determination of major elements in polymer additives by microwave induced plasma atomic emission spectrometry (MIP-AES) has been elaborated. Microwave digestion with nitric acid was selected for sample preparation because of its speed and versatility. Sodium nitrate was added to the digestion mixture in order to reduce phosphorus losses. The precision obtained varied between 2 and 4.5% depending on the element determined. The accuracy of the method was studied by analyzing the Spex 5-element oil standard. The method was applied to a variety of commercial and in-house prepared compositions.     

苯甲酰基的脱去

讨论了苯甲酰基的脱去方法，包括一些传统的脱苯甲酰基方法和新的方法、试剂。脱苯甲酰基方法在此粗分为四类，即酸催化水解法、碱催化水解法、选择性脱苯甲酰基法和其它特殊方法。参考文献48篇。