Encapsulation and release of biomolecules from Ca-P/PHBV nanocomposite microspheres and three-dimensional scaffolds fabricated by selective laser sintering

This study focused on the fabrication of calcium phosphate (Ca-P)/poly(hydroxybutyrate-co-hydroxyvalerate) (PHBV) nanocomposite scaffolds loaded with biomolecules using the selective laser sintering (SLS) technique and their evaluation. Ca-P/PHBV nanocomposite microspheres loaded with bovine serum albumin (BSA) as the model protein were fabricated using the double emulsion solvent evaporation method. The encapsulation efficiency of BSA in PHBV polymer microspheres and Ca-P/PHBV nanocomposite microspheres were 18.06 ± 0.86% and 24.51 ± 0.60%, respectively. The BSA loaded Ca-P/PHBV nanocomposite microspheres were successfully produced into three-dimensional porous scaffolds with good dimensional accuracy using the SLS technique. The nanocomposite microspheres served as protective carriers and maintained the bioactivity of BSA during SLS. The effects of SLS parameters such as laser power and scan spacing on the encapsulation efficiency of BSA in the scaffolds and in vitro BSA release were studied. An initial burst release was observed, which was followed by a slow release of BSA. After 28-day release, The PHBV matrix was slightly degraded after 28-day in vitro release study. It was shown that nanocomposite scaffolds with controlled architecture obtained via SLS could be incorporated with biomolecules, enhancing them with more functions for bone tissue engineering application or making them suitable for localized delivery of therapeutics.     

高灵敏CdTe量子点探针的构建及与金属离子的作用

采用变性的牛血清白蛋白(dBSA)对水相合成的CdTe量子点进行修饰, 构建了高灵敏金属离子探针, 研究了其对重金属离子的检测性能并对机理进行了探讨. 通过优化反应条件, 合成了具有高量子产率的以巯基乙酸为稳定剂的水溶性CdTe量子点, 并采用变性的牛血清白蛋白分别对不同粒径的CdTe量子点进行修饰, 确定变性的牛血清白蛋白与不同粒径量子点之间的最佳比例. 在纯化变性的牛血清白蛋白修饰的量子点(dBSA-QDs)的基础上, 研究了该量子点与不同金属离子的作用. 结果表明, 量子点经修饰后, 其量子产率、 抗光漂白性及稳定性得到显著提高; 而且dBSA-QDs的荧光可被重金属离子有效猝灭, 与巯基乙酸稳定的量子点(TGA-QDs)相比, 检测灵敏度显著提高.     

Generation of anti-azoxystrobin monoclonal antibodies from regioisomeric haptens functionalized at selected sites and development of indirect competitive immunoassays

Azoxystrobin is a modern strobilurin fungicide used around the world to combat prime diseases affecting highly valuable crops. Accordingly, residues of this chemical are frequently found in food, even though mostly under maximum tolerated levels. We herein describe the development of an indirect competitive immunoassay for the determination of azoxystrobin residues. A panel of monoclonal antibodies displaying subnanomolar affinity to azoxystrobin was generated using, as immunizing haptens in mice, four functionalized derivatives carrying the same spacer arm located at different rationally chosen positions. This collection of antibodies was thoroughly characterized with homologous and heterologous antigens, and the immunoassay consisting of monoclonal antibody AZo6#49 and the coating conjugate OVA–AZb6, which displayed an IC₅₀ value of 0.102 μg L⁻¹ and a LOD of 0.017 μg L⁻¹, was eventually optimized. The response to different pH and ionic strength conditions of the specific assay was studied using a biparametric approach. In addition, the influence of Tween 20 and organic solvents over the assay parameters was also evaluated. After optimization, the developed immunochemical assay was applied to the analysis of azoxystrobin in spiked juices of relevant fruits and vegetables, showing excellent recoveries between 2 and 500 μg L⁻¹.     

