铁粉为原料催化改性铁氧化物的储氢性能

以Fe粉为原料, 以金属Mo, Al和Ni可溶性盐作为添加剂, 通过浸渍法制备单金属添加和双金属添加的改性铁氧化物储氢材料Fe-Mo, Fe-Al, Fe-Mo-Ni和Fe-Mo-Al, 并研究了它们的储氢性能. 结果表明样品Fe-Mo改性效果最好: 如放氢温度由改性前的500 ℃降至改性后的290 ℃左右; 300 ℃时放氢速率最高, 由改性前的低于50 μmol•min^－1• Fe-g^－1到改性后的325 μmol•min^－1•Fe-g^－1 (10次平均); 4.53 wt%的平均实验储氢量与理论值4.8 wt%较接近; 储-放氢循环稳定性随着循环次数的增加呈逐渐增加的趋势. SEM微观结构和BET比表面积分析表明添加剂的种类对样品的改性作用更重要.     

Photocatalytic decolorization of methyl orange solution with potassium peroxydisulfate

Increasing environmental pollution caused by toxic dyes due to their hazardous nature is a matter of great concern. It has been generally agreed that methyl orange (MO) can be effectively degraded in aerated K₂S₂O₈ homogeneous reaction system using near-UV irradiation. In this paper photocatalytic degradation of MO solutions with K₂S₂O₈ was investigated, with particular attention on the possible underlying mechanisms. This report has shown decolorization efficiency of MO increases with the increasing of the dosage of the catalyst. There is no optimal amount of catalyst in our case, where special attention was paid on the nature of the photocatalyst itself. The current research revealed that the decolorization reaction is a pseudo first-order reaction when the concentration of MO is below 20 mg L⁻¹ and the decolorization reaction is zero-order reaction when the concentration of MO is above 100 mg L⁻¹, but the Langmuir-Hinshewood kinetic model does not describe this. The influence of IO₄⁻, BrO₃⁻ and H₂O₂ were investigated in detailed. Several observations indicate that the mechanism is not involved in hydroxyl radical attacks in MO degradation with K₂S₂O₈ by UV irradiation. The possible underlying mechanisms are direct oxidation of the MO by S₂O₈²⁻ and hydrogen attraction by SO₄^•−.      

新型添加剂全氟辛酸铵对提高锂离子电池安全性能的研究

报导可显著提高锂离子电池安全性的新型电解液添加剂全氟辛酸铵(APC). UL 94 可燃性试验显示添加0.70 wt% APC能使有机电解液的火焰传播速率下降33%. 差示扫描量热法(DSC)测试表明APC显著减弱了嵌锂碳电极和电解液之间的放热反应, 并将其热不稳定温度由138.0 ℃提高到167.5 ℃. 交流阻抗检测显示APC的加入明显降低了碳材料电极的界面阻抗, 并且提高了在储存过程中其固态电解质界面(SEI)层的稳定性. 添加APC还能有效地提高Li/MCMB电池充放电循环性能和库仑效率.     

过充保护添加剂1,2-二甲氧基-4-硝基苯和1,4-二甲氧基-2-硝基苯在锂离子电池中的应用

在锂离子电池电解液1 mol·L^-1 LiPF₆/(碳酸乙烯酯(EC)+碳酸二乙酯(DEC)+碳酸甲乙酯(EMC) (1:1:1,体积比))中分别添加1,2-二甲氧基-4-硝基苯(DMNB1)和1,4-二甲氧基-2-硝基苯(DMNB2)作为防过充添加剂.采用循环伏安(CV)、恒流充放电、过充测试、电化学阻抗谱(EIS)、扫描电子显微镜(SEM)等手段研究了DMNB1和DMNB2 的防过充效果, 以及添加剂与LiNi_1/3Co_1/3Mn_1/3O₂材料的相容性. 结果表明: DMNB1 和DMNB2 的氧化电位都在4.3 V (vs Li/Li⁺)以上, 且均能显著提高电池的过充保护性能. 100%过充和5 V截止电压过充测试表明, DMNB1 的防过充性能优于DMNB2. 采用基础电解液、添加0.1 mol·L^-1 DMNB1 和添加0.1 mol·L^-1DMNB2 电解液的LiNi_1/3Co_1/3Mn_1/3O₂/Li 电池, 0.2C 倍率下循环100 次, 容量保持率分别为98.4%、95.9%和68.1%. 证明硝基在添加剂苯环上的取代位置和其电化学性能之间有着密切联系.     

