The beneficial effects of a p-type GaInN spacer layer on the efficiency of GaInN/GaN light-emitting diodes

Light-emitting diodes (LEDs) with a Mg-doped p-type Ga_1−xIn_xN (0 ≤ x ≤ 0.07) spacer layer located between an undoped GaN spacer layer and the electron blocking layer are investigated. The LEDs are found to have comparable peak efficiency but less efficiency droop when the crystal quality of the p-type Ga_1−xIn_xN spacer layer is well-controlled by lowering the growth temperature and by using a suitable In composition and Mg doping concentration. All LED samples with the p-type spacer layer show a smaller efficiency droop compared to a reference LED having an undoped GaN spacer. Among the sample sets investigated, an optical power enhancement of 12% at 111 A/cm² is obtained when inserting a 5 nm-thick p-type Ga_0.97In_0.03N spacer layer. The results support that carrier transport is the key factor in the efficiency droop observed in GaN-based LEDs.     

雾化辅助化学气相沉积法氧化镓薄膜生长研究

采用自主设计搭建的雾化辅助化学气相沉积系统设备,开展了Ga₂O₃薄膜制备及其特性研究工作。通过X射线衍射研究了沉积温度、系统沉积压差对Ga₂O₃薄膜结晶质量的影响。结果表明,Ga₂O₃在425~650 ℃温度区间存在物相转换关系。随着沉积温度从425 ℃升高至650 ℃,薄膜结晶分别由非晶态、纯α-Ga₂O₃结晶状态向α-Ga₂O₃、β-Ga₂O₃两相混合结晶状态改变。通过原子力显微镜表征探究了生长温度对Ga₂O₃薄膜表面形貌的影响,从475 ℃升高至650 ℃时,薄膜表面粗糙度由26.8 nm下降至24.8 nm。同时,高分辨X射线衍射仪测试表明475 ℃、5 Pa压差条件下的α-Ga₂O₃薄膜样品半峰全宽仅为190.8″,为高度结晶态的单晶α-Ga₂O₃薄膜材料。     

PbSe/TiO2同轴异质结纳米管的制备及光催化性能

通过溶液法合成了PbSe/TiO2复合纳米管,并对其进行了微观形貌、晶体结构等的表征。结果表明,制得的样品是由PbSe和TiO2两种材料构成的复合材料,致密、均匀的TiO2薄膜包覆在PbSe纳米管表面。以氙灯为模拟光源,通过对甲基橙的降解研究了PbSe/TiO2复合纳米管的光催化性能。结果显示,PbSe与TiO2之间形成的异质结使PbSe/TiO2复合纳米管具有较高的光催化性能,比纯PbSe纳米管的催化降解率提高了约4.5倍。另外,对PbSe/TiO2复合纳米管光催化稳定性也进行了研究。     

高精度半导体激光打标机F-θ镜头设计

为保证半导体激光打标机F-θ镜头的扫描质量,实现系统像高与扫描角的线性变化,需对F-θ镜头给予一定的畸变量,并使其满足等晕条件。分析F-θ镜头工作原理及像差要求,根据1 064 nm半导体激光打标机的光源成像要求选择合适的玻璃材料,合理分配每片透镜的光焦度,以保证等晕成像;根据F-θ镜头线性成像要求,计算系统总畸变量为1.6%,系统总畸变量为系统的实际桶形畸变与相对畸变量之和;在光学系统优化设计时,引入这两项优化参数,优化过程中观察系统成像变化情况。设计结果表明:系统MTF曲线接近衍射极限,F-θ镜头相对畸变小于0.36%,各视场均方根半径均小于艾里斑直径,并且整个系统70%的能量集中在直径为16 μm的圆内,系统总畸变量为1.58%,满足设计指标要求。     

Sonochemical approach for synthesis of zinc oxide-poly methyl methacrylate hybrid nanoparticles and its application in corrosion inhibition

Hybrid nanoparticles (HNPs) with zinc oxide and polymethyl metha acrylate (inorganic/ polymer) were synthesized through the exploitation of ultrasound approach. The synthesized HNPs were further characterized employing transmission electron microscopy and x-ray diffraction. ZnO-PMMA based HNPs exhibit excellent protection properties to mild steel from corrosion when gets exposed to acidic condition. Electrochemical impendence spectroscopy (EIS) analysis was accomplished to evaluate the corrosion inhibition performance of MS panel coated with 2 wt% or 4 wt% of HNPs and its comparison with bare panel and that of loaded with only standard epoxy coating., Tafel plot and Nyquist plot analysis depicted that the corrosion current density (I_corr) decreases from 16.7 A/m² for bare material to 0.103 A/m² for 4% coating of HNPs. Applied potential (E_corr) values shifted from negative to positive side. These results were further supported by qualitative analysis. The images taken over a period of time indicated the increase in lifetime of MS panel from 2 to 3 days for bare panel to 10 days for HNPs coated panel, showing that ZnO-PMMA HNPs have potential application in metal protection from corrosion by forming a passive layer.     

