四能级原子系统中量子相干增强的Kerr非线性效应的研究

应用密度矩阵方程计算了四能级原子系统中三阶非线性极化率随信号光和探针光频率失谐的变化关系。结果表明，由于量子干涉对信号光强度的敏感性，使四能级原子介质的交叉Kerr非线性作用大大增强，与三能级系统相比，四能级原子介质的Kerr非线性系数可增强两个数量级。     

Scaling impacted structures

Summary The problem of non-scalability of structures under impact loads caused by strain-rate effects is solved in this article by properly correcting the impact velocity. The technique relies on the use of an alternative dimensionless basis, together with a mathematical model which allows the calculation of a correction factor for the impact velocity. This new velocity, when applied to the model, makes it to assure the satisfaction of the scaling laws. The indirect similitude method detailed here is applied to two strain-rate sensitive structures, a double plate under in-plane impact and a beam subjected to a blast load. The results show a very good agreement so that the model and a prototype made from strain rate sensitive materials behave the same.accepted for publication 3 March 2004     

Aharonov–Bohm oscillations observed in nanoscale open-dot structures fabricated in an InAs surface inversion layer

We fabricated nanoscale open-dot structures in an InAs surface inversion layer using an atomic-force-microscope oxidation process. Due to its superior nanofabrication capability, small open-dot structures with the feature size ranging between 100 and 300 nm were successfully fabricated. The magnetoresistance signal measured at 4.2 K showed reproducible fluctuations and a periodic oscillation component that varies in both amplitude and periodicity depending on the dot size. We show that the period of the oscillations corresponds to that of the Aharonov–Bohm effect and propose that the possible mechanism for the oscillations is due to the formation of a one-dimensional electron channel enclosing the open-dot structure as a result of the electron transfer from the InAs oxide to InAs.     

Quantum Hall effect in back-gated InAs/GaSb heterostructures under a tilted magnetic field

We investigate the quantum Hall effect (QHE) in the InAs/GaSb hybridized electron–hole system grown on a conductive InAs substrate which act as a back-gate. In these samples, the electron density is constant and the hole density is controlled by the gate-voltage. Under a magnetic field perpendicular to the sample plane, the QHE appears along integer Landau-level (LL) filling factors of the net-carriers, where the net-carrier density is the difference between the electron and hole densities. In addition, longitudinal resistance maxima corresponding to the crossing of the extended states of the original electron and hole LLs make the QHE regions along integer-ν_net discontinuous. Under tilted magnetic fields, these R_xx maxima disappear in the high magnetic field region. The results show that the in-plane magnetic field component enhances the electron–hole hybridization and the formation of minigaps at LL crossings.     

Anomalies in the Absorption and Reflection of a High-Power Ultrashort Laser Pulse by a Plasma with a Solid-State Density

The patterns of absorption and reflection of an ultrashort laser pulse by a plasma with a solid-state density, which are realized in the mode of the normal skin effect, are studied. It is shown that a decrease in low-power pulse duration shorter than the period corresponding to the fundamental frequency of radiation leads to an increase in the absorption coefficient. If the pulse power is so high as to provide electron heating during a time shorter than the reciprocal fundamental frequency, nonlinear suppression of absorption takes place and the spectrum of the reflected radiation contains odd harmonics of the fundamental frequency.     

Electrode “edge effects” analyzed by the Green function method

An exact method based on Green's equation is used to find the diffusion-controlled faradaic current for certain electrode geometries that incorporate edges and vertices. Thereby the magnitudes of the time-independent current density associated with angled electrode/electrode and electrode/insulator junctions are calculated. As well, the square-root-of-time-dependent currents associated with vertices, receive attention. These terms extend to longer times, the Cottrell formulation appropriate for short times. Though most of the problems solved here have been tackled previously, the novel Green function approach is shown to be straightforward and intuitive.     

Synthesis of MgAl2O4 Spinel Nanometer Powder via Biology Polysaccharide Assisted Sol-Gel Process

A novel and cost-effective sol-gel process for preparation of MgAl₂O₄ spinel nanometer powders has been developed in this study. A solution of magnesium and aluminum nitrates in stoichiometric proportion was successfully embraced in the biology polysaccharide gel network, formed by the synergistic interaction between xanthan gum (XG) and locust bean gum (LBG) utilizing their broad-spectrum stability of salt tolerance and character of transformation from sol to gel on the condition of proper temperature and relative proportion of polymeric components. Dry gel could be obtained by vacuum dehydration of aqueous gel at low temperatures. Monolithic MgAl₂O₄ spinel nanometer powders were produced by calcining the dry gel above 800°C, with average crystallite size of 20 nanometers.     

激光在医学中的应用

激光在医学领域的应用非常广泛，本文主要介绍了激光诊断和激光治疗的几个重要应用。     

Cosmological Particle Creation and Dynamical Casimir Effect

We compute particle creation for a real massive scalar field conformally coupled to a spatially closed Robertson–Walker space-time background, with time-dependent scale factor. This is a dynamical Casimir effect with moving boundaries.     

Nonequilibrium Statistical Thermodynamics of Two Dissipative Processes in Solids: Energy Losses of Channeled Particles at Low Velocities and Ultrasound Absorption by Conduction Electrons

We use methods of nonequilibrium statistical thermodynamics to investigate two dissipative processes in solids. We find the electron energy losses of a particle moving in a planar channeling regime and the sound absorption coefficient in metals under electron impurity scattering. The oscillator model is used to analyze the contribution from the effect of electron entrainment by a moving scattering center to the total dissipated energy. We investigate the frequency and temperature dependence of energy losses and also the dependence of the absorption coefficient on the sound wave vector.