基于柔性电路板单纤双向光纤组件的以太无源光网络单元研制(英文)

随着宽带接入技术的发展,以太无源光网络是光纤到户的一种备选方案.而光网络单元数量众多,其成本成为限制以太无源光网络技术实施的重要影响因素.本文提出了一种低成本以太无源光网络单元实现方式:采用带柔性电路板的单纤双向光纤组件直接安装在光网络单元的电路板上.为了验证弯曲柔性电路板的高速性能没有恶化,采用有限元方法仿真了弯曲柔性电路板的小信号响应.由于该方式没有独立的光收发模块,无法采用比特误码分析仪进行测试,因此提出了采用网络测试仪搭建光网络单元的光信号性能测试系统的方案并实现了对光信号的性能测试.结果表明:对于发射机,在0℃~70℃的范围内得到了超过10dB的消光比和1dBm的平均发射功率;对于接收机,估算灵敏度为-27dBm.     

Performance evaluation of a WDM/OCDM based hybrid optical switch utilizing efficient resource allocation

A hybrid optical switch （HOS） with physical layer of wavelength division multiplexing and optical code division multiplexing （WDM/OCDM） scheme is proposed. An additional feature to the HOS than optical cross connect （OXC） is that the controller can process requests for both circuit establishment and burst scheduling. In our study, the measurement criteria of HOS are the blocking probability, probability of error, and probability of outage. To simplify the analysis, no distinction is made between a circuit in progress and a burst in progress. Moreover, a minimum fit （MinF） resource allocation strategy is applied in order to increase the bandwidth efficiency and control the multiplexing interference of the OCDM. A 2D Markov model for the HOS is presented using the MinF strategy. Numerical results reveal that the code parameters and the resource allocation strategy greatly affect the performance. Certain periority can be achieved by assigning shorter codes to high periority users and longer codes to low periority users. Also, the probability of error and outage are reduced bv aonling the MinF strategy.     

160-Gb/s NRZ-DQPSK optical transmission system employing QC-LDPC code

A quasi-cyclic low-density parity check （QC-LDPC） code is constructed by an improved stability of the shortest cycle algorithm for 160-Gb/s non-return zero differential quadrature phase shift keying （NRZ- DQPSK） optical transmission system with the fiber-based optical parametric amplifier （FOPA）. The QC- --14 d LDPC code with stability of the shortest cycle reduces the bit error ratio （BER） to 10 an restrains the error floor effectively.     

Energy spectrum of multi-radiation of X-rays in a low energy Mather-type plasma focus device

The multi-radiation of X-rays was investigated with special attention to their energy spectrum in a Mather-type plasma focus device （operated with argon gas）. The analysis is based on the effect of anomalous resistances. To study the energy spectrum, a four-channel diode X-ray spectrometer was used along with a special set of filters. The filters were suitable for detection of medium range X-rays as well as hard X-rays with energy exceeding 30 keV. The results indicate that the anomalous resistivity effect during the post pinch phase may cause multi-radiation of X-rays with a total duration of 300 ± 50 ns. The significant contribution of Cu-Kα was due to the medium range X-rays, nonetheless, hard X-rays with energies greater than 15 keV also participate in the process. The total emitted X-ray energy in the forms of Cu-K and Cu-K/3 was around 0.14 ± 0.02 （J/Sr） and 0.04 ±0.01 （J/Sr）, respectively. The total energy of the emitted hard X-ray （〉 15 keV） was around 0.12± 0.02 （J/Sr）.     

二维正方光子晶体波导中的慢光传输

采用平面波展开法分析了正方晶格光子晶体线缺陷波导中的慢光传输.数值模拟结果表明,介质柱光子晶体线缺陷波导中,缺陷模的群速度与填充比、缺陷处介质柱半径及与波导相邻介质柱半径有关,其中缺陷处介质柱半径对缺陷模的群速度影响最大|随着填充比和缺陷处介质柱半径的增大及与波导相邻介质柱半径的减小,缺陷模的群速度逐渐减小且最小减至0.015c.进而对比研究空气柱光子晶体线缺陷波导,发现缺陷模的群速度随着缺陷处空气柱半径的减小而减小,最小减至0.008c.     

红外光幕靶测速系统和精度分析

介绍了弹丸初速度测量的不同方法;讨论了红外光幕靶的测速原理;分析了该系统的测速误差;由实弹射击试验证明:红外光幕靶测速系统达到小于 0.1%的测速精度.     

罗斯滤片法测量激光打靶X射线辐射通量

利用一套罗斯滤片系统测量激光轰击固体金属Ti平面靶产生的X射线辐射通量,系统包括两个相同的X射线探测器及相应滤膜。罗斯滤片法的优点在于利用相邻核素对X射线相似的阻止率,可滤出一个窄的能带并去除高能部分的干扰,获得了Ti平面靶K壳层X光辐射产额。实验结果表明:硬X射线能段在4.5~4.9keV之间的K壳特征辐射占优,连续谱所占份额较低(与晶体谱仪一致);随着激光能量的增加,特征辐射增加;激光强度接近2×1015 W/cm2时,能量转换效率出现峰值。     

PTCDA/P-Si光电探测器欧姆接触层的XPS测试分析

在光电探测器PTCDA/P-Si芯片的有机层表面,成功制作出了比接触电阻为4.5×10-5Ω·cm2的低阻欧姆接触层。利用X射线光电子能谱(XPS)对Al/Ni/ITO的欧姆接触层界面的电子状态进行了测试和分析。结果表明,ITO中的In3d及Sn3d各出现两个分裂能级的谱峰,它们是In和Sn原子处于氧化环境的结合能。Ni2p有两个谱峰Ni2p(1)及Ni2p(2),低结合能位置Ni2p(1)对应于Ni原子被X射线激发产生的谱峰,说明NiITO之间没有发生化学反应,Ni层阻止了Al层被氧化成Al2O3;高结合能Ni2p(2)谱峰说明已形成了Al3Ni冶金相,有利于低阻欧姆接触层的形成。     

新型热电子发电机

<正>德国和美国的研究人员开发出一种将热或光转换成电能的新型热电子发电机。新的设计克服了"空间电荷效应问题",这个问题阻碍着实用设备的研制。新型发电机的效率大约是以前的发电机效率的4倍。这种新技术可应用于太阳能发电及废热利用等方面。热电子发电机利用由真空隔开的两块金属板之间的温差来将热或光转换成电流。热的那块金属板由入射光或热传导来加热,使得电子从金属板的表面蒸发     

一维势阱与扩展X射线吸收精细结构

介绍了一维势阱的一个应用实例.