链接基团对固载手性Salen Mn(m)催化不对称环氧化反应的影响

制备了二胺和二酚修饰的晶态有机聚合物-无机杂化载体低聚苯乙烯基膦酸-膦酸氢锆(LCZSPP)轴向固载手性Salen Mn(Ⅲ)催化剂,将其应用于非官能烯烃的多相不对称环氧化反应.研究了两类轴向连接基团及助催化剂在催化不对称环氧化反应中的影响.结果表明,通过二胺为链接基团固载的催化剂在加入轴向助剂(NMO)的情况下,转化...     

A hierarchical porous carbon membrane from polyacrylonitrile/polyvinylpyrrolidone blending membranes:Preparation,characterization and electrochemical capacitive performance

Novel hierarchical porous carbon membranes were fabricated through a simple carbonization procedure of well-defined blending polymer membrane precursors containing the source of carbon polyacrylonitrile （PAN） and an additive of polyvinylpyrrolidone （PVP）, which was prepared using phase inversion method. The as-fabricated materials were further used as the active electrode materials for supercapacitors. The effects of PVP concentration in the casting solution on structure feature and electrochemical capacitive performance of the as-prepared carbon membranes were also studied in detail. As the electrode material for supercapacitor, a high specific capacitance of 278.0 F/g could be attained at a current of 5 mA/cm2 and about 92.90% capacity retention could be maintained after 2000 charge/discharge cycles in 2 mol/L KOH solution with a PVP concentration of 0.3 wt% in the casting solution. The facile hierarchical pore structure preparation method and the good electrochemical capacitive performance make the prepared carbon membrane particularly promising for use in supercapacitor.     

氢化物发生–原子荧光光度法测定食品和食品添加剂中的砷、汞和铅

建立氢化物发生–原子荧光光度法测定食品和食品添加剂中砷、汞和铅元素的方法。对茶叶、方便面、精料与二氧化硅样品的前处理方法进行了研究,讨论了酸介质与酸度、还原剂浓度、铁氰化钾与草酸浓度等因素对样品测定的影响。当还原剂质量浓度为20 g/L、载流酸度为5%、铁氰化钾和草酸质量浓度分别为4 g/L和2 g/L时,砷、汞和铅的方法检出限分别为0.024,0.008,0.066μg/L,方法的回收率为85%~105%,测量结果的相对标准偏差分别为0.7%,0.7%,1.8%。该方法简便、快速、结果准确可靠,能满足食品和食品添加剂中砷、汞、铅的测定。     

阴离子表面活性剂聚二硫二丙烷磺酸钠的合成

利用硫化钠与硫磺反应制备二硫化钠,然后将二硫化钠与1,3-丙磺酸内酯反应,合成了一种可作为电镀添加剂的阴离子表面活性剂——聚二硫二丙烷磺酸钠(SPS)。采用核磁共振氢谱对合成产物进行结构表征,确认了产物结构及产率。通过正交试验研究了产物产率与反应物配比、反应温度、溶剂加入量等因素之间的关系,找出了最优合成条件:第一步合成二硫化钠的反应中,硫化钠/硫磺物质的量比为1∶1.3,温度55℃,加水量18 mL;第二步合成SPS的反应中,1,3-丙磺酸内酯/硫化钠物质的量比为1.7∶1,温度40℃,溶剂量75 mL,产物的最高产率可达到95.8%。     

表面修饰ZrO_2纳米微粒的结构表征及摩擦学行为研究(英文)

采用XPS,FTIR,DSC,TGA等多种现代分析手段表征了硬脂酸修饰ZrO2 纳米微粒的结构.在四球摩擦磨损试验机上,首次评价了表面修饰ZrO2 纳米微粒用作润滑油添加剂的摩擦学性能,结果表明ZrO2 纳米微粒具有良好的抗磨减摩性     

三氟乙酸修饰TiO_2纳米微粒的制备及磨擦学性能

采用化学法制备一种粒径约50nm的三氟乙酸修饰TiO2纳米微粒,并用高分辨透射电镜(HRTEM)、傅立叶红外(FTIR)和热分析(TG、DTA)、X射线粉末衍射(XRD)等手段对该纳米微粒进行了表征,用MRS 10A型四球磨擦试验机考察了该纳米微粒在液体石蜡中的磨擦学性能 结果表明:三氟乙酸修饰TiO2纳米微粒能分散于液体石蜡中且具有较好的抗磨性能,能极大地提高液体石腊的抗磨性和承载能力,降低了磨擦系数