Properties of sol-gel dip-coated zinc oxide thin films

Zinc oxide (ZnO) films were deposited on glass substrates by the sol-gel dip coating method using acrylamide route. The films were characterized by X-ray diffraction studies which indicated wurtzite structure. Optical absorption measurements indicated band gap in the range 3.17-3.32 eV. XPS studies indicated the formation of ZnO. The resistivity of the films were in the range 1000-10,000 ohm cm.     

Competitive influence of atactic polystyrene and supercritical carbon dioxide on the conformation of syndiotactic polystyrene

The crystallization behavior of miscible syndiotactic polystyrene (sPS) and atactic polystyrene (aPS) blends with different sPS/aPS weight ratios was investigated in supercritical CO₂ by using Fourier‐transform infrared spectroscopy, differential scanning calorimetry, and wide‐angle X‐ray diffraction. Supercritical CO₂ and aPS exhibited different effects on the conformational change of sPS and competed with each other. Increasing the content of amorphous aPS in the blends made its effect on the conformational change of sPS gradually surpass that of supercritical CO₂. Supercritical CO₂ favored the formation of the helical conformation of sPS in lower temperature range and the all trans planar conformation in higher temperature range, instead of forming the latter one only in higher temperature range in ambient atmosphere. However, increasing aPS content in the blends pushed the range for forming the helical conformation to lower temperature and made the all trans planar conformation dominant in aPS/sPS 25/75 blend after treating in supercritical CO₂ above 60 °C. The all trans planar zigzag conformation was more favorable than the helical conformation after mixing aPS in sPS in supercritical CO₂. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1755–1764, 2007     

Photocatalytic Synthesis of Oxygenates from Gaseous CO2 and CH4 over Semiconductor

Photoinduced synthesis of CO2 and CH4 was investigated using a batch reaction system on several photoactive materials supported on silicon dioxide. Single semiconductor showed higher selectivity to C1 compounds. The production of C2-C3 oxygenates took place preferentially on composite semiconductor photocatalysts. In particular, it was found that acetone was the primary product over Cu/CdS-TiO2/SiO2.     

Thickness dependence of free‐standing thin films

Below a critical thickness, of about 60 nm, the glass transition temperature of polystyrene (PS) films decreases with film thickness, as demonstrated using free‐standing films. A geometrical model is developed here describing this phenomenon in the case of ideal (Gaussian) chains. This model, which can be considered as an application of the free volume model, assumes that the decrease of the glass transition temperature from thick to ultrathin films is due to the modification of the interpenetration between neighboring chains. The theoretical curve deduced from the model is in excellent agreement with the PS experimental results, without using any adjustable parameters. From these results, it can be concluded that new chain motions, usually buried in bulk samples, are expressed by the presence of the surface. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 10–17, 2007     

用电泳技术制备YBCO高温超导厚膜

介绍了电泳技术制备YBCO高温超导厚膜的实验方法和YBCO高温超导厚膜的电学性质测量 ,讨论了在学生小型科研实验或设计实验中开展此实验的学时安排、注意事项和实验内容的扩展 .     

Reaction of silyl ketene acetals with epoxides: a new method for the synthesis of γ-butanolides

Titanium tetrachloride promoted reaction of silyl ketene acetals with epoxides, followed by acidic work-up, affords butanolides in moderate/good yields. With epihalohydrins the reaction is regioselective and occurs at the less substituted end of the epoxide; the γ-haloalkyl-γ-butanolides thus obtained can be further transformed into various products.     

Effect of nonstoichiometry on Raman scattering of VO2 films

We report on Raman scattering of VO2 films prepared by radio frequency magnetron sputtering under different conditions. Our investigations revealed that the dominated Raman peaks shift towards high frequency for both V-rich and O-rich VO2 films, compared with the stoichiometry VO2 films. The experimental evidence is presented and the cause for nonstoichiometry dependence of Raman spectra of VO2 films is discussed.     

Growth process of TiC clusters from Ti nanoparticles with evaporated carbon layer

Titanium carbide formation by the solid–solid reaction on the surface of Ti nanoparticles was studied in situ using a high-resolution transmission electron microscope with a heating stage. The cross-sectional image of the Ti surface was clearly observed. Vacuum-deposited carbon covered the whole the surface of Ti nanoparticles in spite of the partly evaporation on the nanoparticle surface. The diffusion of the carbon atoms inside the Ti nanoparticles depended on the size of the nanoparticles. When the Ti nanoparticle diameter was less than 30 nm, carbon atoms diffused into the Ti nanoparticle and formed TiC. The superstructure of the Ti nanoparticles was observed, which revealed the growth process of TiC to be the diffusion of carbon atoms. For Ti nanoparticles with diameter larger than 30 nm it was observed that diffusion of Ti atoms into the carbon layer was dominant, which resulted in formation of TiC in the carbon layer at the surface of Ti nanoparticles.     

Alternating copolymerization of carbon dioxide and epoxide by manganese porphyrin: The first example of polycarbonate synthesis from 1-atm carbon dioxide

The first successful example of the formation of polycarbonate from 1-atm carbon dioxide and epoxide was demonstrated by the alternating copolymerization of carbon dioxide and epoxide with manganese porphyrin as a catalyst. The copolymerization of carbon dioxide and cyclohexene oxide with (porphinato)manganese acetate proceeded under the 1-atm pressure of carbon dioxide to give a copolymer with an alternating sequence. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 3549–3555, 2003     

Structure and optical properties of lead iodide based two-dimensional perovskite compounds containing fluorophenethylamines

Phenethylammonium-based perovskites, which can be regarded as a semiconductor/insulator multiple quantum well consisting of lead halide semiconductor layers sandwiched between phenethylammonium insulator layers were prepared. To investigate the effects of the electronic state and the orientation of organic insulator layers on the optical properties of layered perovskites, fluorine substituted analogues were also prepared. The structure and optical properties were investigated by the XRD, UV–Vis absorption, and fluorescence measurements. The exciton absorption peak was shifted by the substitution of fluorine atoms in organic ammonium compounds. It became clear that the optical properties of two-dimensional perovskite compounds were controlled by the substitution of fluorine atoms.