Corrosion behavior of Nd9.4Pr0.6Febal.Co6B6Ga0.5TixCx (x=0, 1.5, 3, 6) nanocomposites annealed melt-spun ribbons

The effect of Ti and C additions on the corrosion behavior of Nd_9.4Pr_0.6Fe_bal.Co₆B₆Ga_0.5Ti_xC_x (x=0, 1.5, 3, 6) isotropic nanocomposite melt-spun ribbons in 3.5 wt% sodium chloride solution was studied. The melt-spun ribbons were annealed at 750 °C for 10 min in argon-filled quartz capsules. The microstructure of multiphase nanocrystalline samples and corrosion products was characterized using the X-ray diffraction and electron microscopy techniques. The electrochemical behavior was assessed using potentiodynamic polarization and electrochemical impedance spectroscopy. The results show that the addition of Ti and C increases the corrosion resistance of NdFeB ribbons; the best corrosion resistance was obtained for 1.5 wt% Ti and C content.     

低能Co离子注入单晶ZnO的光致发光特性

采用离子注入法研究了Co离子注入ZnO晶体的光致发光效应。 对离子注入后的样品在Ar气保护下进行退火处理, 退火温度为700 ℃, 退火时间为10 min, 在其光致发光谱中观察到了406和370 nm的紫光发射峰。 对比了Co, Cu离子分别注入的ZnO晶体的光致发光谱, 观测到二者的光致发光谱类似。 同时, 研究了Co离子注入剂量对样品发光性质的影响, 结果表明随注入剂量的增加绿色发光中心逐渐向低能边偏移, 分析认为绿色发光中心的偏移与离子注入后ZnO晶体的禁带宽度发生改变相关。 In this paper, ion implantation techniques were used to study the photoluminescence(PL) of the Co implanted crystal ZnO. After Co ion implanted, the samples were annealed at 700 ℃ for 10 min in Ar gas flow. It was observed violet emission peak of 406 and 370 nm in the PL spectrum. The PL spectra of the ZnO crystal samples which were implanted by Co ions and Cu ions, respectively, have been compared and observed that the PL spectrum of the Co implanted ZnO is similar to that of the Cu implanted ZnO. We studied the influence of implantation dose on the PL of the Co implanted ZnO and found that the green luminescence centre shifted with increasing of implantation dose. It is concluded that the shift of the green luminescence centre is related to the change of ZnO band gap which was caused by ion implantation.     

水热合成ZnS:Cu,Al纳米晶体及其全色发射光谱特性

报道了水热法(200℃)直接合成的ZnS:Cu,Al纳米晶及其发光特性.ZnS:Cu,Al纳米晶粒径约15 nm,尺寸分布窄,分散性好,具有纯立方相的类球形结构.借助X射线能谱法(EDX)和原子吸收光谱仪,研究了样品中S,Zn和Cu的含量并详细研究了光致发光(PL)光谱的特性.结果证明存在大量Zn空缺,Cu离子经过水热处理后已掺入到ZnS基体中.PL光谱特性为:样品的激发谱为宽带谱,337 nm激发时样品发出很强的绿光,370～420 nm之间任意波长激发时,发射谱均为宽带谱,且它们基本重合.表明此材料作为近紫外(370～410 nm)发光二极管((n)-UV(370～410 nm)LED)用荧光粉及全色荧光粉具有很大的应用潜力.样品在375 nm激发下全色宽带发射谱是460,510和576 nm带光谱的高斯叠加.当Cu/Zn,Cu/Al和S/Zn分别为3×10-4,2和3.0时,于室内照明条件下肉眼可观察到白色发光.     

Spectroscopic Properties and Electronic Structure of (L-Glutamato)(2, 2′-Bipyridine) copper(II)

Cu(L-glu)(bpy)(L-glu = L-glutamato; bpy = 2, 2′-bipyridine) was prepared. Its electronic absorption spectrum and photoacoustic spectrum were recorded at room temperature. They were compared with each other and compared quantitatively with ligand field theory(LFT) and the radical wave function of non-free ions^[1–3]. Therefore, the electronic structure was also investigated with its spectrum behaviors and PLFT^[1–3].     

