Experiment on relationship between the magnetic gradient of low-carbon steel and its stress

In geomagnetic field, a series of tensile experiments on the low-carbon steel sticks were carried out. A special homemade detector was used to measure the magnetic gradient on the material surface. The results showed that the relationship between the magnetic gradient and the stress varied with different conditions of measurement. There was no obvious correlation between the magnetic gradient and the tensile stress if the sample remained on the material test machine. If the sample was taken off from the machine, the measured magnetic gradient was linear with the prior maximum stress. In Nanjing, PR China, a place of 32°N latitude, the slope of the linear relationship was about 67 (uT/m)/MPa. This offered a new method of non-destructive stress testing by measuring the magnetic gradient on the ferromagnetic component surface. The prior maximum applied stress of the sample could be tested by measuring the present surface magnetic gradient. Actually this phenomenon was the metal magnetic memory (MMM). The magnetic gradient near the stress concentration zone of the sample, the necking point, was much larger than other area. Thus, the hidden damage in the ferromagnetic component could be detected early by measuring the magnetic gradient distribution on its surface. In addition, the magnetic memory signal gradually weakened as the sample was taken off and laid aside. Therefore, it was effective for a given period of time to detect the stress or stress concentration based on the MMM testing.     

Long distance atomic teleportation with as good success as desired

Long distance atomic teleportation (LDAT) is of prime importance in long distance quantum communication. Scheme proposed by Bose et al. (1999) in principle enables us to have LDAT using cavity decay. However it gives message state dependent fidelity and success rate. Here, using interaction of entangled coherent states with atom–cavity systems and a two-step measurement, we show how, LDAT can be achieved with unit fidelity and as good success as desired under ideal conditions. The scheme is unique in that, the first measurement predicts success or failure. If success is predicted then second measurement gives perfect teleportation. If failure is predicted the message-qubit remains conserved therefore a second attempt may be started. We found that even in presence of decoherence due to dissipation of energy our scheme gives message state independent success rate and almost perfect teleportation in single attempt with mean fidelity of teleportation equal to 0.9 at long distances. However if first attempt fails, unlike ideal case where message-qubit remains conserved with unit fidelity, in presence of decoherence the message-qubit remains conserved to some degree, therefore mean fidelity of teleportation can be increased beyond 0.9 by repeating the process.     

Optical extensometer and elimination of the effect of out-of-plane motions

A novel optical extensometer is developed to estimate the local uniform strain on planar surface accurately. The proposed system consists of a shared large format lens and two image sensors, which acquire pairs of images of two isolated small regions on the object surface simultaneously. Digital image correlation (DIC) algorithm is applied to determine the relative displacement between gauge points designated on recorded pairs of images. Then local strain can be extracted after dividing the relative displacement by the scale distance. Moreover, a special experimental setup called “correction sheet” is used to eliminate the virtual strain induced by out-of-plane motions. Uni-axial tensile experiments are performed to validate the reliability and resolution of the optical extensometer, and the measurement results demonstrate that the resolution of the optical extensometer achieves 2–3 με.     

CCQM-K74国际比对中二氧化氮浓度的测量

介绍了国际比对样品中10μmol/mol NO2气体浓度精确分析方法的建立过程。该方法的建立包括标准物质的制备、分析仪器的选择和测量结果的不确定度3个主要的方面。标准物质的制备及其量值的不确定度评价采用了气体标准物质定值的基准方法——称量法。对傅立叶变换红外光谱法(FTIR)和化学发光光谱法进行了比较研究。确定了更适合于本次国际比对样品的分析方法为化学发光光谱法,测量结果的相对扩展不确定度为1.0%(k=2)。本次比对的最终结果报告显示,所建立的分析方法准确可靠。     

Ultra high performance liquid chromatography-quadrupole-time of flight analysis for the identification and the determination of resveratrol and its metabolites in mouse plasma

