Nitrite formation in aerated aqueous azide solutions: A radiation chemical study

Gamma radiolysis of oxygenated 1–10 mM azide solutions was carried out at various pH values. In oxygenated 10 mM azide solutions, H₂O₂ and NO ₂ ⁻ were observed as radiolytic products while NH3 was not. The concentration of H₂O₂ reached its maximum level at a dose of 1 kGy, whereas NO ₂ ⁻ yield increased non-linearly beyond 2 kGy in this system. Both in aerated and oxygenated systems, G(NO ₂ ⁻ ) and G(H₂O₂) were found to vary with N ₃ ⁻ concentration. The yield of NO ₂ ⁻ was found to be dependent on both dose rate and pH. On pulse radiolysis, NO ₂ ⁻ was found as a radiolytic product in aerated 1 mM azide solution at pH 6.8. In this system the intermediate generated exhibits absorbance around 250 nm. The overall results obtained during the present study reveal that in presence of both reducing radical (mainly e _aq ⁻ ) and oxygen, N ₃ ⁻ produced an intermediate possibly NH₂O ₂ ^• radical, which is the prime source for NO ₂ ⁻ generation.     

纳米TiO2膜用于光催化氧化测定化学需氧量的研究

A photocatalytic oxidation method for determination of chemical oxygen demand （COD） using nano-TiO2 film, based on the use of a nano-TiO2-Ce（SO4）2 system and electrochemical detection, was proposed. The technique was originated from the direct determination of the Ce（Ⅲ） concentration change resulting from photocatalytic oxidation of organic compounds. Ce（Ⅲ）, which was produced by photocatalytic reduction of Ce（SO4）2, could be measured at a multi-walled carbon nanotubes （MWNT） chemically modified electrode （CME）. The COD values by this method were calculated from the differential pulse voltammetry （DPV） current of Ce（Ⅲ） at the CME. Under the optimal operation conditions, the detection limit of 0.5 mg·L^-1 COD with the linear range of 1-600 mg·L^-1 was achieved. This method was also applied to determination of various COD of ground water and wastewater samples. The resuits were in good agreement with those from the conventional COD methods, i.e., permanganate and dichromate ones.     

Simultaneous propane dehydrogenation andco2hydrogenation overCrOx/SiO2catalyst

Summary Single reverse water-gas shift (RWGS) and dehydrogenation of propane with CO₂(DH-CO₂) reactions in the presence and absence of the CrO_x/SiO₂ catalyst have been studied between 673 and 873 K. It was found that the CrO_x/SiO₂ catalyst is active both in the dehydrogenation of propane and in the RWGS reactions. The obtained results suggest that the dehydrogenation of propane to propene in the presence of CO₂on CrO_x/SiO₂can be facilitated by the RWGS reaction.</o:p>     

3-Nitro-2-naphthalenemethanol: a photocleavable protecting group for carboxylic acids

Photocleavable protecting groups are important in synthesis and caging. Among many such groups, 2-nitrobenzyl and related groups have been found useful in many applications. However, most of the known 2-nitrobenzyl-based caging chromophores show either low quantum yield or the photolysis wavelength is not suitable for various applications. In this paper, we report 2-nitro-3-naphthalenemethanol (NNM) as an efficient photocleavable protecting group for molecules containing a carboxylic function. NNM possesses photochemical properties better than the 2-nitrobenzyl chromophores as it is photoactivatable at 380 nm in aqueous medium (CH₃CN/H₂O, 3:2 v/v) showing the desired photochemistry. The carboxylic acids are efficiently photoreleased from NNM-based esters in almost quantitative yield.     

Selective oxidation of octadecan-1-ol to octadecanoic acid over Co3O4/SiO2 catalysts

Factors (reaction temperature, reaction time, flow rate of oxygen, amount of catalyst, etc.) influencing the catalytic properties of Co₃O₄/SiO₂catalyst in the oxidation octadecan-1-ol to octadecanoic acid were investigated. The catalysts were characterized by means of XRD, FT-IR and N₂-adsorption. The experimental results indicate that under the optimal condition the selectivity to octadecanoic acid reached 97.5 % over 5 % Co₃O₄/SiO₂ catalyst.This revised version was published online in December 2005 with corrections to the Cover Date.     

3-Cyanopyridine-2(1H)-thiones and 3-cyano-2-(methylthio)pyridines in the synthesis of substituted 3-(aminomethyl)pyridines

The reactions of substituted 3-cyanopyridine-2(1H)-thiones and 3-cyano-2-(methylthio)pyridines with lithium aluminum hydride in anhydrous diethyl ether afforded the corresponding 3-aminomethyl derivatives, which were used in the synthesis of the corresponding amides.     

2,2,4-Trimethylhydroquinolines in the Bischler-Melau Reaction

8-R-1-Aryl-4,4,6-trimethyl-4H-pyrrolo[3,2,1-ij]quinolines have been synthesized by the Bischler-Melau reaction in the series of 6-R-2,2,4-trimethylhydroquinolines.     

CO Oxidation on Cu/MgO-SiO2 Sol-Gel Derived Catalysts

Sol-gel Cu//MgOSiO₂ catalysts were prepared gelling tetraethoxysilane (TEOS), magnesium ethoxide and copper acetylacetonate at pH 3 and pH 9. The catalysts shown specific surface areas ca. 500 m²/g and 140 m²/g for pH 9 and pH 3 preparations respectively. Si(OH) and Si(OH)₂ hydroxy groups were observed by MAS-RMN spectroscopy in both preparations. CO₂-TPD and NH₃-TPD desorption thermograms showed that acid and basic sites were formed on the catalysts surface. It has been found that the catalysts having the highest density of basic sites were the catalysts showing the highest activity for the CO oxidation. It is proposed that the catalytic activity depends of the relative Cu⁼¹/Cu⁼² stability given by the support acidity.     

New method for calculating the adsorption of noble gases on amorphous surfaces

A new approach to calculating the equilibrium characteristics of the adsorption of noble gases on the amorphous surfaces of adsorbents was developed and applied to the Ar−TiO₂(rutile) system. Intermolecular adsorbate-adsorbate interactions are taken into account for the nearest neighbors in the quasi-chemical approximation. The lattice energy parameters of all interactions of the model are determined from the Lennard-Jones potential (12-6). The formation of amorphous TiO₂(rutile) surface includes completion of the surface layers and partial removal of the surface oxygen ions. The quality of the amorphization procedure was confirmed by the experimentally measured heats and isotherms of adsorption of the system under study. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 6, pp. 1109–1118, June, 1997.     

Hydrolysis and Condensation of Transition Metal Alkoxide: Experiments and Simulations

We present here an experimental and numerical study of the chemical and aggregative mechanisms for titanium alkoxide in a reverse micellar medium. NMR experiments were done to study the first step of the sol-gel process: hydrolysis of titanium isopropoxide. Light and X-ray scattering experiments were then conducted to characterize the clustering of aggregates and aggregation kinetics. Fractal dimension, measured by U.S.A.X.S., varies with the hydrolysis ratio and the hydration of the surfactant. This evolution was explained by polydispersity of the hydrolysis which depends on the surfactant concentration. This hypothesis was tested through a numerical simulation of irreversible aggregation using a chemically limited aggregation model. The hydrolyzed sites are distributed among the monomers by a random procedure governed by a polydispersity parameterp, varying from 0 to 1. The total number of hydrolyzed sites is governed by a parameterq belonging to the interval [0, 1]. Thep-q evolution of the fractal dimension coincides rather well with the experimental data in all the region of the two dimensional phase space.