Synchrotron radiation circular dichroism spectroscopy of ribose and deoxyribose sugars, adenosine, AMP and dAMP nucleotides.

Synchrotron radiation circular dichroism (SRCD) spectra of ribose and deoxyribose sugars, adenosine, AMP and dAMP nucleotides and cyclic derivatives were measured in the vacuum ultraviolet region (down to 168 nm for sugars and 175 nm for adenine derivatives) and at different pH values (3, 6-7, 9-10) and temperatures (between 5 and 45 degrees C). The information content in the VUV region is important since the CD bands strongly depend on the chemical structure of the sugar, the presence and orientation of a phosphate group and the protonation state of adenine. On the other hand, single or double deprotonation of the phosphoric acid group has no influence on the spectra. We assign the vacuum ultraviolet (VUV) CD bands of the nucleoside and nucleotides to be due mainly to n-->pi* transitions in the adenine nucleobase based on a comparison with the absorption spectra. The CD bands of the sugars are due to n(O -->sigma*) transitions and are much smaller than the CD signal from the nucleotides in the VUV region. Bands are assigned to both pyranose and open-chain forms.     

Radiation formation of polymeric nanogels

An alternative method of synthesis of polymeric nanogels is proposed, based not on polymerization, but on intramolecular crosslinking of polymer chains, initiated by pulse irradiation in dilute aqueous solutions. Kinetic data show that for many water-soluble polymers irradiation under these conditions result in intramolecular crosslinking. Preliminary product studies on poly(vinyl alcohol) indicate that in fact internally crosslinked macromolecules can be obtained by this technique.     

Synthesis and polymerization of coupled compounds of 1,11-dodecadiyne

The dimer, trimer, and tetramer of 1,11-dodecadiyne, HC?C? (CH₂)₈? C?CH, were synthesized. The solid-state polymerization of the dimer was investigated by infrared (IR) spectroscopy. IR bands due to the diacetylene moiety were identified through the comparison of the IR spectra of the dimer, trimer, and tetramer. The dimer was found to have two polymorphs, melt-crystallized and solution-crystallized. Both of the polymorphs undergo solid-state polymerization by exposure to γ-ray or UV irradiation. The former has higher polymerizability for the diacetylene moiety than the latter. The solid-state polymerization of the terminal acetylene group was not observed. It is shown that the previously reported dimer structure in which both the diacetylene and terminal acetylene groups are polymerized to form an inherently electrically conducting polymer is incorrect. © 1995 John Wiley & Sons, Inc.     

Effect of γ-radiation on ointment cold cream

In this paper, Co-60γ ray was used to irradiate the ointment cold cream at room temperature (25°C). We also used FTIR, GC and thin film chromatogram to analyse various irradiated samples. It was found that the ointment cold cream can be irradiated at dose of 5–35 kGy and at dose rate from 0.2 to 0.6 kGy/h at room temperature (25°C) without evident decomposition. At dose of 5–15 kGy, the number of bacteria can be reduced to hygienic standard value. The radiation sterilization is a safe method for killing the bacteria in the ointment cold cream.     

Thermal degradation behavior of radiation synthesized polydiallyldimethylammonium chloride

Thermogravimetric analysis (TGA) and differential scanning calorimetric (DSC) studies were carried out on gamma radiation synthesized polydiallyldimethylammonium chloride (PDADMAC). The polymer was found to undergo thermal degradation in two stages. The first stage showed a weight loss of 33% and the second stage showed a weight loss of 67%. The DSC thermogram shows two endothermic peaks corresponding to the two stages in the TG thermogram and the experimental enthalpy change associated with the first and second stages were 650 J g⁻¹ and 129.5 J g⁻¹, respectively. The nth-order kinetic parameters (order of the reaction, activation energy and the pre-exponential factor) were determined from a single dynamic DSC or thermogravimetric (TG) thermogram by the method of least square. Theoretical TG/differential thermogravimetric (DTG) and DSC thermograms derived from the calculated kinetic parameters were in good agreement with the experimental ones at the heating rate employed. However, the kinetic parameters determined using TG and DSC were different. This leads to the conclusion that the degradation mechanism could be complicated and may consists of a number of parallel or consecutive reactions. The glass transition temperature (T_g) of the polymer was found to be around 150 °C depending on the test method employed.     

Analysis of low Z elements on Si wafer surfaces with synchrotron radiation induced total reflection X-ray fluorescence at SSRL, Beamline 3-3: comparison of droplets with spin coated wafers

The unique properties of synchrotron radiation, such as high incident flux combined with low divergence, its linear polarization and energy tunability, make it an ideal excitation source for total reflection X-ray fluorescence (TXRF) spectroscopy in order to non-destructively detect trace impurities of transition metals on Si wafer surfaces. When used with a detector suitable for the determination of low energy radiation this technique can be extended to the detection of low-Z elements, such as Al, Na and Mg. Experiments have been performed at SSRL Beamline 3-3, a bending magnet beamline using monochromatic radiation from a double multilayer monochromator. The wafer was mounted vertically in front of the detector, which was aligned along the linear polarization vector of the incoming synchrotron radiation. This configuration allows the detector to accept a large solid angle as well as to take advantage of the reduced scattered X-ray intensity emitted in the direction of the linear polarization vector. A comparison between droplet samples and spin coated samples was done, in order to compare the capabilities of vapor phase decomposition (VPD-TXRF) with conventional SR-straight-TXRF. Detection limits in the range of 50 fg corresponding to 2E10 atoms/cm² have been obtained for Na. The spin coated samples, prepared from solutions containing an equal amount of Na, Mg and Al showed an unexpected result when performing a scan of the angle of incidence of the incoming X-rays suggesting a different adsorption behavior of the elements in a multielement solution on the wafer surface. The observation of this behavior is important because the spin coating technique is the standard method for the preparation of surface standards in semiconductor quality control. This effect could be characteristic of the Na, Mg, Al solution used, but the angle dependence of the fluorescence signal of a standard should always be investigated before using the standard for calibration of the apparatus and quantification.     

