强流四脉冲电子束源实验研究

 为了进行强流多电子束源研究，对现有2MeV LIA 注入器进行了四脉冲改造，二极管脉冲电压约500kV。实验研究了天鹅绒阴极在四脉冲条件下的发射能力、传导电流负载效应以及阴极等离子体运动对阴极电子发射和束能量的影响。利用空间电荷限制流模型推算出阴极等离子体膨胀速率在1 ~4cm/μs之间。     

静电加速管中强流空间电荷效应的研究

 对一种工业用大功率电子加速器(450kW)的加速管中的空间电荷效应作了5点假设，建立了物理模型。对模型的束内外径向电位分布、空间电荷对轴上电位的影响，以及空间电荷力对束流传输的影响等进行了理论分析，得到了束内径向电位分布。结果表明：束流内部径向电位沿径向均呈抛物线变化，并在轴上达到最小值；而空间电荷产生的束内电场与半径呈线性变化；空间电荷不仅会引起轴上电位的跌落，而且对束流有发散作用，特别是在电子速度较低时更为明显。在考虑了空间电荷效应后，强流静电加速管的电场设计关键在加速管的前端，与弱流加速管相比，强流加速管的电场变化要大得多。     

An example of applications of the elementary catastrophe theory in Hamiltonian systems

The convection in atmosphere discussed in ref. [1] is rigorously treated by considering the variation of environmental temperature with the height. This represents an example of applications of the elementary catastrophe theory in Hamiltonian systems.     

Te溶剂Bridgman法CdMnTe晶体核辐射探测器的制备和表征

碲锰镉(CdMnTe)作为性能优异的室温核辐射探测器材料,可用于环境监测和工业无损检测领域。本文中采用Te溶剂Bridgman法生长In掺杂Cd_0.9Mn_0.1Te晶体,制备成10 mm×10 mm×2 mm大小的室温单平面探测器,研究了该探测器对²⁴¹Am@59.5 keV γ射线源的能谱响应。通过表征红外透过率、电阻率以及探测器能谱响应等参数,综合评定了探测器用CdMnTe晶体的质量、电学和探测器性能。结果表明,晶片的红外透过率均在55%以上,最好可达到60%。采用湿法钝化,100 V偏压下的漏电流由钝化前的9.48 nA降为钝化后的7.90 nA,钝化后的电阻率为2.832×10¹⁰ Ω·cm。在-400 V反向偏压下,CdMnTe探测器对²⁴¹Am@59.5 keV γ射线源的能量分辨率在钝化前后分别为13.53%和12.51%,钝化后的电子迁移率寿命积为1.049×10^-3 cm²/V。研究了探测器的能量分辨率随电压的变化特性,当偏压≤400 V时,探测器的能量分辨率主要由载流子的收集效率决定,而当偏压>400 V时,能量分辨率由漏电流决定。本文研究结果表明,Te溶剂Bridgman法生长的CdMnTe晶体质量较好,电阻率和电子迁移率寿命积满足探测器制备需求。     

Cu3N薄膜及其研究现状

Cu3N薄膜是近10年来研究的热点材料之一.Cu3N是立方反ReO3结构,理想立方反ReO3结构的一个晶胞中Cu原子占据立方边的中心位置而N原子占据立方晶胞的八个顶点,此结构的体心位置有一较大间隙,Cu原子以及其他原子如Pd、碱金属原子等很有可能进入此位置导致Cu3N的电学性能、光学性能等发生很大的变化,这使得该材料具有很大的潜在应用价值.Cu3N的晶格常数为0.3815nm,密度5.84g/cm3,分子量204.63,颜色呈黑绿色或红褐色,空间点群Pm3m.Cu3N薄膜在室温下相当稳定并且热分解温度较低(300℃左右),热分解前后薄膜的光学反射率有较大差别,这可使Cu3N薄膜用作一次性光记录材料.此外,Cu3N薄膜还可用作在Si片上沉积金属Cu线的缓冲层、低磁阻隧道结的阻挡层、自组装材料的模板等.     

Pyrene分子(小片石墨晶体)的电子传导特性

利用量子理论中基于Green函数的tight-binding方法,对pyrene分子的电子传导和电子流分布进行了理论研究。在考虑到界面耦合和Hopping积分的情况下,得出了电子透射谱和流分布的模拟结果。结果显示透射与电子的能量紧密相关;谱的振荡特征是能级量子化的结果;流分布有着特定的方向,并且在每一个原子点上符合Kirchhoff量子流守恒定律。另外还发现了桥接pyrene分子的正负能开关特性。     

迭代法分析圆环类微带行波天线的辐射特性

利用圆环类微带行波天线的辐射功率与等效行波磁流衰减常数之间的自洽关系,导出了计算衰减常数的迭代方程;为加快迭代速度,将辐射积分中的格林函数展开成柱面波函数,得到快速收敛的级数和.最后给出了方向图的计算曲线,与实验结果对比吻合良好,表明此方法模拟圆环类微带行波天线辐射特性的有效性.     

Spin Transport in a Rashba Ring-Quantum Dot System Pumped by Microwave Fields

We report a theoretical study on producing electrically spin-polarized current in the Rashba ring with parallel double dots embedded, which are subject to two time-dependent microwave fields. By means of the Keldysh Green's function method, we present an analytic result of the pumped current at adiabatic limit and demonstrate that the interplay between the quantum pumping effectand spin-dependent quantum interference can lead to an arbitrarily controllable spin-polarized current in the device. The magnitude and direction of the charge and spin current can be effectively modulated by system parameters such as the pumping phase difference, Rashba precession phase, and the dynamic phase difference of electron traveling in two arms of ring; moreover, thespin-polarization degree of the charge current can also be tuned in the range [-∞, +∞]. Our findings may shed light on the all-electric way to produce the controllable spin-polarized charge current in the field of spintronics.     

一个新的IEC61000-4-2标准ESD电流解析表达式

分析了两个ESD标准电流波形表达式,并提出一个新的基于脉冲函数来描述ESD标准电流的解析表达式,该表达式符合最新的标准IEC61000-4-2,在零时刻的电流及其微分部为0,且波形与实际测量波形基本吻合。     

Structural characteristics and residual stresses in oxide films produced on Ti by pulsed unipolar plasma electrolytic oxidation

Oxide films, 7–10 µm thick, were produced on commercially pure titanium by plasma electrolytic oxidation in a sodium orthophosphate electrolyte using a pulsed unipolar current with frequency (f) and duty cycle (δ) varying within f = 0.1–10 kHz and δ = 0.8–0.2, respectively. The coatings comprised a mixture of an amorphous phase with nanocrystalline anatase and rutile phases, where the relative rutile content range was 17–25 wt%. Incorporation of phosphorus from the electrolyte into the coating in the form of PO₂ ^–, PO₃ ^2– and PO₄ ^3–, as demonstrated by EDX and FT-IR analyses, contributed to the formation of the amorphous phase. Residual stresses associated with the crystalline coating phase constituents were evaluated using the X-ray diffraction sin² ψ method. It was found that, depending on the treatment parameters, internal direct and shear stresses in anatase ranged from–205 (±17) to–431 (±27) MPa and from–98 (±6) to–145 (±10) MPa, respectively, whereas the rutile structure is comparatively stress-free.