A study of peralkylated derivatives of bis(η6-benzene)chromium by gas-phase electronic absorption spectroscopy

The gas-phase electronic absorption spectra of (⁶-C₆R₆)₂Cr (R = Me (1) and Et (2)) reveal Rydberg structures, which disappear on going to the condensed phase. Each spectrum shows a Rydberg series converging to the ionization threshold. The first ionization potential determined as the series convergence limit is 4.662±0.008 eV for 1 and 4.667±0.019 eV for 2. The Rydberg bands are due to the transitions from the non-bonding MO 3d_z2 to the R4s and Rnp (n = 4—10) levels. The influence of methyl and ethyl substituents on the term values of the Rydberg transitions depends on the principal quantum number of the Rydberg MO.     

Preparation and properties of composites made from rice straw and poly(vinyl chloride) (PVC)

Rice straw was employed for the preparation of lignocellulosic‐poly(vinyl chloride) (PVC) composites. The effect of pretreatment of rice straw, concentration of PVC, pressure as well as pressing temperature on the mechanical properties and water absorption was studied. Also, the effect of lignin as coupling agent on the mechanical properties and water absorption of composite was studied. Composites of rice straw comprising both PVC and a coupling agent offer superior properties compared to those made from only rice straw and PVC. The extent of improvement in the mechanical properties and dimensional stability of composites depended not only on the pretreatment of rice straw, concentration of PVC and lignin but also on pressure and pressing temperature. Copyright © 2004 John Wiley & Sons, Ltd.     

流动注射在线共沉淀预富集火焰原子吸收法测定痕量铜

研究了以Ｎｉ＾２＋－ＤＤＴＣ为共沉淀载体，流动注射在线共沉淀预富集－火焰原子吸收光谱法测定痕量铜的体系，在０．３ｍｏｌ．Ｌ＾－１的硝酸介质中，铜离子在编织反应器中与Ｎｉ＾２＋－ＤＤＴＣ（产生共沉淀，并被收集在编织器内壁上，用甲基异丁基酮（ＭＩＢＫ）在线洗脱沉积物并引入火争原子化器中测定。当富集时间为４０ｓ时，４０μｇ．Ｌ＾－１的铜１０次测定的相对标准偏差为３．０％，灵敏度提高６０倍，检出限（３σ）     

Sol–gel preparation and properties of hydroxypropylcellulose–titania hybrid thin films

Hydroxypropylcellulose (HPC)–titania hybrid thin films were prepared by sol–gel method where titanium tetraisopropoxide Ti(OC₃H₇ ⁱ )₄ was hydrolyzed under acidic conditions in the presence of HPC, followed by dip-coating and drying at 120 °C for 24 h. The viscosity average molecular weight of HPC was 55,000–70,000 or 110,000–150,000, and the TiO₂/(HPC + TiO₂) mass ratio ranged from 0 to 1, which was calculated on the assumption that all Ti(OC₃H₇ ⁱ )₄ is converted into TiO₂. The films were 0.35–1.0 μm thick, transparent in visible region and opaque in ultraviolet (UV) region, where the optical absorption coefficient in UV region increased with increasing titania content. The refractive index increased with increasing titania content, ranging from 1.6 to 1.8 for the hybrid thin films. The pencil hardness increased from 6B to 5H, the durability in hot water significantly increased and the contact angle of water on films increased from 35° to 89° with increasing titania content. Crack-free films could be deposited on organic polymer substrates irrespective of titania or HPC contents, where cracking did not occur at higher HPC contents even when the substrate was bent.     

A new approach for fluorine determination by solid sampling graphite furnace molecular absorption spectrometry

This work deals with the determination of fluorine by solid sampling graphite furnace molecular absorption spectrometry. The molecular absorbance of aluminum monofluoride (AlF), which is produced in the vapor phase in the presence of Al³⁺, is measured at 227.5 nm, a non-resonant platinum line. A conventional graphite furnace program has been used with pyrolysis and vaporization temperatures of 800 and 2300 °C, respectively. Solutions of Ba²⁺ and Al³⁺ have been used to avoid fluorine losses during the pyrolysis stage and to produce AlF in the vaporization stage, respectively. Certified coal and alumina samples were analyzed using aqueous standards for calibration. The agreement between the found concentration and the certified value, or the value obtained by another method ranged from 92 to 105%, with a relative standard deviation less than 8.5%. The limit of detection and the characteristic mass was 0.17 μg g^− 1 and 205 pg, respectively.     

