间隙线性反馈控制混沌

提出了两种控制混沌的线性间隙反馈方法.该方法由控制相和非控制相组成,通过选取合适的反馈系数和控制相时间,可以获得各种不同的所需稳定的周期轨道.分别对一维的声光双稳系统和二维的类Henon吸引子进行计算机模拟,表明该方法可以使既定的系统按照给定的周期轨道演化,并且是大范围可控的. 关键词： 间隙线性反馈 混沌 类Henon映射 Lyapunov指数     

Fuzzy-PID分级控制变水量空调系统温度的研究

针对变水量空调系统温度控制的时变、大滞后、非线性特点,结合模糊控制和PID控制,设计了基于模糊规则切换的Fuzzy-PID分级控制器,并在Matlab/Simulink软件上进行了仿真。仿真结果表明,控制器同时具有模糊控制超调量小、鲁棒性好和PID控制精度高、响应速度快的优点。     

红外成像系统NETD参数测试算法及应用研究

噪声等效温差(NETD)是表征红外成像系统灵敏度的关键参数,也是评估红外成像系统性能的重要参数之一,应用广泛。通过对红外成像系统3D噪声、信号传递函数(SiTF)、NETD等参数测试方法、算法和流程研究,给出一种基于视频文件的3D噪声离线对比测试方法和一种SiTF线性区自动判断计算斜率算法,在此基础上针对某型技术保障装备国产化光电检测平台开发了配套应用软件功能模块。实现了通过计算单位均方根噪声所对应的SiTF斜率值,分析得出系统NETD参数值的功能。以某型热像仪为被测对象,开展了测试结果重复性和一致性试验,并与美国Optikos公司I-SITE红外整机测试系统进行了对比测试。实验结果表明开发的NETD参数测试功能模块测试精度和重复性满足设计要求,具有较高实用价值,已进行了工程应用。     

基于光纤锥级联结构的湿度传感器

提出了一种基于普通单模光纤粗锥级联结构的马赫-曾德尔干涉湿度传感器.将两根单模光纤对芯熔融成一个粗锥,并依次级联,形成光纤锥-单模光纤-光纤锥-单模光纤-光纤锥结构.外界环境湿度、温度的改变使传感器的纤芯基模和包层模的光程差发生改变,引起传感器干涉光谱发生变化.通过监测干涉谱波长和能量的变化实现对外界物理量的测量.实验结果表明,当空气中湿度在35~95%RH范围内变化时,传感器的湿度灵敏度为-0.065dB/%RH,线性度为0.997;当温度在30~80℃范围内变化时传感器的温度灵敏度为69.4pm/℃,线性度为0.998.该传感器可以避免温湿度的交叉影响,实现单参量的同时在线区分测量.     

��ͨ����Һ̬����ٶ���������Һ̬��¶ȷֲ���Ӱ��

应用商业软件ANSYS CFX计算了等离子体热通量和液态锂流速对自由流动液态锂温度分布的影响。计算结果表明,导向槽中心附近液态锂温度较高,冷却水入口和出口对应位置液态锂温度最低。液态锂出口温度随着等离子体热通量的增大而线性升高,冷却水流速为1.5m·s-1,热通量分别为0.1MW·m-2和1MW·m-2时,液态锂在出口处对应的温度分别为255.3°C和458.6°C。增大液态锂流速,导向槽内液态锂的温度逐渐降低,但温度变化的幅度较小。计算结果对液态锂回路安全稳定运行提供了一定参考。     

Surface reactions of monoethylgermane on Si(100)-(2×1)

The adsorption and decomposition of monoethylgermane (GeH₃Et) on the Si(100)-(2×1) surface was investigated with the intent of elucidating the surface processes leading to the deposition of germanium. The low-temperature adsorption of the molecule was explored, as well as its thermal decomposition. H₂ and C₂H₄ are observed as the desorption products in temperature-programmed desorption experiments. The ethylene is produced by a hydride elimination reaction within the adsorbed ethyl groups. The amount of Ge which can be deposited in a reaction cycle is correlated with the number of sites occupied by the ethyl groups upon the dissociation of GeH₃Et.     

Quantitative characterization of spatiotemporal patterns II

Disorderness of spatiotemporal patterns which are obtained by nonlinear partial differential equations is characterized quantitatively. The mean Lyapunov exponent for a nonlinear partial differential equation is given. The local Lyapunov exponent which is a finite time average of the mean Lyapunov exponent is shown to have close relation to the spatiotemporal patterns. It is suggested that the systems which are described by nonlinear partial differential equations are characterized statistically through the probability distribution function of the local Lyapunov exponent.     

Effective spectral emissivity measurements of superalloys and YSZ thermal barrier coating at high temperatures using a 1.6μm single wavelength pyrometer

A method which employs an integrating sphere and a single-wavelength (1.6 μm) pyrometer for measuring the spectral effective emissivities of superalloys in the temperature range (=650–1050°C) is described. The spectral effective emissivities for five superalloys, namely, MARM-247, MARM-509, CMSX-4, Inconel-718, N-155 and two René-N6 samples coated with YSZ thermal barrier coating were measured. Correcting the pyrometer measurements for the variations in the object emissivity would reduce the uncertainty in the temperature measurements to <±1%.     

Optical path automatic compensation low-coherence interferometric fibre-optic temperature sensor

An interferometric fibre-optic temperature sensing system employing a light emitting diode (LED) as the broadband optical source and a single mode fibre coil which was fabricated in a definite length as the sensor head is described. A reference fibre line transmitting back and forth along the same path as the sensing transmitting fibre is used, so the change caused by the environmental temperature fluctuation of the fibre path can automatically be compensated. The sensitivity of the sensing system can be easily improved by using the long length of the sensing fibre. The experiment results of the sensing gauge length versus the sensitivity are given. Two typical wavelengths (1300 and 1550 nm). LED sources are used, it is shown that the sensitivity of the system between the two wavelengths is different. The experimental curve of the resolution characteristic of the system related to the length of sensing fibre coil is also discussed.