氢部分选择性催化还原NO反应研究

在低钯含量活性非均布Pd/Al2O3催化剂上，实现了富氧条件下，氢部分选择性催化还原NO过程，低温、富氧条件下NO的转化率高达80％－100％。NO直接分解实验表明，600℃，NO分解转化率在无氧时为17．3％，有0．5％氧存在时接近于0。氢非选择性还原NO条件下，100℃以下，NO转化率为100％。根据实验结果及文献，推测了氢部分选择性还原NO过程中可能存在的反应，不同的反应温度下，NO脱除反应有所不同。在115℃以下，NO还原产物为NH3；115℃－155℃，NO还原产物为NH3、N2O和N2；155℃以上，NO还原产物中无NH3存在。NO还原反应与氢氧反应是平行的竞争反应。     

Retention characteristics of volatile compounds on tenax TA

The chromatographic separation properties of long, thin adsorption tubes enable substance-specific quantitative enrichment and reduction to be achieved when sampling and thermal desorption are carried out in the same flow direction. The specific retention volumes, and also the breakthrough and peak end volumes, of 69 compounds in the boiling range between-164 and 126°C and of a relative molecular mass between 16 and 119 were determined at temperatures between 30 and 130°C: normal alkanes, isoalkanes, cycloalkanes, alkenes, polyenes, alkynes, aromatics, ethers, alcohols, aldehydes, ketones, carboxylic acids and their esters, nitroalkanes, O-heterocycles, S-heterocycles, chloroalkanes, water, nitrogen monoxide, nitrogen dioxide, carbon dioxide, and sulfur dioxide. The correlation between adsorbent temperature and specific retention volume of these components, presented in the form of diagrams, permits the required quantity of adsorbent to be determined for a given sample volume. Contrary to literature sources, even extremely volatile compounds such as propane, propene, methanol, formaldehyde, formic acid, and chloromethane can be quantitatively retained on Tenax provided the operating conditions are appropriately selected.     

MH—Ni电池封口化成及其性能

在硼氢化钾碱性溶液中对金属氢化物（ＭＨ）电极的表面进行化学还原处理，提高了ＭＨ电极的放电容量、活化性能和电催化活性．用其为负极组装的ＡＡ型ＭＨ－Ｎｉ电池进行了封口化成，电池放电容量达到１１５０ｍＡｈ，５Ｃ下电池的放电容量达到０．２Ｃ下容量的８０％以上，电池在１Ｃ１００％ＤＯＤ（放电深度）充放电条件下，循环寿命由原来的１００次左右提高到２００次以上     

Synthesis of nitro and amino derivatives of benzothiacrown ethers

The condensation reaction of 1,2-bis(2-haloethoxy)-4-nitrobenzenes with acyclic α,ω-(oxa)alkanedithiols in the presence of alkali metal carbonates produced a series of nitrobenzodithiacrown ethers with macrocycles of different size. The structures of three ethers were established by X-ray diffraction. A new method was developed for the synthesis of nitrobenzomonothia-15-crown-5 ether. Nitro derivatives of benzodithiacrown ethers were tested as reagents for extraction of palladium(II), platinum(IV), and rhodium(III) from hydrochloric acid solutions. Extraction of Pd^II salts was found to be highly selective compared to that of Pt^IV and Rh^III salts. Benzodithia-15-crown-5 ether is the most efficient extractant for palladium(II). Reduction of nitrobenzothiacrown ethers with hydrazine hydrate in the presence of a platinum catalyst afforded their amino derivatives. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 958–966, May, 2007.     

Determination and fractionation of sulphur in a contaminated dredged sediment

Conversion of sulphur compounds in reduced, contaminated sediments that are brought in upland conditions may largely affect the potential mobility of heavy metal contaminants. We applied selected methods for the determination of total sulphur and sulphur fractions in a contaminated sediment in the reduced state and after gradual drying and oxidation during 1 month. Dry ashing, followed by ion chromatographic detection, was reliable for the determination of total sulphur. Good recoveries were obtained in both reference samples and spiked samples. Total sulphur was 14.5±0.6 g kg⁻¹ relative to dry sediment. Wet chemical methods that involve the determination of acid-volatile, Zn–HCl-reducible, chromium-reducible, acetone-soluble and HI-reducible sulphur were used to estimate specific sulphur forms. Results for acetone-soluble sulphur were to high and not consistent with results for other fractions. Major part of sulphur in the sediment (90%) was inorganic. Sulphides were converted partially to sulphate and to intermediary oxidised sulphur compounds upon oxidation of the sediment. The results suggested that the intermediary oxidised sulphur pool in the reduced sediment (2.5 g kg⁻¹) mainly consisted of pyrite, that was not converted during drying and oxidation. No significant changes in organic sulphur were detected.     

