Miniaturized molecularly imprinted polymer extraction method for the gas chromatographic analysis of flavonoids

In this study, the use of monolithic molecularly imprinted polymers in a micropipette tip format allowing the simple and fast extraction of flavonoids from standard solutions and a black tea sample is demonstrated. The imprinted polymer employed quercetin, methacrylic acid or 4‐vinylpyridine, and ethylene glycol dimethacrylate as template, functional monomer, and cross‐linker, respectively. Surface morphologies of the quercetin‐imprinted polymers and the corresponding nonimprinted polymers were characterized by SEM. Extraction of flavonoid standards was performed to evaluate the selectivity and recovery with these imprinted and nonimprinted polymers. Flavonoid compositions in aliquots eluted from the tips were identified using fast GC with flame ionization detection. Maximum specific capacities of 0.2, 5.7, and 16.0 mg/g for catechin, morin, and quercetin, respectively, were obtained with the imprinted polymer prepared with methacrylic acid, with the corresponding recoveries of 99.8, 98.8, and 95.4%, respectively. Efficient extraction by the quercetin‐imprinted polymer of epicatechin, catechin, and quercetin from an apple‐flavored black tea sample was achieved, with GC–MS employed for compound identification for both the tea and extracted samples.     

热力学数据对1, 3-丁二烯燃烧特性的影响

基于G4方法, 计算了1,^{3-丁二烯框架燃烧反应机理中102个物种的热力学数据, 并考察了振动非谐性、 频率校正因子以及受阻内转动对结果的影响. 结果表明, 考虑振动非谐性或采用不同的频率校正因子, 对热力学数据的影响不大; 考虑内转动后, 对热力学数据有较大影响. 而且考虑内转动后, 得到的热力学数据与实验热力学数据吻合得更好. 用所得热力学数据模拟了1,3-丁二烯的绝热燃烧温度以及点火延迟时间, 结果显示, 要得到可靠的绝热火焰温度, 对小分子(如CO和CO₂等)的热力学数据需要采用实验结果. 将用所得热力学数据模拟得到的点火延迟时间, 与机理本身的热力学数据所得点火延迟时间进行对比, 二者差别显著, 表明所得热力学数据主要通过改变一些反应的逆反应速率常数来影响点火延迟时间. 进一步确定了用所得热力学数据对点火延迟时间有显著影响的一些物种.}     

Optimization of Vacuum-Microwave-Assisted Extraction of Natural Polyphenols and Flavonoids from Raw Solid Waste of the Orange Juice Producing Industry at Industrial Scale

Orange pomace (OP) is a solid waste produced in bulk as a byproduct of the orange juice industry and accounts for approximately 50% of the quantity of the fruits processed into juice. In numerous literature references there is information about diverse uses of orange pomace for the production of high-added-value products including production of natural antioxidant and antimicrobial extracts rich in polyphenols and flavonoids which can substitute the hazardous chemical antioxidants/antimicrobials used in agro-food and cosmetics sectors. In this work and for the first time, according to our knowledge, the eco-friendly aqueous vacuum microwave assisted extraction of orange pomace was investigated and optimized at real industrial scale in order to produce aqueous antioxidant/antimicrobial extracts. A Response Surface Optimization methodology with a multipoint historical data experimental design was employed to obtain the optimal values of the process parameters in order to achieve the maximum rates of extraction of OP total polyphenols and/or total flavonoids for economically optimum production at industrial scale. The three factors used for the optimization were: (a) microwave power (b) water to raw pomace ratio and (c) extraction time. Moreover, the effectiveness and statistical soundness of the derived cubic polynomial predictive models were verified by ANOVA.     

过渡态理论在化学体系中的2个应用实例*

在大学本科一二年级的物理化学教学中,化学动力学章节的学习涉及到对不同时间尺度的认识。本文利用过渡态理论得到的速率常数表达公式,以乙烷分子碳/碳单键旋转和水分子氢键交换的动力学过程为例,对这2个应用实例的动力学过程所发生的时间尺度做出估算。这些时间尺度的估算对于学生理解不同动力学过程的物理图像至关重要,同时也有助于加强学生对重要公式的理解并能够将这些公式在化学体系中灵活运用。     

无溶剂法大量制备高效红光碳点及其在白光器件中的应用

以邻苯二胺、 2,5-二氨基苯磺酸和三氯化铝为原料, 通过无溶剂法大量制备了高效的红色荧光碳点 (R-CDs). 制得的碳点尺寸大约为2.4 nm, 含有13%的氮元素, 主要由高度石墨化的碳核及覆盖在其表面的大量官能团构成. 在不同的波长光激发下, 碳点在乙醇溶液中表现出不依赖于激发的红光发射, 其荧光峰位于 704 nm, 最大量子产率达到22%. 由于R-CDs具有优异的光学性质, 利用其构筑了紫外光激发的碳基白色发光二极管, 其色坐标为(0.33, 0.33), 非常接近自然光. 该研究为高效红色荧光碳点的大量制备提供了一种新路径, 同时拓宽了其在白光器件中的应用.     

