极谱法测定矿石及冶金渣中铍含量

矿石及冶金渣试样与过氧化钠在700℃熔融,用温水浸取,以一定量盐酸酸化后定容。分取部分试样溶液使其中铍(Ⅱ)与铍试剂Ⅲ在EDTA、氯化铵和氨水底液中,生成稳定的配合物,该配合物于-0.80V(vs.SCE)处产生一灵敏的吸附波,其峰电流的二阶导数与铍(Ⅱ)的质量浓度在0.004~0.20mg·L-1范围内呈线性关系,检出限(3S/N)为0.3μg·L-1。方法用于了7个矿石及冶金渣样品的分析,所得测定值与认定值一致。方法的加标回收率在96.0%~105%之间,相对标准偏差(n=6)在1.3%~9.7%之间。     

气相色谱-质谱结合活数据库法测定煤直接液化加氢改质油中C7C9馏分的组成

采用中心切割二维气相色谱,以PONA色谱柱为一维预分析柱与氢火焰离子检测器连接,以DB-35MS色谱柱为二维分析柱与MS连接,对煤直接液化加氢改质油中C7~C9馏分进行了分离与分析,并将质谱谱库检索和活数据库法相结合对60种组分进行了定性分析。同时采用标准物质和烃类化合物在PONA柱上的保留规律对上述定性结果作了验证。还采用面积归一化方法对油样中各化合物进行了定量分析和碳数分布以及族组成分析,其中C8及C9的化合物含量分别为32.3%和51.7%,主要族组成为环烷烃(77.3%)和正构烷烃(9.63%)。     

二氧化锡薄膜:制备及在室温下气敏性质(英文)

利用溶胶-凝胶法首先在玻璃基片上制备了氧化锡晶种膜,之后采用溶剂热法在其上生长了致密的氧化锡薄膜。利用扫描电子显微镜和X射线衍射技术对氧化锡薄膜的形貌和晶体结构进行了表征,结果表明构成薄膜的氧化锡晶粒具有四方锡石结构,尺寸在7~10 nm之间。表面活性剂在溶剂热反应过程中对薄膜生长的研究表明,十二烷基苯磺酸钠可以显著提高薄膜的质量。对所制备的氧化锡薄膜进了气敏性质研究,结果表明,在温和的测试条件下,如室温、常压、干燥的空气背景等,该氧化锡薄膜对二氧化氮气体具有良好的探测能力,检测限为0.5μL·L-1。     

A ladder conjugated polymer transducer for solid-contact Cu2+-selective electrodes

In recent years, there has been a pronounced interest in solid-contact ion-selective electrodes （SC-ISEs）, with emphasis on the use of conducting polymers as ion-to-electron transducer. In this work, a ladder conjugated polymer, thieno[3,2-b]thiophene （LCPT）, was investigated in fabricating Cu2＋-selective electrodes for the first time. The resulting electrodes were characterized by electrochemical impedance spectroscopy （EIS）, chronopotentiometry, and the water layer test. Results proved that the active LCPT facilitates the ion-to-electron transduction, and avoids the detrimental aqueous layer formed at the interface of SC-ISEs.     

Synthesis and electrochemical performance of LiNi0.6Co0.2Mn0.2O2 as a concentration-gradient cathode material for lithium batteries

A well-ordered and spherical LiNi0.6Co0.2Mn0.2O2 cathode material was successfully synthesized from Ni and Mn concentration-gradient precursors via co-precipitation. The crystal structure, morphology and electrochemical properties of LiNi0.6Co0.2Mn0.2O2 were characterized by X-ray diffraction, scanning electron microscopy, energy-dispersive spectroscopy, and charge-discharge tests. The material delivered an initial discharge capacity of 174.3 mAh/g at 180 mA/g （1 C rate） between 2.8 and 4.3 V and more than 93.1% of that was retained after 100 cycles. In addition, it also exhibited excellent rate capability, high cut-off voltage and temperature performance.     

Iso-structural phase transition in tetramethylammonium nickel（Ⅱ） nitrite [（CH3）4N][Ni（NO2）3]

The title compound, tetramethylammonium nickel nitrite [（CH3）4N][Ni（NO2）3], has a hexagonal perovskite-type structure with formula ABX3. It undergoes two reversible phase transitions occurring at about 409.1 and 428.4 K, associated with dielectric transitions. DSC measurement and dielectric measurement confirm the transition. The variable-temperature X-ray structural determinations and the powder X-ray diffraction （PXRD） experiments reveal that this compound has the same space group P3ml （No. 164） at 293 K, 413 K and 438 K. The phase transitions are caused by the rotation of the [（CH3）4N]＋ cation.     

