Effects of Cd2+ substitution on elastic properties and step-like anomalies in Tl0.9Bi0.1Sr1.8Yb0.2Ca1−xCdxCu1.99Fe0.01o7−δ superconductors

Cd-doped Tl_0.9Bi_0.1Sr_1.8Yb_0.2Ca_1−xCd_xCu_1.99Fe_0.01O_7−δ (x=0–0.4) bulk superconductor samples were prepared by solid-state reaction method, to examine the effect of Cd on ultrasonic velocity and elastic behavior of the samples. The samples were characterized by X-ray diffraction, DC electrical resistivity and temperature dependent ultrasonic velocity measurements. DC electrical resistivity measurement showed all the samples exhibit metallic normal-state behavior with the highest T_{c zero} observed at around 76.4 K (x=0.3). Ultrasonic velocity measurements at 80 K showed a non-linear increase in both absolute longitudinal and shear velocities as well as elastic moduli with Cd substitution with the largest increase observed for the x=0.3 sample. Temperature dependant longitudinal modulus showed elastic anomaly characterized by a step-like slope change at around 230 K for x=0 & x=0.3 and at around 250 K for x=0.4 with the x=0.3 sample showing the sharpest slope change. A comparison between experimental data and calculated lattice anharmonicity curve based on the model proposed by Lakkad, showed large deviation of the experimental longitudinal modulus curves for (x=0.3) from the calculated anharmonicity curves indicating that the elastic behavior was strongly influenced by the existence of the step-like longitudinal anomaly. On the other hand, our analysis using the Landau free energy model found that the anomalous step-like elastic behavior fitted well with the equation derived from the model for regions below and above the elastic anomaly temperature, T_A. The fitting indicated that the anomaly is related to a phase transition that is suggested to involve ordering of oxygen which introduces strain in the system.     

基于超声波和云测试的油井液面测试系统研究

针对目前油井液面深度测试系统测量范围小、误差大、稳定性低的缺点,提出了基于声波法测动液面原理,利用时间序列分析技术、新息自适应卡尔曼滤波技术来实时检测回波信号,进而实现对油井液面深度的高精度测量和噪声处理;选用FPGA和云测试技术成功实现了油井液面深度测量系统的远程化和网络化。基于云测试的油井液面远程监测系统目前已在油田生产现场通过测试,测试结果表明,系统稳定,算法实时、高效,动液面深度测量误差小,测量精度高,能满足实际工程应用。     

Sulfur removal from bauxite water slurry (BWS) electrolysis intensified by ultrasonic

Effects of ultrasonic on desulfurization ratio from bauxite water slurry (BWS) electrolysis in NaOH solution were examined under constant current. The results indicated that ultrasonic improved the desulfurization ratio at high temperatures because of the diffusion and transfer of oxygen gas in electrolyte. However, due to the increase in oxygen gas emission, ultrasonic could not improve the desulfurization ratio obviously at low temperatures. Additionally, the particle size of bauxite became fine in the presence of ultrasonic, indicating that the mass transfer of FeS₂ phase was improved. According to the polarization curves, the current density increased in the presence of ultrasonic, indicating that the mass transfer of liquid phase was improved. The apparent activation energy (AAE) of electrode reaction revealed that ultrasonic did not change the pathway of water electrolysis. However, ultrasonic changed the pathway of BWS electrolysis, converting indirect oxidation into direct oxidation. The AAE of BWS electrolysis in the presence of ultrasonic was higher than that in the absence of ultrasonic. And the low AAEs (less than 20 kJ/mol) clearly indicated the diffusion control during BWS electrolysis reaction.     

Opportunities and Challenges in the Use of TiO2 Nanoparticles Modified with Citric Acid to Synthesize Advanced Nanocomposites Based on Poly(amide-imide) Containing N,N′-(Pyromellitoyl)-bis-L-leucine Segments

In this study, the goal was the preparation, characterization, and surface morphology of poly(amide-imide)/TiO₂-citric acid nanocomposites (PAI/TiO₂-CA NCs). Owing to the high surface energy and tendency for agglomeration, the surface of TiO₂ nanoparticles was modified with citric acid. Then poly(amide-imide) was synthesized by direct polycondensation reaction of N,N′-(pyromellitoyl)-bis-L-leucine diacid with 4,4′-diaminodiphenylmethane by triphenyl phosphite and tetra-n-butylammonium bromide as a green medium. The attained polymer and modified TiO₂ nanoparticles were used to prepare PAI/TiO₂-CA NCs through ultrasonic irradiation. The resulting PAI/TiO₂-CA NC was characterized with FT-IR spectroscopy, X-ray diffraction, field emission scanning electron microscopy, transmission electron microscopy, and thermogravimetric analysis.     