Surface imprinted thin polymer film systems with selective recognition for bovine serum albumin

Molecularly imprinted polymers are synthetic antibody mimics formed by the crosslinking of organic or inorganic polymers in the presence of an analyte which yields recognitive polymer networks with specific binding pockets for that biomolecule. Surface imprinted polymers were synthesized via a novel technique for the specific recognition of bovine serum albumin (BSA). Thin films of recognitive networks based on 2-(dimethylamino)ethyl methacrylate (DMAEMA) as the functional monomer and varying amounts of either N,N′-methylenebisacrylamide (MBA) or poly(ethylene glycol) (400) dimethacrylate (PEG400DMA) as the crosslinking agent were synthesized via UV free-radical polymerization and characterized. A clear and reproducible increase in recognition of the template BSA was demonstrated for these systems at 1.6-2.5 times more BSA recognized by the MIP sample relative to the control polymers. Additionally, these polymers exhibited selective recognition of the template relative to competing proteins with up to 2.9 times more BSA adsorbed than either glucose oxidase or bovine hemoglobin. These synthetic antibody mimics hold significant promise as the next generation of robust recognition elements in a wide range of bioassay and biosensor applications.     

Serum Albumin Targeted,pH‐Dependent Magnetic Resonance Relaxation Agents

The objective of this work was the synthesis of serum albumin targeted, Gd^III‐based magnetic resonance imaging (MRI) contrast agents exhibiting a strong pH‐dependent relaxivity. Two new complexes ( Gd‐glu and Gd‐bbu ) were synthesized based on the DO3A macrocycle modified with three carboxyalkyl substituents α to the three ring nitrogen atoms, and a biphenylsulfonamide arm. The sulfonamide nitrogen coordinates the Gd in a pH‐dependent fashion, resulting in a decrease in the hydration state, q, as pH is increased and a resultant decrease in relaxivity (r₁). In the absence of human serum albumin (HSA), r₁ increases from 2.0 to 6.0 mM ^?1 s^?1 for Gd‐glu and from 2.4 to 9.0 mM ^?1 s^?1 for Gd‐bbu from pH 5 to 8.5 at 37 °C, 0.47 T, respectively. These complexes (0.2 mM ) are bound (>98.9 %) to HSA (0.69 mM ) over the pH range 5–8.5. Binding to albumin increases the rotational correlation time and results in higher relaxivity. The r₁ increased 120 % (pH 5) and 550 % (pH 8.5) for Gd‐glu and 42 % (pH 5) and 260 % (pH 8.5) for Gd‐bbu . The increases in r₁ at pH 5 were unexpectedly low for a putative slow tumbling q=2 complex. The Gd‐bbu system was investigated further. At pH 5, it binds in a stepwise fashion to HSA with dissociation constants K_d1=0.65, K_d2=18, K_d3=1360 μM . The relaxivity at each binding site was constant. Luminescence lifetime titration experiments with the Eu^III analogue revealed that the inner‐sphere water ligands are displaced when the complex binds to HSA resulting in lower than expected r₁ at pH 5. Variable pH and temperature nuclear magnetic relaxation dispersion (NMRD) studies showed that the increased r₁ of the albumin‐bound q=0 complexes is due to the presence of a nearby water molecule with a long residency time (1–2 ns). The distance between this water molecule and the Gd ion changes with pH resulting in albumin‐bound pH‐dependent relaxivity.     

Cd（Ⅱ）与HSA或BSA的结合平衡研究

用平衡透析法详细研究了生理pH(7.43)条件下Cd(Ⅱ)与HSA或BSA的结合平衡.通过非线性最小二乘法拟合Bjerrum方程,首次报道了Cd(Ⅱ)-HSA和Cd(Ⅱ)-BSA体系的逐级稳定常数值,其K_1～K_3的数量级均为10~4;Hill系数和自由能偶合定量分析表明Cd(Ⅱ)与HSA或BSA的结合均产生在类似体系中少见的强的正协同效应,且Cd(Ⅱ)与HSA结合产生的正协同效应大于BSA;Scatchard图分析表明,Cd(Ⅱ)在HSA和BSA中均有3个强结合部位.通过Cd(Ⅱ)与Cu(Ⅱ),Zn(Ⅱ)或Ca(Ⅱ)等竞争结合HSA或BSA的结果,进一步讨论了Cd(Ⅱ)在HSA或BSA中强结合部位的可能位置和(或)配体.     