Fabrication of hollow silica microspheres utilizing a hydrothermal approach

Hollow silica microspheres(HSMSs) have been successfully fabricated via a facile hydrothermal route using D-glucose as the sacrificial template and sodium silicate powder as the silica precursor.The resulting silica hollow particles were characterized by scanning electron microscopy(SEM),transmission electron microscopy(TEM),X-ray diffraction(XRD),and infrared spectroscopy(IR).The surface area was determined using the BET method.SEM and TEM images exhibited micro-sized silica hollow particles with a size of ~1.5μm.     

Alkali metal cation doping of metal-organic framework for enhancing carbon dioxide adsorption capacity

Metal-organic frameworks （MOFs） have attracted much attention as adsorbents for the separation of CO2 from flue gas or natural gas. Here, a typical metal-organic framework HKUST-I（also named Cu-BTC or MOF-199） was chemically reduced by doping it with alkali metals （Li, Na and K） and they were further used to investigate their CO2 adsorption capacities. The structural information, surface chemistry and thermal behavior of the prepared adsorbent samples were characterized by X-ray powder diffraction （XRD）, thermo-gravimetric analysis （TGA） and nitrogen adsorption-desorption isotherm analysis. The results showed that the CO2 storage capacity of HKUST-1 doped with moderate quantities of Li＋, Na＋ and K＋, individually, was greater than that of unmodified HKUST-1. The highest CO2 adsorption uptake of 8.64 mmol/g was obtained with 1K-HKUST-1, and it was ca. 11% increase in adsorption capacity at 298 K and 18 bar as compared with HKUST- 1. Moreover, adsorption tests showed that HKUST-1 and 1K-HKUST-1 displayed much higher adsorption capacities of CO2 than those of N2. Finally, the adsorption/desorption cycle experiment revealed that the adsorption performance of 1K-HKUST-1 was fairly stable, without obvious deterioration in the adsorption capacity of CO2 after 10 cycles.     

Preparation and characterization of Ti0.7Sn0.3O2 as catalyst support for oxygen reduction reaction

Sn-doped TiO_2 nanoparticles with high surface area of 125.7 m~2·g~(-1) are synthesized via a simple one-step hydrothermai method and explored as the cathode catalyst support for proton exchange membrane fuel cells.The synthesized support materials are studied by X-ray diffraction analysis,energy dispersive X-ray spectroscopy and transmission electron microscopy.It is found that the conductivity has been greatly improved by the addition of 30 mol%Sn and Pt nanoparticles are well dispersed on Ti_(0.7)Sn_(0.3)O_2 support with an average size of 2.44 run.Electrochemical studies show that the Ti_(0.7)Sn_(0.3)O_2 nanoparticles have excellent electrochemical stability under a high potential compared to Vulcan XC-72.The as-synthesized Pt/Ti_(0.7)Sn_(0.3)O_2 exhibits high and stable electrocatalytic activity for the oxygen reduction reaction.The Pt/Ti_(0.7)Sn_(0.3)O_2 catalyst reserves most of its electrochemically active surface area(ECA),and its half wave potential difference is 11 mV,which is lower than that of Pt/XC-72(36 mV) under 10 h potential hold at 1.4 V vs.NHE.In addition,the ECA degradation of Pt/Ti_(0.7)Sn_(0.3)O_2is 1.9 times lower than commercial Pt/XC-72 under 500 potential cycles between 0.6 V and 1.2 V vs.NHE.Therefore,the as synthesized Pt/Ti_(0.7)Sn_(0.3)O_2 can be considered as a promising alternative cathode,catalyst for proton exchange membrane fuel cells.     

邻氨基酚与邻苯二胺共聚的原位紫外-可见光谱电化学研究

运用循环伏安法(CV)和原位紫外-可见光谱电化学法分别研究了邻氨基酚(OAP)和邻苯二胺(OPD)在1 mol/L HCl溶液中单独聚合及二者共聚的电化学过程。OAP和OPD单独聚合及二者共聚时呈现出的不同电化学行为表明OAP和OPD发生了共聚反应。原位紫外-可见光谱研究表明,在共聚过程中,OAP和OPD首先分别被氧化生成其相应的阳离子自由基,然后,OAP和OPD的阳离子自由基与溶液中的OPD和OAP单体或其阳离子自由基发生交互反应生成类苯胺和类吩嗪结构的二聚物/低聚物中间体,生成的中间体继续发生耦合反应生成OAP和OPD的共聚物,呈现出两个波长分别位于477 nm和419 nm处的吸收峰。并用傅立叶变换红外光谱(FT-IR)表征了共聚物的生成。进一步研究发现,OAP和OPD的共聚过程与溶液中OAP和OPD单体的浓度比有关。