溶剂化金属原子浸渍法制备Pd-Cu/γ-Al2O3低温CO氧化催化剂

Nano-particle Pd/γ-Al₂O₃ monometallic and Pd-Cu/γ-Al₂O₃ bimetallic catalysts were prepared by solvated metal atom impregnation (SMAI) method. The results of XRD measurement indicated that Pd- Cu alloy was formed in the bimetallic catalysts and the crystalline particle size of the alloy increased as Cu contents increased with av-erage diameters < 6.0nm for all the samples. XPS and Auger spectra showed that Pd was in zero- valent state, Cu existed mainly in zero- valent state and partially in monovalent state Cu⁺. The Pd/γ-Al₂O₃ and Pd-Cu/γ-Al₂O₃ catalysts exhibited higher activity for CO oxidation at low temperature. The activity of Pd-Cu/γ-Al₂O₃ bimetallic catalyst was higher than that of Pd/γ-Al₂O₃ monometallic catalyst. The Pd-Cu/γ-Al₂O₃ catalyst with Pd/Cu atomic ratio of 1∶1 showed the highest activity.     

Comparison of EI and metastable atom bombardment ionization for the identification of polyurethane thermal degradation products

Polyurethanes are widely used in the manufacture of commercial products such as foams and paints. During combustion, these polymers can generate isocyanates, which induce adverse health effects. Polymer pyrolysis (Py) hyphenated with mass spectrometry (MS) allows the investigation of polymer thermal degradation over time/temperature. A diphenylmethanediisocyanate (MDI) polyurethane foam was analyzed with electron ionization (EI) and metastable atom bombardment (MAB) ionization at a pyrolysis temperature of 400 °C. The recently introduced MAB ionization source uses discrete energy stored in metastable atoms of gases to ionize the analytes. This characteristic allows modulation of the ionization energy by simply changing the ionization gas. The extensive fragmentation of molecular ions observed using EI 70 eV is not totally eliminated with EI 10 eV. However, only molecular ions are observed with MAB using N₂ as the ionization gas. Temperature gradients were used to separate the products generated during the thermal degradation of a 1,6-hexamethylenediisocyanate (HDI) polyurethane paint. The analysis of mass spectra was facilitated owing to a selective desorption of pyrolysis products. Furthermore, changing the MAB ionization gas allows elucidation of the structure of the pyrolysis products by controlling the extent of their fragmentation. During these experiments, isocyanic acid, methyleneisocyanate, ethyleneisocyanate, propylisocyanate and butylisocyanate were detected.     

Synthesis of linear and starlike polymers from poly(propylene glycol) methacrylate using controlled radical polymerization

The copper‐catalyzed atom transfer radical polymerization (ATRP) of poly(propylene glycol) methacrylate (PPGM) in solution to produce linear and starlike polymers is reported, using methylethyl ketone as the solvent and a temperature of 80 °C. The ATRP system used was efficient for polymerization of the functionalized monomer without protecting hydroxyl end groups of monomer. The polymerizations were consistent with “living” or controlled processes, as revealed by the linear evolution of molecular weight with conversion. Increasing the [M]₀:[I]₀ ratio resulted in increasing molecular weights, whereas the polydispersity indices remained low (M_w/M_n < 1.4) even at high conversion. Decreasing the [CuBr]₀:[I]₀ ratio resulted in lower conversions, slightly larger polydispersities, and decreased molecular weights, likely resulting from a lower initiation efficiency. Polymers were characterized by ¹H and ¹³C NMR; molecular weights of polymers with low degrees of polymerization were estimated by end‐group analysis from ¹³C NMR spectra obtained using distortionless enhancement by polarization transfer and the gated decoupling techniques. © 2001 John Wiley & Sons, Inc. J Polym Sci Part A: Polym Chem 40: 334–343, 2002     

还原气化-原子荧光光谱法快速测定绿色食品基地土壤中的砷与汞

应用还原气化-原子荧光光谱法，使待测元素与基体自动分离、富集，测定绿色食品基地土壤中的AS、HG。经对国家经土壤标准物质进行分析证明，该方法具有快速、准确、灵敏度高等优点，用于绿色食品基地的审评检测，结果令人满意。     

过渡金属表面有机官能团硅烷膜的研究——镍电极表面γ-氨丙基三甲氧基硅烷膜的结构

在镍电极表面制备了γ-氨丙基三甲摒在硅烷膜并对其形成和结构进行了研究 。镍电极表面有机官能团硅烷膜的X射线光电子能谱（XPS）结果表明氮、硅等元素 在电极表面的存在，并且氨基在膜中有若干种存在方式，包括自由氨基和质子化的 氨基。通过对表面增强拉曼散射光谱（SERS）谱图的分析，发现与电极表面作用的 吸附基团硅醇羟基和氨基发生了竞争吸附，它们及其邻近基团的拉曼谱几随着电位 的负称除了相对强度发生变化以外，还发生了一定的位移，这缘于吸咐基团吸附的 量和吸附取向随电极电位发生了变化并形成的更为复杂的界面结构；氨基不同存在 方式之间也会随之发生转变，这一结果与X射线光电子能谱分析的结果相符合。原 子力显微镜（AFM）结果表明镍电极表面的有机官能团硅烷膜呈现为一种较规则的 多孔结构。     

