ESTIMATION OF ACTIVATED ENERGY OF DESORPTION OF n-HEXANE ON ACTIVATED CARBONS BY TPD TECHNIQUE

In this paper, six kinds of activated carbons such as Ag+-activated carbon, Cu2+-activated carbon, Fe3+- activated carbon, activated carbon, Ba2+- activated carbon and Ca2+-activated carbon were prepared. The model for estimating activated energy of desorption was established. Temperature-programmed desorption (TPD) experiments were conducted to measure the TPD curves of n-hexanol and then estimate the activation energy for desorption of n-hexanol on the activated carbons. Results showed that the activation energy for the desorption of n-hexanol on the Ag+- activated carbon, the Cu2+- activated carbon and the Fe3+- activated carbon were higher than those of n-hexanol on the activated carbon, the Ca2+- activated carbon and the Ba2+- activated carbon.     

The fundamental surface science of wurtzite gallium nitride

A review is presented that covers the experimental and theoretical literature relating to the preparation, electronic structure and chemical and physical properties of the surfaces of the wurtzite form of GaN. The discussion includes the adsorption of various chemical elements and of inorganic, organometallic and organic species. The focus is on work that contributes to a microscopic, atomistic understanding of GaN surfaces and interfaces, and the review concludes with an assessment of possible future directions.     

Au/TiO2/Ru(0 0 0 1) model catalysts and their interaction with CO

Au/TiO₂/Ru(0 0 0 1) model catalysts and their interaction with CO were investigated by scanning tunneling microscopy and different surface spectroscopies. Thin titanium oxide films were prepared by Ti deposition on Ru(0 0 0 1) in an O₂ atmosphere and subsequent annealing in O₂. By optimizing the conditions for deposition and post-treatment, smooth films were obtained either as fully oxidized TiO₂ or as partly reduced TiO_x, depending on the preparation conditions. CO adsorbed molecularly on both oxidized and reduced TiO₂, with slightly stronger bonding on the reduced films. Model catalyst surfaces were prepared by depositing submonolayer quantities of Au on the films and characterized by X-ray photoelectron spectroscopy and scanning tunneling microscopy. From X-ray photoelectron spectroscopy, a weak interaction between the Au and the TiO₂ substrate was found. At 100 K CO adsorption occurred on both the TiO₂ film and on the Au nanoparticles. CO desorbed from the Au particles with activation energies between 53 and 65 kJ/mol, depending on the Au coverage. If the Au deposit was annealed to 770 K prior to CO exposure, the CO adsorption energy decreased significantly. STM measurements revealed that the Au particles grow upon annealing, but are not encapsulated by TiO_x suboxides. The higher CO adsorption energy observed for smaller Au coverages and before annealing is attributed to a significantly stronger interaction of CO with mono- and bilayer Au islands, while for higher particles, the adsorption energy becomes more bulk-like. The implications of these effects on the known particle size effects in CO oxidation over supported Au/TiO₂ catalysts are discussed.     

铜,钾助剂对铁基催化剂吸附—脱附性能的影响

气-固相催化反应活性很大程度上依赖于反应组分在催化剂表面上的吸附与脱附行为,因此,研究反应组分在催化剂表面的吸附与脱附性质对了解催化剂表面活性部位分布、催化活性、反应机理等具有重要意义。本文用程序升温脱附(TPD)及稳态化学吸附研究了具有良好催化活性的F-T合成铁基催化剂对CO和H_2的吸附、脱附特性,并讨论了Cu、K助剂的影响。     

Polydimethylsiloxane at the interfaces of fumed silica and zirconia/fumed silica

Polydimethylsiloxane (PDMS)/fumed silica A-300 and PDMS/ZrO₂/A-300 were studied using adsorption, thermogravimetry, temperature-programmed desorption (TPD) mass-spectrometry, infrared spectroscopy, XRD, and broadband dielectric relaxation spectroscopy. ZrO₂ was synthesized on fumed silica with zirconium acetylacetonate in CCl₄ at 350 K for 1 h and calcinated at 773 K for 1 h (1-4 reaction cycles). PDMS (5-40 wt.%) was adsorbed onto silica and zirconia/silica from hexane solution and then dried. Grafted zirconia changes the chemistry of the surface (because of its catalytic capability) and the topology of secondary particles (because of occupation of voids in aggregates of primary silica particles by zirconia nanoparticles) responsible for the textural porosity of the powders. Therefore, many properties (such as structural characteristics of the composites, reactions on heating in air and vacuum, interfacial relaxation phenomena, hydrophobicity as a function of treatment temperature, etc.) of PDMS/zirconia/silica strongly differ from those of PDMS/A-300. Broadening of the α-relaxation of PDMS at the interfaces of disperse oxides suggests both weakening of the PDMS-PDMS interaction and strengthening of the PDMS-oxide interaction.     

利用混合有机空穴传输材料提升有机薄膜晶体管场效应迁移率

通过采用在并五苯薄膜与源漏电极之间插入10 nm 并五苯掺杂的N,N’-二苯基-N,N’-二（3-甲基苯基）-1,1’-联苯-4,4’-二胺薄膜的方法研究了基于并五苯有源层的底栅错面型有机薄膜晶体管的电学特性。研究发现：N,N’-二苯基-N,N’-二（3-甲基苯基）-1,1’-联苯-4,4’-二胺的引入可以有效改善有源层和源漏电极接触界面的表面形貌,利于形成欧姆接触,从而改善器件性能,最终使优化器件的迁移率由（0.1±0.01）cm²/（V·s）提升至（0.31±0.02）cm²/（V·s）,阈值电压由（－34.6±1.3）V 降至（－30.1±1.2）V。     

Acid-base properties of Ni-MgO-Al2O3 materials

Ni-MgO-Al₂O₃ materials of different Ni/Mg ratios were prepared by the co-precipitation method. Acid-base properties of the samples after calcination and reduction were examined by the temperature programmed desorption of ammonia and carbon dioxide. Thermal treatment of the materials in air at 400 °C led to the formation of hydrotalcite-like phases. The increase of Ni/Mg ratio decreased the stability of the hydrotalcite structure. The number and the strength of acid and base sites were related to the Ni/Mg ratio and thermal treatment conditions of materials. It was found that the replacement of Ni with Mg decreased the acidity and increased basicity of the surface of oxide materials. Thermal treatment of the samples in hydrogen led to the structural changes. The presence of magnesia improved thermal stability. The ratio of the number of acid to base sites in the reduced samples gradually increased with the increase of magnesia content.     

Characterization of aminophenol isomer adsorption on silver nanostructures

Surface-enhanced infrared absorption (SEIRA), temperature-programmed desorption, and density functional theory calculations were used to explore the adsorption of aminophenol isomers on vacuum deposited silver films and silver powder. Salts of the aminophenolate ions were synthesized to aid in vibrational spectral interpretation. No evidence for dissociation of any of the aminophenols into aminophenolate ions in the monolayer or multilayer was found when adsorbed on silver nanostructures (SNS). SEIRA demonstrated additional hydrogen-bonding interactions in a multilayer of 2-aminophenol and 3-aminophenol adsorbed on SNS beyond what is present in the aminophenol powders. Surface-enhanced Raman spectroscopy (SERS) experiments also showed that a 2-aminophenol monolayer adsorbed on SNS is photolytically oxidized to either 3-aminophenoxazone or 2,2′-dihydroxyazobenzene, while neither 3-aminophenol nor 4-aminophenol showed any SERS activity. This work is expected to have a significant impact in a range of environmental, biochemical, and industrial applications where phenol chemistry is important.