Resveratrol is a polyphenol that has numerous interesting biological properties, but, per os, it is quickly metabolized. Some of its metabolites are more concentrated than resveratrol, may have greater biological activities, and may act as a kind of store for resveratrol. Thus, to understand the biological impact of resveratrol on a physiological system, it is crucial to simultaneously analyze resveratrol and its metabolites in plasma. This study presents an analytical method based on UHPLC-Q-TOF mass spectrometry for the quantification of resveratrol and of its most common hydrophilic metabolites. The use of ¹³C- and D-labeled standards specific to each molecule led to a linear calibration curve on a larger concentration range than described previously. The use of high resolution mass spectrometry in the full scan mode enabled simultaneous identification and quantification of some hydrophilic metabolites not previously described in mice. In addition, UHPLC separation, allowing run times lower than 10 min, can be used in studies that requiring analysis of many samples.     

Simultaneous derivatization and air-assisted liquid–liquid microextraction of some aliphatic amines in different aqueous samples followed by gas chromatography-flame ionization detection

The paper presents a new method based on simultaneous derivatization and air-assisted liquid–liquid microextraction (AALLME) for the extraction and preconcentration of some aliphatic amines prior to gas chromatography-flame ionization detection (GC-FID). Primary aliphatic amines are derivatized and extracted simultaneously by a fast reaction with butylchloroformate (derivatization agent/extraction solvent) under mild conditions. The mixture of butylchloroformate and aqueous sample solution is rapidly sucked into a 10-mL glass syringe and then is injected into a test tube with conical bottom and the procedure is repeated seven times. After centrifuging the resulted cloudy solution, the derivatized analytes in the sedimented phase are determined by GC-FID. The influence of main factors on the efficiency of derivatization/extraction procedure is studied. Under the optimal conditions, the enrichment factors (EFs) for aliphatic amines are obtained in the range of 248–360 and limits of detection (LODs) are between 0.30 and 2.6 μg L⁻¹. The obtained extraction recoveries ranged from 50 to 72% and the relative standard deviation (RSD) was less than 4.8% for intra-day (n = 6) and inter-days (n = 4) precision. The method is successfully applied to determine some aliphatic amines in environmental water samples.     

The optimal cell gap determination of a liquid crystal wavefront corrector from a single photoelectric measurement

It has been a crucial technique to improve the dynamic response characteristics of a liquid crystal wavefront corrector (LCWFC) with optimal cell gap since the LCWFC needs at least 2π (or π) phase modulation in adaptive optics systems (AOSs). We have given a complete process for obtaining the optimal cell gap accurately from a single photoelectric measurement, which can be conducted with a liquid crystal (LC) cell of any known thickness. This method has been analysed theoretically and confirmed experimentally by using a wedge-shaped cell; the experimental results match very well with the theoretical analysis. The response time of an optimal gap cell can be a novel evaluation method of response performance of LC materials.     

Effect of a lateral methyl group on azo-mesogens containing the naphthalene moiety

Two mesogenic homologous series, 2-[4-(4-n-alkoxybenzoyloxy)-2-methylphenylazo]-naphthalenes (I) and 2-[4-(4-n-alkoxybenzoyloxy)-3-methylphenylazo]naphthalenes (II) with a lateral methyl group have been synthesized. Both series are purely nematogenic. The mesomorphic properties of both series are compared with each other and also with the properties of other structurally related series to evaluate the effect of the lateral methyl group on mesomorphism. The chiral nematic (N*) mesophase was induced in the system by doping with a derivative of naturally occurring chiral menthol.     

基于主动式时间反转镜的声呐目标强度测量研究

为提高目标强度测量过程中的抗噪声、混响以及浅海多途干扰性能,从军标文件中的目标强度测量方法以及主动式时间反转镜的基本原理出发,经过研究和推演,发现可将基于单阵元的主动式时间反转镜与相关器结合应用于目标强度测量过程,提出了一种新的目标强度测量方法。该方法利用了主动式时间反转镜的抗多途特性,使得测量具有抗多途的性能;利用噪声与信号的不相关特性,算法结合相关器起到了很好的抗随机噪声效果;混响中的体积混响是随机的,算法具有抗体积混响的性能。论文分别从理论仿真和水池实验验证了算法的有效性和正确性。