稀土Tonpilz换能器的有限元设计法

当Tonpilz换能器组件迥横截面面积之间相差较大时,应力,应变会有一定的突破,边界条件将不很连续,用四端网络方法设计会带来较大的误差,本文用有限元方法,设计并研制了一稀土Tonpilz型换能器 实验测试表明,与四端网络设计法相比,有限元方法具有更好的设计精度。     

爆电换能脉冲大电流输出研究

 基于爆电换能原理,使用掺铌的PZT 95/5陶瓷组装换能器件,在垂直工作模式下,对爆电电源LRC电路响应进行了理论分析,并开展了脉冲大电流输出实验研究。实验采用多组PZT 95/5铁电陶瓷并联,利用平面波发生器作为冲击加载手段,获得了峰值5 kA以上的脉冲大电流,初始电流上升速率可达10~20 GA/s。实验结果与理论设计符合较好。     

宽体液腔Janus-Helmholtz换能器

本文使用有限元方法对宽体液腔Janus-Helmholtz(JH)换能器进行了仿真分析,得出了壳体宽度拓展增量对JH换能器工作性能的影响规律。使用三维建模的方式,分析了连接部分对换能器性能的影响及宽体壳体的的模态,证明了三维建模的必要性。依据仿真优化结构设计了一款宽体液腔JH换能器并进行了湖上测试。最终测试结果与仿真结果有很好的一致性,相较直筒JH换能器其谐振频率降低300Hz,发射电压响应最高可达144dB。     

基于EKF的水下LD通信精对准控制算法

高速激光通信中接收机与光斑中心很难处于精对准状态,导致水下光通信链路难以稳定建立.首先采用蒙特卡洛仿真统计法分析激光光子在海水中传输的接收光强分布规律,再通过实验对接收端的光斑图像进行采样分析,利用曲线拟合得到接收器位置与接收光强的关系.仿真与实验结果表明:光束经过25 m的水下传输,接收光强分布仍近似为高斯分布.采用非线性估计算法(扩展卡尔曼滤波)与基本状态控制反馈理论,根据接收光强度估计接收器当前位置与最大光强处的距离,通过反馈算法实现接收端与光斑中心的主动跟踪对准.算法仿真结果显示,接收端对准误差在2 mm以下,稳定后接收效率超过98%.     

基于超磁致伸缩材料的光纤光栅调谐范围研究

研究了基于超磁致伸缩材料实现对光纤布拉格光栅的动态调谐这一方案理论上可获得的最大调谐范围．利用超磁致伸缩换能器的输出特性,进行了超磁致伸缩换能器用于光纤布拉格光栅调谐的实验研究．分析了实验中影响可获得调谐范围的各种因素,如实际可获得的超磁致伸缩材料的特性、光纤布拉格光栅的特性以及换能器结构的设计．进一步讨论了在理论界限的前提下改进该方案可获得调谐范围的措施,并以施加预应力为例进行了实验验证．结果表明,通过给予超磁致伸缩材料合适的预应力,可以较明显地改善最大调谐范围．     

浑水中非均匀光场探测图像方法

分析了传统的水下观测和激光观测技术在能见度约为0.5~1.5 m的浑浊水域和0.2 m的特浑水域观测遇到的理论和技术上的局限性.叙述了一种非均匀光场集束光水下目标图像探测方法和系统,并在各种浑浊水质中进行其特性的试验.试验结果表明该系统基本上解决了浑浊水中的观测问题.     

Testing of nitrile rubber joints for a deep submergence vehicle

This paper describes an experimental study of the long term sealing performance of nitrile rubber joints on a manned deep ocean submersible operating down to 6000 m depths. An initial formulation showing large compression set is discussed first. Then results from long term laboratory testing of a second formulation, aged in water for 10 years, are presented. Much lower compression set and higher sealing forces are observed. Based on these results a testing methodology for the prediction of the long term sealing performance of nitrile O-rings is proposed. Results from laboratory tests are compared with those measured on joints aged for up to 10 years in service.     

A method to accurately measure and respond to an underwater sound pulse in a wide dynamic range

I.IntroductionTomeasurethesound1evelofanundcrwatersoundpulsewithunknownamplitudeisofimportanceinunderwaterapp1ication.Forinstancc,asimu1ationsystemusedtointerfcresomesonarmusthavesuchfunction,whichhastobeabIctomeasurethesoundlcvelatreceivingpointandretransmitasimulatcdsignalwithrequircdsoundlcvelafterpropcrprocessing.Itisdifficultforanorma1peakorthresho1ddetectortocompletethistask.Thereasonforthisisthattherangeofthesignalamp1itudercaches7O-8odBandthereissomedistortionofsignalwaveform,inaddit…     

镶嵌型宽波束换能器

本文描述了一种用于水下运载体上的宽波束换能器的设计方法和实验结果。分析了影响波束开角的因素及变化趋势。所建立的模型可以设计不同工作频率的宽波束换能器。     

The Hamming weight of the non-adjacent-form under various input statistics

The Hamming weight of the non-adjacent form is studied in relation to the Hamming weight of the standard binary expansion. In particular, we investigate the expected Hamming weight of the NAF of an n-digit binary expansion with k ones where k is either fixed or proportional to n. The expected Hamming weight of NAFs of binary expansions with large (≥ n/2) Hamming weight is studied. Finally, the covariance of the Hamming weights of the binary expansion and the NAF is computed. Asymptotically, these Hamming weights become independent and normally distributed. Communicated by Attila Pethő