Elastic friction drive of surface acoustic wave motor

Importance of elastic deformation control to obtain large output force with a surface acoustic wave (SAW) motor is discussed in this paper. By adding pre-load to slider, stator and slider surfaces are deformed in a few tens nanometer. Appropriate deformation in normal direction against normal vibration displacement amplitude of SAW existed. By moderate deformation, the output force of the SAW motor was enlarged up to about 10 N and no-load speed was 0.7 m/s. To produce this performance, the transducer weight and slider size were only 4.2 g and 4 x 4 mm(2).By traveling wave propagation, surface particles of the SAW device move in elliptical motion. Due to the amplitude of the elliptical motion is 10 or 20 nm order, the contact condition of the slider is very critical. To control the contact condition, namely, the elastic deformation of the slider and stator surface in nanometer order, a lot of projections were fabricated on the slider surface. The projection diameter was 20 micro m. In static condition, the elastic deformation and stress were evaluated with the FEM analysis. From this calculation and the simulation result, it is consider that the wave crest is distorted, hence the elasticity has influence on the friction drive condition.Elastic deformation of the stator surface beneath the projection from the initial position were evaluated. In 4 x 4 mm(2) square area, the sliders had from 1089 to 23,409 projections. Depression was independent to the contact pressure. However, the output force depended on the depression although the projection density were different. From the view point of the output power of the motor, the proper depression was independent to the projection density. Around 25 nm depression, the output force and output power were maximized. This depression value was almost same as the vibration displacement amplitude of the stator transducer.     

Propagation of Bleustein-Gulyaev waves in a prestressed layered piezoelectric structure

Based on the theories of nonlinear continuum mechanics, piezoelectricity and elastic waves in solids, theoretical analysis of Bleustein-Gulyaev surface acoustic wave propagation in a prestressed layered piezoelectric structure are described. Numerical calculations are performed for the case that the layer and the substrate are identical LiNbO(3) except that they are polarized in opposite directions. It is found that an almost linear behavior of the relative change in phase velocity versus the initial stress is obtained for both surface electrically free and shorted cases. Potential applications in the design of acoustic wave devices are suggested.     

Operator kernel estimates for functions of generalized Schrödinger operators

We study the decay at large distances of operator kernels of functions of generalized Schrödinger operators, a class of semibounded second order partial differential operators of mathematical physics, which includes the Schrödinger operator, the magnetic Schrödinger operator, and the classical wave operators (i.e., acoustic operator, Maxwell operator, and other second order partial differential operators associated with classical wave equations). We derive an improved Combes-Thomas estimate, obtaining an explicit lower bound on the rate of exponential decay of the operator kernel of the resolvent. We prove that for slowly decreasing smooth functions the operator kernels decay faster than any polynomial.

     

声波导中的局部正交变换

In this paper, a local orthogonal transformation is created to transform the Helmholtz waveguide with curved interface to the one with a flat interface within the two-layer medium, and the Helmholtz equation uxx uzz k^2(x,z)u=0 is transformed to Vxx αVzz βVz γV=0. Numerical results demonstrate that the transformation is more feasible. This transformation is particularly useful for the research on wave propagation in acoustic waveguide.     

应用相敏光放大器的非零色散位移光纤通信系统中的ISI限制距离研究

本文分析了1.55μm信号波长,采用强度调制/直接检测(IM/DD)方式的单信道级联相敏光放大器(PSA)非零色散位移光纤传输系统的性能.应用非线性薛定谔方程(NLSE),通过对信号传输后眼图劣化度的计算,得到了光纤传输系统的码间干扰(ISI)限制距离.由于PSA的相敏特性,其对光纤色散具有一定的补偿作用,因此级联相敏光放大器光纤通信系统可以实现信号高比特率长距离传输.然而,随着信号速率的提高,对长距离传输,必须减小光纤色散值和PSA的间距.当光纤色散值大到一定程度,要进行信号的高速率传输,就必须附加其它的色散补偿方法.     

天光一号预放大器电子束产生和传输

 论述了天光一号电子束泵浦KrF准分子激光预放大器电子束产生和传输系统的研制。针对低电压(400kV)和高电流密度(143Acm^-2),重点考虑了二极管真空绝缘界面、电极结构、漂移区长度和主膜支撑等问题并介绍了实验结果：二极管电压在450 kV以上仍能稳定工作,电流上升前沿约20ns,电子束总束能4.2kJ以上。只要开关导通时间选在PFL电压峰值附近,Marx 建立时间抖动小于20 ns,对总束能的影响将小于5%。     

Ternary eutectic growth of Ag-Cu-Sb alloy within ultrasonic field

The liquid to solid transformation of ternary Ag42.4Cu21.6Sb36 eutectic alloy was accomplished in an ultrasonic field with a frequency of 35 kHz, and the growth mechanism of this ternary eutectic was examined. Theoretical calculations predict that the sound intensity in the liquid phase at the solidification interface increases gradually as the interface moves up from the sample bottom to its top. The growth mode of (ε θ Sb) ternary eutectic exhibits a transition of "divorced eutectic- mixture of anomalous and regular structures-regular eutectic" along the sample axis due to the inhomogeneity of sound field distribution. In the top zone with the highest sound intensity, the cavitation effect promotes the three eutectic phases to nucleate independently, while the acoustic streaming efficiently suppresses the coupled growth of eutectic phases. In the meantime, the ultrasonic field accelerates the solute transportation at the solid-liquid interface, which reduces the solute solubility of eutectic phases.     

激光清洗实时监测技术研究

针对目前在研激光清洗的实时监测问题进行实验和分析。得出两个结论:激光清洗具有传统方法无法具有的优越性,可以节省大量人力物力成为新型清洗方法而受到重视,激光清洗在设备维修保养中显示了良好的应用前景。激光清洗过程中产生的声发射信号包含了清洗过程的大量信息,利用声发射检测系统可以对激光清洗过程实时监控。     

光束旋转90°多程放大系统的波前误差校正

光束通过神光-Ⅲ原型装置四程放大系统发生了90°旋转和扩束。在四程放大系统腔镜处放置变形镜校正系统像差是一种新的自适应光学方案，推导出被校正像差与变形镜面形之间的数学关系。理论推导表明，在扩束比大于1的前提下，腔镜处变形镜可以校正系统输出的任意类型的像差，且变形镜对应的面形唯一。理论分析和计算仿真说明该方案的校正能力与像差类型和扩束比有关，扩束比增大将增强变形镜校正像散的能力，但系统旋光消像散的能力也将减弱。     

直接扣除法测量半导体光放大器频率响应

在光电子器件散射参量定义的基础上建立了基于直接扣除法的半导体光放大器频率响应测量系统,测量中通过扣除激光器和探测器系统的频率响应,得到放大器固有的频率响应。对InGaAsP体材料行波腔半导体光放大器样品进行了测量,得到了放大器在不同注入光功率和不同偏置电流下的频率响应曲线。这些曲线很好地反应了半导体光放大器的增益饱和和噪声特性,进一步分析发现半导体光放大器对低频调制信号的放大能力弱于对高频信号的放大能力,分析认为其原因在于半导体光放大器的载流子寿命有限导致低频信号长时间消耗载流子时,载流子数量无法及时恢复,从而使得增益降低。