Aktivierung von CO2 an Übergangsmetallzentren: Zum Ablauf der CO2-Reduktion an Nickel(0)-Fragmenten

Activation of CO₂ at Transition Metal Centres: The Route of the CO₂ Reduction at Nikel(0) Moieties A competing reaction in the catalytic cyclooligomerization of hex-3-yne and CO₂ at the (TMED)Ni(0)-fragment (TMED = N,N,N′,N′-tetramethylethylendiamine) is the formation of carbon monoxide and (TMED)Ni(CO₃). So it is possible to explain the generation of II (TMED)Ni(diethylmalicacidanhydride) and III (a nickel trimer with two (TMED)Ni(CO₃) units). Both complexes are characterized by X-ray analysis. The reduction of CO₂ to CO most likely proceeds via an intermediate in which two molecules of carbon dioxide are coupled head-to-tail to form a metallacycle. An ab initio scf geometry optimization supports the existence of such an intermediate.     

Inorganic electrides

Inorganic electrides are a novel kind of ionic compounds in which the anions are electrons confined in a complex array of cavities or channels and the cations are nanoscale arrays of alkali metal ions that provide charge balance. In electrides the donated electron behaves like a low-density correlated electron gas, whereby the dimensionality of the electron gas and its electronic and magnetic properties are determined by the topology of the cavities in the host matrix. Unlike traditional electrides, in which alkali cations are encapsulated within an organic cage, inorganic electrides are thermally stable. The current inorganic electrides based on alkali metal loaded zeolites can be designed as useful reduced-dimensionality materials. Inorganic electrides are powerful reducing agents, and they are able to reduce small aromatic molecules to the radical anions within the channels of the zeolite.     

Electron-transfer reduction of selected alcohols with alkalide K, K(15-crown-5)2 via organometallic intermediates

The course of the reaction of alkalide K⁻, K⁺(15-crown-5)₂1 with selected alcohols depends on the kind of alcohol and the mode of substrate delivery. In the case of methanol, potassium methoxide formed initially undergoes destruction at the excess of 1. It results in potassium oxide and methylpotassium. The latter opens the crown ether ring giving potassium tetraethylene glycoxide vinyl ether and methane. A similar course of the process is observed for propanol. Potassium glycidoxide is the main product formed in the reaction of 1 with glycidol. Its oxirane ring is opened at the excess of 1. Organopotassium alkoxides, i.e., potassium potassiomethoxide and dipotassium potassiopropane-1,2-dioxide are intermediate products of this reaction. They react then with the crown ether. Potassium methoxide, potassium enolate of acetaldehyde, dipotassium propane-1,2-dioxide and potassium tetraethylene glycoxide vinyl ether are the final products of this process.     

Indium-mediated one-pot reductive conversion of nitroarenes to N-arylacetamides

N-Arylacetamides were prepared in excellent yields from nitroarenes in the presence of acetic anhydride, acetic acid and indium by a one-pot procedure.     

Comparison of reactivities of 1- and 4-oxotetrahydrocarbazoles in reactions with nucleophilic and electrophilic reagents

The half-wave potentials of polarographic reduction of the carbonyl group in unsubstituted and N-methyl- and N-phenylsulfonyl-substituted 1- and 4-oxotetrahydrocarbazoles and their reactivities in reactions with nucleophilic (NaBH₄, malonodinitrile, and cyanoacetamide) and electrophilic (DMF dimethyl acetal) reagents were compared. 4-Oxotetrahydrocarbazoles are much less reactive than 1-oxotetrahydrocarbazoles. __________ Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1832–1836, August, 2005.