极低密度聚乙烯与其它聚乙烯的共混

从结构角度，用ＤＳＣ，ＷＡＸＤ，ＳＡＸＳ研究了聚乙烯（ＰＥ）家族中极低密度聚乙烯（ＶＬＤＰＥ）与其它ＰＥ的互容性．ＨＤＰＥ／ＶＬＤＰＥ是共晶互容的，以其大量无规部分“溶解”了ＨＤＰＥ的结晶缺陷部分，提高了ＨＤＰＥ的Ｔｃ，Ｔｍ，Ｘｃ，结晶峰半高宽变窄，晶胞参数随组成而有最低值．ＶＬＤＰＥ与ＬＬＤＰＥ结构极为相似，ＤＳＣ及ＷＡＸＤ证明其共混物是共晶相容体系．ＬＤＰＥ／ＶＬＤＰＥ的结晶度符合按组成的计算值，但晶胞参数ａ，ｂ以及晶粒尺寸增大，ＤＳＣ上有分别相应于两组份的两个Ｔｍ；ＶＬＤＰＥ的Ｔｃ，Ｔｍ峰高之和高于按组份的计算值，ＬＤＰＥ的Ｔｍ，Ｔｃ则低于计算值．认为是正如ＬＬＤＰＥ／ＬＤＰＥ，ＬＤＰＥ向充满整个体积的ＶＬＤＰＥ中不断填入，以ＶＬＤＰＥ为晶核而结晶，形成相分离的不相容体系．     

f-Element/crown ether complexes: 21. Conformational changes in metal complexed versus hydrogen bonded benzo-15-crown-5 in the structure of [Y(OH2)3(NCMe)-(benzo-15-crown-5)][ClO4]3·benzo-15-crown-5·CH3CN

Crystalline [Y(OH₂)₃(NCMe)(benzo-15-crown-5)][ClO₄]₃·benzo-15-crown-5-CH₃CN can be obtained by slowly cooling a reaction mixture of Y(ClO₄)₃·n H₂O with benzo-15-crown-5 in a solution of acetonitrile and methanol (3 : 1) from 60°C to room temperature. The crystal structure of this complex has been determined at –150 and 20°C. The complex is triclinic,P . At –150°C the cell parameters area = 11.986(4),b = 12.071(7),c = 16.364(5) Å, = 93.56(3), = 98.68(3), = 109.68(4)°, vol = 2187 ų, andD _calc = 1.61 g cm^–3 forZ = 2 formula units. 3633 independently observed [F _o 5(F _o)] reflections were used in the final least-squares refinement leading to an agreement index ofR = 0.048. The Y(III) ion coordination geometry approximates a tricapped trigonal prism with three water molecules and three benzo-15-crown-5 oxygen atoms forming the prism, with the two remaining benzo-15-crown-5 oxygen atoms and the acetonitrile molecule completing the coordination as capping atoms. The three water molecules hydrogen bond a second crown ether molecule and two of the perchlorate anions. The two acetonitrile molecules have contacts with perchlorate oxygen atoms close enough for some weak interaction. One perchlorate is ordered, one is partially disordered as is the coordinated solvent molecule, and the third anion is totally disordered. The two unique crown ether molecules have distinctively different conformations.For Part 20, see reference [1].     

New FIR laser lines and frequency measurements in CD3OD

Twenty-four new submillimeter laser lines in fully deuterated methyl alcohol (CD₃OD) in the wavelength range from 52 to 328 m have been obtained in a Fabry-Perot FIR resonator by optically pumping the methanol with a cw CO₂ laser. We have made accurate wavelength measurements and have determined the relative polarization of most of the known CD₃OD laser lines. The frequencies of 13 of the strongest lines were also measured.Contribution of the U.S. Government, not subject to copyright.     

Preparation of water‐soluble,syndiotacticity‐rich,low molecular weight poly(vinyl alcohol) microfibrils in high yields with the low‐temperature polymerization of vinyl pivalate in tetrahydrofuran and saponification

To prepare water‐soluble, syndiotacticity‐rich poly(vinyl alcohol) (PVA) microfibrils for various industrial applications, we synthesized syndiotacticity‐rich, low molecular weight PVA by the solution polymerization of vinyl pivalate (VPi) in tetrahydrofuran (THF) at low temperatures with 2,2′‐azobis(2,4‐dimethylvaleronitrile) (ADMVN) as an initiator and successive saponification of poly(vinyl pivalate) (PVPi). Effects of the initiator and monomer concentrations and the polymerization temperature were investigated in terms of the polymerization behaviors and molecular structures of PVPi and the corresponding syndiotacticity‐rich PVA. The polymerization rate of VPi in THF was proportional to the 0.91 power of the ADMVN concentration, indicating the heterogeneous nature of THF polymerization. The low‐temperature solution polymerization of VPi in THF with ADMVN proved to be successful in obtaining water‐soluble PVA with a number‐average degree of polymerization (P_n) of 300–900, a syndiotactic dyad content of 60–63%, and an ultimate conversion of VPi into PVPi of over 75%. Despite the low molecular weight of PVA with P_n = 800, water‐soluble PVA microfibrillar fibers were prepared because of the high level of syndiotacticity. In contrast, for PVA with P_n = 330, shapeless and globular morphologies were observed, indicating that molecular weight has an important role in the in situ fibrillation of syndiotacticity‐rich PVA. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 1103–1111, 2002     