Hydrogen peroxide in basic media for whole blood sample dissolution for determination of its lead content by electrothermal atomization atomic absorption spectrometry

Hydrogen peroxide in basic media is proposed as a means for dissolving whole blood samples to be analyzed by electrothermal atomization atomic absorption spectrometry, ET AAS. Approximately 2 g of the whole blood sample were directly weighed in a 150 mL volumetric flask; 3 mL of a NaOH 0.2 mol L⁻¹ solution, two drops of 1-octanol, as an antifoaming agent, and 1 mL of 30% volume hydrogen peroxide were added to the flask to promote oxidation. The solution was then manually shaken and after approximately three minutes of shaking, a clear solution, with no apparent suspended solids or greasy layers, was obtained. Distilled-deionized water was used to complete the volume. Ten μL of the resulting solution along with 10 μL of a solution containing 5000 mg L⁻¹ of NH₄H₂PO₄ and 300 mg L⁻¹ of Mg(NO₃)₂ as a modifier, were injected into transversely heated graphite tubes for lead determination. Both aqueous standards and standard addition calibration curves produced results not significantly different at a 95% confidence limit level. Accuracy of the measurements was assessed by analysis of the IAEA A-13 (concentration of trace and minor elements in freeze dried animal blood) standard reference material containing 0.18 mg L⁻¹ lead on a dry basis and by means of recovery tests. Analysis of the IAEA A-13 standard produced 0.17 ± 0.02 mg L⁻¹ lead on a dry basis; recovery tests afforded values from 95 to 105%. Ten consecutive measurements of a 5 ppb lead solution gave a characteristic mass of 47.2 pg and a (3S) detection limit of 1.77 μg L⁻¹ Pb. Results obtained from analysis of whole blood samples of volunteer donors covered a lead concentration range between 8 and 21 μg L⁻¹ with a mean value of 11.9 ± 4.7 μg L⁻¹.     

Study of metal-loaded activated charcoals for the separation and determination of selenium species by energy dispersive X-ray fluorescence analysis

Conversion of adsorption properties of activated charcoal (C^∗) by metal modification towards selenite, selenate and seleno-dl-methionine (Se-Met) was studied. Several metals were included in modification studies and also a procedure was developed for the separation and independent determination of microgram quantities of these selenium species in aqueous solution. Selenium species were collected one by one from the same sample solution onto collector material by adsorbing them directly or after complex formation onto different metal-loaded activated charcoals (MgC^∗ and FeC^∗). The mass of selenium in these collectors was measured directly by energy dispersive X-ray fluorescence spectrometry (EDXRF). Detection limits for all three selenium species were better than 6 μg corresponding to concentration of 60 μg/l with 0.100 l of initial sample volume.     

Physico-Chemistry of the Limestone Sulphation Process

Aspects of the mechanism of the overall reaction between CaCO₃/CaO and SO₂/SO₃ under oxidizing conditions are discussed. The limestone and lime sulphation processes were carried out in a thermobalance under conditions relevant to atmospheric fluidized bed combustion. Sulphated samples, prepared in the form of cross-section particles, were examined in a scanning electron microscope by energy-dispersive X-ray and back-scattered electron imaging. Photomicrographs are presented. The reaction proceeded from the outer surface of the particles and along the pores. Surface textural changes during the reaction were considered. The layer of products was identified as controlling both the rate and extent of limestone/lime sulphation. In the products, two sulphur-bearing solids (CaSO₄ and CaS) were identified. The presence of CaS, which may cause difficulties in practice, is attributed to CaSO₃ disproportionation. This revised version was published online in August 2006 with corrections to the Cover Date.     

Determination of manganese in brain samples by slurry sampling graphite furnace atomic absorption spectrometry

A simple procedure for the determination of manganese in different sections of human brain samples by graphite furnace atomic absorption spectrometry has been developed. Brain sections included cerebellum, hypothalamus, frontal cortex, vermix and encephalic trunk. Two sample preparation procedures were evaluated, namely, slurry sampling and microwave-assisted acid digestion. Brain slurries (2% w/v) could be prepared in distilled, de-ionized water, with good stability for up to 30 min. Brain samples were also digested in a domestic microwave oven using 5 ml of concentrated HNO₃. A mixed palladium+magnesium nitrate chemical modifier was used for thermal stabilization of the analyte in the electrothermal atomizer up to pyrolysis temperatures of 1300 °C, irrespective of the matrix. Quantitation of manganese was conducted in both cases by means of aqueous standards calibration. The detection limits were 0.3 and 0.4 ng ml⁻¹ for the slurry and the digested samples, respectively. The accuracy of the procedure was checked by comparing the results obtained in the analysis of slurries and digested brain samples, and by analysis of the NIST Bovine Liver standard reference material (SRM 1577a). The ease of slurry preparation, together with the conventional set of analytical and instrumental conditions selected for the determination of manganese make such methodology suitable for routine clinical applications.     

The Reaction of Maleic and Phthalic Anhydrides with 2-Methylimidazole

The reaction of maleic anhydride with 2-methylimidazole in acetonitrile and DMF is accompanied by the appearance of strong absorption bands in the visible part of the spectrum due to the formation of molecular complexes. In acetonitrile the reaction proceeds by two routes via the formation of an amide and the molecular complex. Phthalic anhydride reacts with 2-methylimidazole to give amide but not to form molecular complexes.