Photovoltaic polymers based on difluoroqinoxaline units with deep HOMO levels

We report the synthesis of low bandgap polymers with a difluoroquinoxaline unit by Stille polymerization for use in polymer solar cells (PSCs). A new series of copolymers with 2,3‐didodecyl‐6,7‐difluoro quinoxaline as the electron‐deficient unit and alkyloxybenzo[1,2‐b:4,5‐b′]dithiophene and thiophene as the electron‐rich unit were synthesized. The photovoltaic properties of the devices based on the synthesized polymers revealed that the fluorine atoms at the quinoxaline units aid in decreasing the highest occupied molecular orbital (HOMO) energy levels; this in turn increased the open circuit voltage of the devices. The polymers with long alkyl chains exhibited good solubility that increased their molecular weight, but the power conversion efficiency was low. Efficient polymer solar cells were fabricated by blending the synthesized copolymers with PC₇₁BM, and the PCE increased up to 5.11% under 100 mW cm⁻² AM 1.5 illumination. These results demonstrate that the importance of having a control polymer to be synthesized and characterized side by side with the fluorine analogues. © 2018 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2018 , 56, 1489–1497     

Photocatalytic Activity of Supported Metal Nanoparticles and Single Atoms

Photocatalysis has been known as one of the promising technologies due to its eco-friendly nature. However, the potential application of many photocatalysts is limited owing to their large bandgaps and inefficient use of the solar spectrum. One strategy to overcome this problem is to combine the advantages of heteroatom-containing supports with active metal centers to accurately adjust the structural parameters. Metal nanoparticles (MNPs) and single atom catalysts (SACs) are excellent candidates due to their distinctive coordination environment which enhances photocatalytic activity. Metal-organic frameworks (MOFs), covalent organic frameworks (COFs) and carbon nitride (g-C₃N₄) have shown great potential as catalyst support for SACs and MNPs. The numerous combinations of organic linkers with various heteroatoms and metal ions provide unique structural characteristics to achieve advanced materials. This review describes the recent advancement of the modified MOFs, COFs and g-C₃N₄ with SACs and NPs for enhanced photocatalytic applications with emphasis on environmental remediation.     

Attapulgite grafted with polystyrene via a simultaneous reverse and normal initiation atom transfer radical polymerization

The surface grafting of attapulgite (ATP) with polystyrene (PS) was established via a simultaneous reverse and normal initiation atom transfer radical polymerization (SR&NIATRP). 4‐(chloromethyl)phenyltrimethoxysilane (CMPTMS) chemical bounded on the surface of ATP (ATP‐Cl, Cl‐I) was prepared via one‐step self‐assembly. SR&NI ATRP of styrene was conducted using CuCl₂ complex tris(2‐(dimethylamino)ethyl)amine (Me₆‐TREN) as the catalytic system, initiated by 2,2‐azobis(isobutyronitrile) (AIBN) and ATP‐Cl. FT‐IR, XRD, XPS, TGA and TEM data were consistent with the grafting of benzyl chloride groups and PS chains on ATP surface. The controllability of polymerization was investigated by the kinetics behavior under different molar ratio of AIBN and CuCl₂. The obtained polymer possessed a uniform distribution of molecular weights with a lower polydispersity index of 1.2～1.4. The relationship between polymerization on the surface of ATP and in solution was discussed in detail based on TGA data of hybrid particles and GPC trace of free polymer in solution. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2016 , 54, 1508–1516     

Solution behavior of polyimide‐graft‐polystyrene copolymers in selective solvents

A polyimide‐graft‐polystyrene (PI‐g‐PS) copolymer with a polyimide backbone and polystyrene side chains was synthesized by the “grafting from” method using styrene polymerization on a polyimide multicenter macroinitiator via ATRP mechanism. The side chain grafting density z = 0.86 of PI‐g‐PS is rather high for graft‐copolymers synthesized by the ATRP method. Molecular characteristics and solution behavior of PI‐g‐PS were studied in selective solvents using light scattering and viscometry methods. In all solvents, the backbone tends to avoid contact with a poor solvent. To describe the conformation and hydrodynamic properties of PI‐g‐PS macromolecules in thermodynamically good solvents for side chains and PI‐g‐PS, the wormlike spherocylinder model is used. Macromolecules of the studied graft‐copolymer are characterized by high equilibrium rigidities (Kuhn segment length >20 nm). In Θ‐conditions, PI‐g‐PS macromolecules may be modeled by a rigid prolate ellipsoid of revolution with a low asymmetry form and a collapsed backbone as the ellipsoid core. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2014 , 52, 1539–1546