大口径光学元件波前调制PSD模拟分析

 使用PSD作为大口径光学元件表面加工质量的评价参数，针对不同的波前调制进行了初步的模拟计算，得到了不同调制频率和不同调制深度情况下的PSD曲线变化情况。当调制频率不同时，PSD曲线的突变部分会发生相应的频移，调制频率高则突变发生在空间频率较高的频段，同时PSD峰值不变。相对应调制深度不同时，PSD曲线的突变部份峰值发生变化，调制深度大则峰值大，与此同时峰值出现的位置不会发生变化。计算和分析结果表明PSD分析结果能够在频率域反应出元件表面受到的不同程度的调制信息。     

回旋速调管放大器输出腔的特性研究

 利用变截面波导的耦合模理论，根据输出腔中电场幅值分布函数所满足的微分方程组，编写了具有自动优化功能的计算程序，分析研究了不同渐变角度、考虑腔体损耗前后和输出腔与外电路失配时，谐振频率、腔体品质因数和高频场幅值沿轴分布的变化情况，为进一步研究高频场与电子注的互作用和输出腔奠定了基础。     

强流射频四极加速器输入耦合环的物理设计研究

 详细讨论了强流射频四极加速器高频输入耦合环的一些基本问题，完成了高频输入耦合环的初步物理设计. 利用二维程序Superfish 的一些结果，确定了耦合环的大小，计算了耦合环的功耗，并对构成耦合环导线的粗细进行了估算。该耦合环的物理设计可作为耦合环试验的基础，同时，也可作为三维程序HFSS 模拟计算的起点。     

Frequency and voltage-dependent electrical and dielectric properties of Al/Co-doped PVA/p-Si structures at room temperature

In order to investigate of cobalt-doped interracial polyvinyl alcohol （PVA） layer and interface trap （Dit） effects, A1/p- Si Schottky barrier diodes （SBDs） are fabricated, and their electrical and dielectric properties are investigated at room temperature. The forward and reverse admittance measurements are carded out in the frequency and voltage ranges of 30 kHz-300 kHz and -5 V-6 V, respectively. C-V or er-V plots exhibit two distinct peaks corresponding to inversion and accumulation regions. The first peak is attributed to the existence of Dit, the other to the series resistance （Rs）, and interfacial layer. Both the real and imaginary parts of dielectric constant （er and err） and electric modulus （Mr and Mrr）, loss tangent （tan~）, and AC electrical conductivity （aac） are investigated, each as a function of frequency and applied bias voltage. Each of the M~ versus V and Mrr versus V plots shows a peak and the magnitude of peak increases with the increasing of frequency. Especially due to the Dit and interfacial PVA layer, both capacitance （C） and conductance （G/w） values are strongly affected, which consequently contributes to deviation from both the electrical and dielectric properties of A1/Co-doped PVA/p-Si （MPS） type SBD. In addition, the voltage-dependent profile of Dit is obtained from the low-high frequency capacitance （CLF-CHF） method.     

Hexacyanoferrate‐based ionic liquids as Fenton‐like catalysts for deep oxidative desulfurization of fuels

Two hexacyanoferrate‐based ionic liquids, [C₄Py]₃Fe(CN)₆ and [C₁₆Py]₃Fe(CN)₆, were synthesized and characterized using Fourier transform infrared and mass spectroscopies and CHN analysis. They were employed as Fenton‐like catalysts in extraction and catalytic oxidative desulfurization of model oil with dibenzothiophene (DBT), benzothiophene (BT), 4,6‐dimethyldibenzothiophene (4,6‐DMDBT), 4‐methyldibenzothiophene (4‐MDBT) and 3‐methylbenzothiophene (3‐MBT) as substrates. Various polar solvents, such as ionic liquids, water and organic solvents, were applied to choose a suitable extractant. The results showed the removal of DBT reached 97.1% with [C₄Py]₃Fe(CN)₆ as a catalyst and 1‐n‐octyl‐3‐methylimidazolium hexafluorophosphate ([C₈mim]PF₆) as an extractant under optimal conditions. The activity of sulfur removal followed the order DBT > 3‐MBT > BT > 4‐MDBT >4,6‐DMDBT. The effect of water content on sulfur removal was investigated by adding various concentrations of H₂O₂. It was found that excess water had a positive effect on sulfur removal but the catalysts were less sensitive than [FeCl₄^?]‐based catalysts to water. The mechanism was studied using electron spin‐resonance spectroscopy and gas chromatography–mass spectrometry. O₂^?? may be the active oxygen species in the catalytic oxidative desulfurization process and the oxidation products of various sulfur compounds were the corresponding sulfoxides and sulfones. Copyright © 2016 John Wiley & Sons, Ltd.     

Crack detection of a double-beam carrying a concentrated mass

This paper presents the influence of a concentrated mass location on the natural frequencies of a cracked double-beam. The double-beam consists of two different beams connected by an elastic medium. The concentrated mass is located on the main beam. The relationship between the natural frequency and the location of concentrated mass is established and called “Frequency–Mass Location” (FML). The numerical simulations show that when there is a crack, the frequency of the double-beam changes irregularly when the concentrated mass is attacked at the crack position. This irregular change can be amplified by the wavelet transform and this is useful for crack detection: the crack location can be detected by the location of peaks in the wavelet transform of the FML. Finite element model for the cracked double-beam carrying a concentrated mass is presented and numerical simulations are also provided.