甲基紫与牛血清白蛋白作用的荧光光谱研究

在pH 7.40的Tris-HC1缓冲溶液体系中,采用荧光光谱法和同步荧光光谱法研究了甲基紫(MV)与牛血清白蛋白(BSA)相互作用.结果表明MV与BSA相互作用两者存在一个结合位点,结合常数(KA)为7.628×103 L/mol,MV与BSA主要发生疏水作用,反应是一个吸热、熵增的自发过程.     

丝裂霉素C与牛血清蛋白结合作用的研究

结合光谱法与微量热法研究了水溶液中丝裂霉素C与牛血清白蛋白分子间的结合反应,测定了反应的结合常数K~A,结合位点数n及热力学函数△~rG~m,△~rH~m和△~rS~m,并确定了分子间作用力性质;依据Forster非辐射能量转移机制,确定了授体-受体间的结合距离和能量转移效率;采用同步荧光技术考察了丝裂霉素C对牛血清白蛋白构象的影响。     

Thermodynamics of porphyrin binding to human serum albumin using affinity capillary electrophoresis

Summary The interaction thermodynamics of heptacarboxylporphyrin (HCP) and protoporhyrin (PP) with human serum albumin (HSA) was studied by affinity capillary electrophoresis (ACE) over the temperature range of 25–50°C, where HCP and PP bound to HSAvia 1:1 molecular association. The binding equilibrium constants (pH 7.4, phosphate buffer) for the binding of HCP with HSA were found to decrease with an increase in temperature, whereas the binding constants of the PP/HSA system appeared to be independent of temperature changes over the range studied. The van’t Hoff relationship (25–50°C) was found to be linear for the interaction of either HCP or PP with HSA. However, the interaction thermodynamics for both of these porphyrins with HSA were found to be quite different. In particular, the interaction of HCP (a hydrophilic porphyrin) with HSA appeared to be based on an enthalpy-driven process, whereas the binding between PP (a hydrophobic porphyrin) and HSA driven by a favorable change in entropy. The ability of using ACE to evaluate the interaction thermodynamics of serum proteins (e.g., HSA) with ligands (e.g., porphyrins and related compounds) should aid in the development of new and more effective photosensitizers in the photodynamic therapy of cancer.     

Cathodic stripping voltammetric detection and determination at a hanging mercury-drop electrode of dye contaminants in purified biomaterials: study of the human serum albumin and reactive dye 120 system

Procion red HE-3B (RR120) is an example of dye currently used in affinity purification. A method is described for determining trace amounts of RR120 dye contaminant in human serum albumin by cathodic stripping voltammetry. The method is based on a measure of a well-defined peak at −0.58 V, obtained when samples of HSA protein (0.01-2% w/v) containing dye concentrations are submitted to a heating time of 330 min at 80 °C in NaOH, pH 12.0 and the samples are removed to a solution containing Britton-Robinson buffer, pH 4.0. Using an optimum accumulation potential and time of 0 V and 240 s, respectively, linear calibration curves were obtained from 1.0×10⁻⁹ to 1.0×10⁻⁸ mol l⁻¹ for RR120 dye. Leakage/hydrolysis of reactive red 120 from an agarose support (e.g. at pH 2 or 12) can also be conveniently determined at very low levels (sub-μg ml⁻¹) by means of cathodic stripping voltammetry, which involves adsorptive accumulation of the dye onto the hanging mercury-drop electrode.