Transplantation of betacellulin-transduced islets improves glucose intolerance in diabetic mice

Type 1 diabetes is an autoimmune disease caused by permanent destruction of insulin-producing pancreatic β cells and requires lifelong exogenous insulin therapy. Recently, islet transplantation has been developed, and although there have been significant advances, this approach is not widely used clinically due to the poor survival rate of the engrafted islets. We hypothesized that improving survival of engrafted islets through ex vivo genetic engineering could be a novel strategy for successful islet transplantation. We transduced islets with adenoviruses expressing betacellulin, an epidermal growth factor receptor ligand, which promotes β-cell growth and differentiation, and transplanted these islets under the renal capsule of streptozotocin-induced diabetic mice. Transplantation with betacellulin-transduced islets resulted in prolonged normoglycemia and improved glucose tolerance compared with those of control virus-transduced islets. In addition, increased microvascular density was evident in the implanted islets, concomitant with increased endothelial von Willebrand factor immunoreactivity. Finally, cultured islets transduced with betacellulin displayed increased proliferation, reduced apoptosis and enhanced glucose-stimulated insulin secretion in the presence of cytokines. These experiments suggest that transplantation with betacellulin-transduced islets extends islet survival and preserves functional islet mass, leading to a therapeutic benefit in type 1 diabetes.     

Ultrasound-promoted,rapid, green,one-pot synthesis of 2′-aminobenzothiazolomethylnaphthols via a multi-component reaction,catalyzed by heteropolyacid in aqueous media

A one-pot, three-component condensation reaction of 2-aminobenzothiazole, 2-naphthol and appropriate aldehydes catalyzed by heteropolyacid (HPA) in an aqueous medium afforded the Mannich adduct 2′-aminobenzothiazolomethylnaphthols at 45 °C under ultrasound irradiation. This method provides several advantages such as simple work-up procedure, short reaction time and high yields.     

A Selective Release System Based on Dual‐Drug‐Loaded Mesoporous Silica for Nanoparticle‐Assisted Combination Therapy

A selective release system was demonstrated with a dual‐cargo loaded MSNs. When stimulated by different signals (UV or H⁺), this system could selectively release different kinds of cargoes individually. Furthermore, this system has been used to provide a combination of chemotherapy and biotherapy for cancer treatment. This controlled release system could be an important step in the development of more effective and sophisticated nanomedicine and nanodevices, due to the possibility of selective release of a complex multi‐drug.     

Selective Uptake of Cylindrical Poly(2‐Oxazoline) Brush‐AntiDEC205 Antibody‐OVA Antigen Conjugates into DEC‐Positive Dendritic Cells and Subsequent T‐Cell Activation

To achieve specific cell targeting by various receptors for oligosaccharides or antibodies, a carrier must not be taken up by any of the very many different cells and needs functional groups prone to clean conjugation chemistry to derive well‐defined structures with a high biological specificity. A polymeric nanocarrier is presented that consists of a cylindrical brush polymer with poly‐2‐oxazoline side chains carrying an azide functional group on each of the many side chain ends. After click conjugation of dye and an anti‐DEC205 antibody to the periphery of the cylindrical brush polymer, antibody‐mediated specific binding and uptake into DEC205⁺‐positive mouse bone marrow‐derived dendritic cells (BMDC) was observed, whereas binding and uptake by DEC205^? negative BMDC and non‐DC was essentially absent. Additional conjugation of an antigen peptide yielded a multifunctional polymer structure with a much stronger antigen‐specific T‐cell stimulatory capacity of pretreated BMDC than application of antigen or polymer–antigen conjugate.     

Combinatorially Designed Lipid‐like Nanoparticles for Intracellular Delivery of Cytotoxic Protein for Cancer Therapy

An efficient and safe method to deliver active proteins into the cytosol of targeted cells is highly desirable to advance protein‐based therapeutics. A novel protein delivery platform has been created by combinatorial design of cationic lipid‐like materials (termed “lipidoids”), coupled with a reversible chemical protein engineering approach. Using ribonuclease A (RNase A) and saporin as two representative cytotoxic proteins, the combinatorial lipidoids efficiently deliver proteins into cancer cells and inhibit cell proliferation. A study of the structure–function relationship reveals that the electrostatic and hydrophobic interactions between the lipidoids and the protein play a vital role in the formation of protein–lipidoid nanocomplexes and intracellular delivery. A representative lipidoid (EC16‐1) protein nanoparticle formulation inhibits cell proliferation in vitro and suppresses tumor growth in a murine breast cancer model.