Laminar bubbly flow in an open capillary channel in microgravity

The study of a bubbly laminar two-phase flow in an open capillary channel under microgravity conditions was conducted aboard the sounding rocket, Texus-45. The channel consists of two parallel plates of width b = 25 mm and distance a = 10 mm. The flow along the length l = 80 mm is confined by a free surface on one side and a plate on the opposite side. The bubbles are injected at the nozzle of the capillary channel via six capillary tubes of 100 μm in inner diameter. Different liquid and gas flow rates were tested leading to different liquid free surface shape and bubble size.     

Complementarity of CFD, experimentation and reactor models for solving challenging fluidization problems

Experimentalists, numerical modellers and reactor modellers need to work together, not only just for validation of numerical codes, but also to shed fundamental light on each other＇s problems and underlying assumptions. Several examples are given, Experimental gas axial dispersion data provide a means of choosing the most appropriate boundary condition （no slip, partial slip or full slip） for particles at the wall of fluidized beds. CFD simulations help to identify how close ＂two-dimensional＂ experimental columns are to being truly two-dimensional and to representing three-dimensional columns. CFD also can be used to provide a more rational means of establishing assumptions needed in the modelling of two-phase fluidized bed reactors, for example how to deal with cases where there is a change in molar flow （and hence volumetric flow） as a result of chemical reactions.     

Propagation of a pre-existing turbulent fluid fracture

The propagation of rough and smooth wall pre-existing turbulent fluid fractures is investigated. The laminar fluid fracture is included as a special case for comparison. Lubrication theory is assumed to apply in the fracture and turbulence is introduced through the wall shear stress. The Perkins–Kern–Nordgren approximation is made in which the fluid pressure is proportional to the half-width of the fracture. The fracture half-width satisfies a non-linear diffusion equation. By using a linear combination of the Lie point symmetries of the non-linear diffusion equation a group invariant solution for the fracture length, volume and half-width is derived. The evolution of the length, half-width and mean flow velocity is analysed for a range of working conditions at the fracture entry. It is found that the mean flow velocity increases approximately linearly along the fracture.     

EACVD中热阴极直流放电特性的实验研究

本文针对ＥＡＣＶＤ过程中经常出现的放电振荡和不稳定现象，比较系统地研究了ＥＡＣＶＤ中热阴极直流放电特性及其与工艺参数之间的关系，分析和讨论了放电振荡和不稳定现象发生的原因，并给出了避免和控制的途径和措施。     

Carbopol gels: Elastoviscoplastic and slippery glasses made of individual swollen sponges: Meso- and macroscopic properties,constitutive equations and scaling laws

This paper gives details of new data on neutralized Carbopol 940 dispersions. Appropriate techniques have been used to characterize the physical properties of the bulk gel and inter-phase slip at the wall. Previously published data are analysed and used wherever possible. Terminology and measurement difficulties are also addressed.     

COALESCENCE INDUCED GRADIENT MORPHOLOGY NEAR A WALL IN PHASE SEPARATED POLYMER BLENDS DURING QUIESCENT ANNEALING

A fast coalescence mechanism is proposed to account for the wall effect on the formation of gradient morphologyin phase separated polymer blends during quiescent annealing. The existence of solid wall with high polarity is believed tochange the potential field around the dispersed pedicles near the wall. This additional potential interaction between the solidwall and the dispersed particles causes faster coalescence of the dispersed particles near the wall than in the bulk. Thegradient phase morphology thus formed can be predicted by combining the wall-particle interaction and the touch-coalescence mechanism. The effect of interfacial tension on the gradient morphology is also discussed.     

Counter-current gas–liquid flow in a vertical narrow channel—Liquid film characteristics and flooding phenomena

Results are reported of an experimental investigation of gas–liquid counter-current flow in a vertical rectangular channel with 10 mm gap, at rather short distances from liquid entry. Flooding experiments are carried out using air and various liquids (i.e., water, 1.5% and 2.5% aqueous butanol solutions) at liquid Reynolds numbers Re_L < 350. Visual observations and fast recordings suggest that the onset of flooding at low Re_L (<250) is associated with liquid entrainment from isolated waves, whereas “local bridging” is dominant at the higher Re_L examined in this study. Significant reduction of flooding velocities is observed with decreasing interfacial tension, as expected. Instantaneous film thickness measurements show that under conditions approaching flooding, a sharp increase of the mean film thickness, of mean wave amplitude and of the corresponding RMS values takes place. Film thickness power spectra provide evidence that by increasing gas flow the wave structure is significantly affected; e.g., the dominant wave frequency is drastically reduced. These data are complemented by similar statistical information from instantaneous wall shear stress measurements made with an electrochemical technique. Power spectra of film thickness and of shear stress display similarities indicative of the strong effect of waves on wall stress; additional evidence of the drastic changes in the liquid flow field near the wall due to the imposed gas flow, even at conditions below flooding, is provided by the RMS values of the wall stress. A simple model is presented for predicting the mean film thickness and mean wall shear stress under counter-current gas–liquid flow, below critical flooding velocities.     

从太空探测万里长城

2004年5月11日,欧空局网站发布了题为“从太空看长城”的公告,引起广泛关注和热烈争论.争论焦点涉及如何正确认识人眼视觉原理,如何准确理解卫星遥感应用潜力等问题.文章从人眼结构、产生光觉、视觉和形觉的基本条件以及眼睛分辨率等基本概念入手,判定肉眼从太空不可能看到长城.同时通过理论分析与实验,揭示了空间分辨率达到米级的SPOT-5全色图像能够清楚地展现北京密云水库北面的各段野长城.在分辨率为10m和20m的多光谱图像上,无法辨别出长城.而在全色（2.5m,5m）与多光谱进行融合处理的图像上,各段野长城及其周围背景都能十分清晰地显示出来.     

Analysis of bulk and inorganic degradation products of stones,mortars and wall paintings by portable Raman microprobe spectroscopy

This work reports the use of a portable Raman microprobe spectrometer for the analysis of bulk and decaying compounds in carbonaceous materials such as stones, mortars and wall paintings. The analysed stones include limestone, dolomite and carbonaceous sandstone, gypsum and calcium oxalate, both mono- and dihydrated, being the main inorganic degradation products detected. Mortars include bulk phases with pure gypsum, calcite and mixtures of both or with sand, soluble salts being the most important degradation products. The pigments detected in several wall paintings include Prussian blue, iron oxide red, iron oxide yellow, vermilion, carbon black and lead white. Three different decaying processes have been characterised in the mortars of the wall paintings: (a) a massive absorption of nitrates that reacted with calcium carbonate and promoted the unbinding of pigment grains, (b) the formation of black crusts in the vault of the presbytery and (c) the thermodecomposition of pigments due to a fire.     

Switching of transmission resonances in a two-channels coupler: A Boundary Wall Method scattering study

In this work, we study the transmission characteristics of a two-channels coupler model system using the Boundary Wall Method (BWM) to determine the solution of the corresponding scattering problem of an incident plane wave. We show that the BWM provides detailed information regarding the transmission resonances. In particular, we focus on the case of single channel input aiming to explore the energy switching performance of the coupler. We show that the coupler geometry can be tailored to allow for the first transmission resonances to be predominantly transmitted on specific output channels, an important characteristic for the realization of logical operations.