光学薄膜在现代汽车工业中的应用

本文论述应用光学薄膜技术对汽车窗口玻璃和塑料的若干性能进行改进的技术发展水平，这些性能包括塑料表面的硬化，红外区的反射，紫外区的吸收，偏振化作用，双折射，憎水性以及光学角度选择性等，评论等离子体处理和物理蒸汽淀积薄膜工艺近来应用的一些例子。对于物理蒸汽淀积薄膜所提供的异常功能连同实际使用中它们的耐久性作了特殊的强调。     

萃取色谱法富集原子吸收法测定环境水中超痕量金属元素──两种萃取剂的比较

本文研究并比较了分别以８－羟基喹啉和巯基苯骈噻唑为萃取剂，以活性硅胶为载体的柱式萃取色谱法对环境水中Ｚｎ、Ｃｕ、Ｐｂ、Ｃｄ、Ｆｅ、Ｃｏ、Ｎｉ和Ｍｎ的最佳富集和洗脱条件。实验证明，后者明显优于前者。以巯基苯骈噻唑为萃取剂的色谱柱对金属元素的吸附具有快速、完全、寿命长和重现性好等特点。在ｐＨ＝７～８之间回收率可达９８％以上，富集倍数为２００倍。     

三角帆蚌对水体Cr,Pb和Cd的净化与吸收

三角帆蚌（Hyriopsis cumingii Lea）对水体Cr,Pb,Cd污染有明显的净化能力，持续处理12d，能使水体Cr,Pb,Cd含量分别下降83％，77．6％和72％。蚌体的斧足、鳃、外磁膜、体表粘液、肝脏、肠道和生殖腺等组织对3种污染物的吸收和富集作用不尽相同，其中分别以体表粘液、鳃和肝脏最为显著。3种污染物进入蚌体的速度很快，其组织吸收量一般在第3天即可达到较高水平。进入蚌体的污染物，可在组织转移和重新分布。研究结果为生物治理Cr,Pb,Cd等重金属污染积累了资料。     

石墨-六角氮化硼微晶混合物与水高压反应产物分析

 利用球磨法制备石墨-六角氮化硼微晶混合物，并在6.1 GPa、800~1 500 ℃条件下与水进行高压反应，以便研究用水作触媒合成B-C-N三元化合物的可能性。通过对反应产物的XRD、XPS谱分析发现：高压下随着温度的升高，反应产物中出现再结晶石墨，其晶化程度逐渐提高；但没有出现再结晶六角氮化硼，也未出现立方氮化硼。在球磨不充分条件下，石墨-六角氮化硼混合物的XRD谱没有完全弥散，它们与水高压反应时，能观察到石墨与立方氮化硼分别结晶的现象，但都没有形成B-C-N晶化结构。     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

几种旱生植物水分生理特性的比较研究

本文对梭梭(Halorylon ammodendron)等几种典型荒漠旱生植物在干旱环境下体内含水量、相对合水量、水分饱和亏缺、自由水、束缚水、水势、离体枝叶吸水速率等的变化及其与植物抗旱的关系进行了比较研究。     

中高温工质在蒸发器中的换热模拟分析

本文采用分布参数的方法,建立了水源热泵中普遍采用的壳管式蒸发器稳态数学模型.通过中高温水源热泵试验台的实验数据同模拟计算结果的对比,验证了数学模型的准确性。应用此数学模型对中高温工质HTR01、HTR02及R134a在蒸发器典型制热运行工况,进行了模拟计算。得出了三种工质制冷剂侧换热系数沿管长的变化关系并对三种工质的换热性能进行了对比分析,为采用中高温工质的水源热泵换热器设计提供了参考依据.     

Bending-torsion vibration of a partially submerged cylinder with an arbitrary cross-section

An analytical method is presented to investigate the bending-torsion vibration characteristics of a cylinder with an arbitrary cross-section and partially submerged in water. The compressibility and the free surface waves of the water are considered simultaneously in the analysis. The exact solution of structure–water interaction is obtained mathematically. Firstly, the analytical expression of the velocity potential of the water is derived by using the method of separation of variables. The unknown coefficients in the velocity potential are determined by the longitudinal and circumferential Fourier expansions along the outer surface of the cylinder and are expressed in the form of integral equations including the unknown dynamic bending deflection and torsional angle of the cylinder. Secondly, the force and torque acting on the cylinder per unit length, provided by the water, are obtained by integrating the water dynamic pressure along the circumference of the cylinder. The general solution of bending-torsion vibration of the cylinder under the water dynamic pressure is derived analytically. The integral equations included in the velocity potential of the water can be solved exactly. Finally, the eigenfrequency equation of cylinder–water interaction is obtained by means of the boundary conditions of the cylinder. Some numerical examples for elliptical columns partially submerged in water are provided to show the application of the present method.