Batch versus Flow Photochemistry: A Revealing Comparison of Yield and Productivity

The use of flow photochemistry and its apparent superiority over batch has been reported by a number of groups in recent years. To rigorously determine whether flow does indeed have an advantage over batch, a broad range of synthetic photochemical transformations were optimized in both reactor modes and their yields and productivities compared. Surprisingly, yields were essentially identical in all comparative cases. Even more revealing was the observation that the productivity of flow reactors varied very little to that of their batch counterparts when the key reaction parameters were matched. Those with a single layer of fluorinated ethylene propylene (FEP) had an average productivity 20 % lower than that of batch, whereas three‐layer reactors were 20 % more productive. Finally, the utility of flow chemistry was demonstrated in the scale‐up of the ring‐opening reaction of a potentially explosive [1.1.1] propellane with butane‐2,3‐dione.     

Determination of the Absolute Configuration of Perylene Quinone‐Derived Mycotoxins by Measurement and Calculation of Electronic Circular Dichroism Spectra and Specific Rotations

Altertoxins I–III, alterlosins I and II, alteichin (alterperylenol), stemphyltoxins I–IV, stemphyperylenol, stemphytriol, 7‐epi‐8‐hydroxyaltertoxin I, and 6‐epi‐stemphytriol are mycotoxins derived from perylene quinone, for which the absolute configuration was not known. Electronic circular dichroism (ECD) spectra were calculated for these compounds and compared with measured spectra of altertoxins I–III, alteichin, and stemphyltoxin III and with reported Cotton effects. Specific rotations were calculated and compared with reported specific rotations. The absolute configuration of all the toxins, except for stemphyltoxin IV, could thus be determined. The validity of the assignment was high whenever reported ECD data were available for comparison, and the validity was lower when the assignment was based only on the comparison of calculated and reported specific rotations. ECD spectra are intrinsically different for toxins with a biphenyl substructure and for toxins derived from dihydroanthracene.     

金属标记结合高效液相色谱-选择离子监测质谱的蛋白质绝对定量新方法

建立了金属标记结合高效液相色谱-选择性离子监测质谱(SIM)的蛋白质绝对定量新方法。实验考察了金属标记效率、金属标记的稳定性、标记后肽段的色谱保留和质谱行为、新定量方法的线性范围和准确度。实验结果表明金属标记具有标记效率高,稳定性好,色谱保留行为一致等优点。另外,金属标记-选择离子监测质谱绝对定量方法灵敏度高,其定量限低至1 fmol,线性范围为1~500 fmol,线性范围内R2值大于0.99,具有良好的线性关系;经过测量,标准肽段的回收率为117.01%,说明该方法具有较高的准确度。将该方法应用于腾冲嗜热菌中烯醇酶蛋白的定量分析,相对标准偏差为5.47%,表明该方法的精密度高。以上结果表明该方法可以用于生物样本中的蛋白质的绝对定量分析,为比较简单的生物样本中蛋白质的绝对定量方法提供了一种新的选择。     

Different defect morphologies in polyethylene crystal induced by surface physicochemical properties

The physicochemical properties of surfaces have a great effect on the micro-morphologies of the crystal structures which are in contact with them.Understanding the interaction mechanism between the internal driving forces of the crystal and external inducing forces of the surfaces is the prerequisite of controlling and obtaining the desirable morphologies.In this work,the dynamic density functional theory was applied to construct the free energy functional expression of polyethylene(PE) lattice,and the micro-dynamic evolution processes of PE lattice morphology near the surfaces with different properties were observed to reveal the interaction mechanism at atomic scale.The results showed that the physical and chemical properties of the external surfaces synergistically affect the morphologies in both the defect shapes and the distribution of the defect regions.In the absence of the contact surfaces,driven by the oriented interactions among different CH2 groups,PE lattices gradually grow and form a defect-free structure.Conversely,the presence of contact surfaces leads to lattice defects in the interfacial regions,and PE lattice shows different self-healing abilities around different surfaces.     

Demystifying terms for understanding bioelectrochemical systems towards sustainable wastewater treatment

Bioelectrochemical systems (BESs) have been intensively studied in the past decade, but precise understanding of BESs performance is hindered by unclear definition of several key parameters. Herein, we analyze and discuss three sets of terms about conversion efficiency, energy performance, and pilot scale. It is suggested that ‘Coulombic recovery’ can avoid the misleading results because of different organic removals, compared with ‘Coulombic efficiency.’ Power density is not a suitable term to describe energy performance of BESs, and energy production/consumption should be reported in the energy unit such as kWh. Pilot-scale BESs should meet several criteria, including hydraulic capacity, use of actual wastewater, non-laboratory condition, and long-term operation. Proper use of those terms is strongly encouraged and will be critically important to BESs research and development.