Cu chemistry of YBa2Cu3O6+x investigated by nuclear quadrupole resonance

The nuclear quadrupole resonance (NQR) technique has been utilized to characterize the local oxygen coordination of inequivalent Cu sites in YBa₂Cu₃O_6+x(0 ≤ x ≤ 0.91). Essentially, four distinct NQR lines which correspond to 2, 3,4 oxygen coordinated Cu sites in the Cu-O chains and 5 oxygen coordinated Cu sites in the Cu-O planes have been observed. The zero-field NQR frequencies of these are centered at about 30.1, 24.0, 22.0 and 31.5 MHz for ⁶³Cu, respectively. For the antiferromagnetic ordered state (x ≤ 0.3), antiferromagnetic nuclear resonance (AFNR) has been observed at 90 MHz with quadrupole splittings associated with the moment-bearing Cu sites in the Cu-O planes. The relative intensities of these resonance lines depend on the oxygen content, and this gives us a microscopic understanding of the Cu chemistry of this system.     

On the absence of shear cracking and grain boundary cavitation in secondary tensile regions of Ti–6Al–4V–0.1B alloy during hot (α + β)-compression

Deformation instabilities, such as shear cracking and grain boundary cavitation, which are observed in the secondary tensile region of Ti–6Al–4V alloy during compressive deformation in the (α?+?β)-phase field, do not form in Ti–6Al–4V–0.1B alloy when processed under the same conditions. This has been attributed to the microstructural modifications, e.g. the absence of grain boundary α and adjacent grain boundary retained β layers and a lower proportion of 90^o-misoriented α-colonies that occur with boron addition.     

PUMP-TUNING KTP OPTICAL PARAMETRIC OSCILLATOR WITH CONTINUOUS OUTPUT WAVELENGTH PUMPED BY A PULSED TUNABLE Ti:SAPPHIRE LASER

We report on the implementation of a KTP optical parametric oscillator pumped by a pulsed tunable Ti:sapphire laser. Two major improvements were achieved, including the connection of the signal and idler tuning ranges and the high-output conversion efficiency through the signal and idler tuning ranges. Both in the signal and idler, the continuous output wavelength from 1.261 to 2.532μm was obtained by varying the pump wavelength from 0.7 to 0.98μm. The maximum output pulse energy was 27.2mJ and the maximum conversion efficiency was 35.7% at 1.311μm (signal).     

用有效折射率／有限元法设计1．55μmTi：LiNbO_3单模条波导及其方向耦合器

应用有效折射率／有限元法（ＥＩ－ＦＥＭ），考虑到ＬｉＮｂＯ３晶体和Ｔｉ扩散的各向异性，折射率增量与寻常光、非寻常光及波长色散的关系，设计了１．５５μｍ光波长下工作的ｚ切ｙ传播Ｔｉ：ＬｉＮｂＯ３单模条波导的制备参数，计算和分析了其单模特性、模式场分布及其变化规律．扩展了ＥＩ－ＦＥＭ，将其用于求解耦合波导系统，确定了方向耦合器的耦合长度及其波长色散特性．     

3dZ2基态铜(Ⅱ)冠醚配合物的粉末ESR谱

制备了两种不同基质的掺杂3d_Z²基态铜(Ⅱ)苯并15冠5配合物(Cu(Ⅱ)B15C5)的粉末样品,ESR测定结果表明,以B15C5为基质时,Cu(Ⅱ)B15C5的轴向配体是H₂O;而以Mg(Ⅱ)B15C5为基质时的轴向配体则是CIO₄^-.不同的轴向配体对ESR谱的线型有着较大的影响。利用Bleaney公式,计算了键参数,并对成键特性进行了讨论和比较。     

Improving Cu2ZnSnS4 (CZTS) solar cell performance by an ultrathin ZnO intermediate layer between CZTS absorber and Mo back contact

The effects of an ultrathin ZnO intermediate layer deposited at the CZTS/Mo interface on CZTS solar cell performance have been investigated in this work. The ZnO layer inhibits the generation of MoS₂ layer and the formation of voids in the CZTS absorber. Consequently, the incorporation of this layer reduces the series resistance and increases the shunt resistance, which boosts photovoltaic conversion efficiency from 1.13% to 4.3%. (© 2014 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)