Effect of an Al-doped ZnO electron transport layer on the efficiency of inverted bulk heterojunction solar cells

Doping is a widely-implemented strategy for enhancing the inherent electrical properties of metal oxide charge transport layers in photovoltaic devices because higher conductivity of electron transport layer (ETL) can increment the photocurrent by reducing the series resistance. To improve the conductivity of ETL, in this study we doped the ZnO layer with aluminum (Al), then investigated the influence of AZO on the performance of inverted bulk heterojunction (BHJ) polymer solar cells based on poly [[4,8-bis [(2-ethylhexyl)oxy]benzo [1,2-b:4,5-b’]dithiophene-2,6-diyl]-[3-fluoro-2[(2-ethylhexyl)-carbonyl]-thieno-[3,4-b]thiophenediyl ]] (PTB7):[6,6]-phenyl C71 butyric acid methyl ester (PC₇₁BM). The measured conductivity of AZO was ~10⁻³ S/cm, which was two orders of magnitude higher than that of intrinsic ZnO (~10⁻⁵ S/cm). By decreasing the series resistance (R_s) in a device with an AZO layer, the short circuit current (J_sc) increased significantly from 15.663 mA/cm² to 17.040 mA/cm². As a result, the device with AZO exhibited an enhanced power conversion efficiency (PCE) of 8.984%.     

Extending the response spectrum of organic photodetectors by quaternary active layer method with complementary absorption spectra

In this work, we report a new method for extending the response spectra of organic photodetectors (OPDs) by incorporating PBDT-TT-C and PBDT-TT-F in the P3HT:PC₆₁BM. The effects of PBDT-TT-C and PBDT-TT-F incorporation on the optical and electrical properties of OPDs were investigated, It was found that when the mass ratio of P3HT:PBDT-TT-F:PBDT-TT-C:PC₆₁BM was 12:2:2:8, the response spectrum of the active layer was extended to 780 nm. The responsivity (R) and external quantum efficiency (EQE) of the OPDs reached 340, 376, 315 mA/W and 67%, 88%, 85% under 630, 530, and 460 nm illumination and −1 V bias, respectively, and the detectivity (D*) reached 10¹² Jones. The results show that the inclusion of an appropriate amount of donor material with similar chemical structure and complementary absorption spectrum can reduce the influence of the doping material on the micro-morphology of the original film while improving the absorption of the spectrum. The interaction between the donor materials promotes the generation of photogenerated carriers and increases the photocurrent of the OPDs. In addition, the incorporation of the different component promotes crystallization of the film, resulting in a reduction in dark current of the OPDs.     

SnO2TiO2 复合半导体纳米薄膜的研究进展*

本文概述了SnO₂TiO₂ 复合半导体纳米薄膜的发展历史和研究现状,对比分析了“混合”、“核壳”和“叠层”3 种复合薄膜的结构和性能特点,着重论述了叠层结构的SnO₂ /TiO₂复合薄膜的光电化学和光催化特性。结合作者的研究工作,探讨了SnO₂ /TiO₂双层复合薄膜上下层厚度对其光催化活性的影响,指出复合薄膜光催化活性的提高可归因于电子从TiO₂ 向SnO₂ 的迁移。最后对SnO₂ /TiO₂复合薄膜的局限性和发展潜势做一简要分析,强调了该复合薄膜本身的应用特点。     

Investigation on the catalytic activity of doped low-percentage oxide catalysts Mn/ZnO obtained from oxalate precursor

The precursors with a low manganese content ≤ 0.07% Mn were synthesized by spontaneous crystallization from Zn²⁺, Mn²⁺ and C₂O₄ ²⁻-containing solutions. The initial ratio Zn²⁺:C₂O₄ ²⁻ = 1:1 and 1:2 influences the morphology and prevailing orientations of the crystallites in the oxalate samples. The presence of such small Mn content in the samples does not change the morphology or size of the crystals. The ZnO and Mn/ZnO oxides with manganese content from 0.51×10⁻² to 15.1×10⁻² Wt % are obtained after thermal decomposition of the oxalates. The oxides preserved the morphology of the precursors. The catalytic tests show that the pure ZnO has a poor activity for CO oxidation reaction. Its doping with Mn promotes the catalytic activity (up from twice to five times) in spite of the very low contents of the dopants. The observed increase of the activity depends on both dopant concentration and Zn²⁺:C₂O₄ ²⁻ ratio, probably due to the different mechanism of the manganese inclusion and different morphology of the oxides. The catalysts of the 1:2 series are more active in CO oxidation reaction.