ToF‐SIMS observation of PTFE surfaces modified by α‐particle irradiation

The surface structure of polytetrafluoroethylene (PTFE) upon α‐particle irradiation has been investigated at doses in the range of 1 × 10⁷ to 1 × 10¹¹ Rad and compared with the surface structure of the unirradiated polymer. Both neat and 25% fiberglass content PTFE were studied. The samples, maintained at nominal room temperature, were irradiated in vacuum by 5.5 MeV ⁴He²⁺ ions generated in a tandem accelerator beam line. Static time‐of‐flight SIMS (ToF‐SIMS) was employed to probe chemical changes at the surface as a function of the irradiation level. In general, the data are indicative of increased cross‐linking at α‐doses less than 1 × 10⁹ Rad, followed by increased fragmentation and unsaturation at α‐doses greater than 1 × 10⁹ Rad. Throughout the irradiation regime, scission is a constant factor promoting cross‐linking, branching, and unsaturation. However, at α‐doses greater than 1 × 10¹⁰ Rad, extreme structural degradation of the polymer becomes evident and is accompanied by conversion to oxygen‐functionalized and aliphatic compounds. Thus, for PTFE in an α‐particle field, an upper exposure limit of ～10¹⁰ Rad is essential for nominal retention of molecular structure. Finally, a quantitative relationship between α‐dose and characteristic fragment ion intensity is developed. Copyright © 2005 John Wiley & Sons, Ltd.     

一种被动式单波长实时测温系统的优化设计

基于Kirchhoff定律,利用一面反射镜,设计了一种可同时测量发射率及温度的单波长实时测温系统.从系统的测温灵敏度、相对测温灵敏度、探测器的温度分辨力及系统的测温标准差与波长的关系出发,并结合大气对红外辐射的透射特性,优化了系统的工作波长; 从系统的抗反射辐射能力与波长带宽的关系出发,并结合探测器的最小可探测光功率要求,优化了系统的波长带宽.实验结果表明,当λ=0.80 μm、Δλ=20 nm时,在测温范围600~2 500℃内,系统的测温不确定度优于0.3%.     

遗传算法优化变分模态分解提取舰船辐射噪声特征线谱方法

特征线谱提取是舰船目标识别的一个重要研究环节,常采用传统的DEMON谱分析方法,处理过程中,一般对舰船噪声时域信号未予抑噪,低信噪比情况下,传统DEMON谱分析性能差。对此,提出一种采用遗传算法优化变分模态分解方法,用于分解舰船噪声原时域信号,获得抑制噪声后的舰船噪声重构信号,进而有效提取了舰船目标噪声幅度调制特征线谱。该方法首先采用遗传算法优化变分模态分解的两个关键输入参数(分解所取模态个数和惩罚因子),对变分模态分解得到的各阶固有模态分量加以判别,去除噪声主导分量,保留信号主导分量,使重构舰船噪声信号显著抑制了干扰噪声,然后对降噪后的重构信号进行频谱分析,获得目标噪声调制特征线谱。理论分析、仿真和实验数据处理结果表明,相比传统DEMON谱分析法,基于遗传算法优化变分模态分解的舰船噪声特征线谱提取方法具有更好的噪声抑制能力,所获取的舰船噪声幅度调制特征线谱信噪比明显高于传统DEMON方法,具有一定优势,前景良好。     

Microwave Irradiation and Glutamic Acid-Assisted Phytotreatment of Tannery and Surgical Industrial Wastewater by Sorghum

We investigated how different doses of microwave irradiation (MR) affect seed germination in Sorghum, including the level of remediation against textile and surgical wastewater (WW) by modulating biochemical and morpho-physiological mechanisms under glutamic acid (GA) application. The experiment was conducted to determine the impact of foliar-applied GA on Sorghum under wastewater conditions. Plants were treated with or without microwave irradiation (30 s, 2.45 GHz), GA (5 and 10 mM), and wastewater (0, 25, 50, and 100). Growth and photosynthetic pigments were significantly decreased in plants only treated with various concentrations of WW. GA significantly improved the plant growth characteristics both in MR-treated and -untreated plants compared with respective controls. HMs stress increased electrolyte leakage (EL), hydrogen peroxide (H₂O₂), and malondialdehyde (MDA) content; however, the GA chelation significantly improved the antioxidant enzymes activities such as ascorbate oxidase (APX), superoxide dismutase (SOD), peroxidase (POD), and catalase (CAT) both in MR-treated and -untreated plants under WW stress compared with respective controls. The results suggested that the MR-treated plants accumulate higher levels of HMs under GA addition in comparison to the WW-only-treated and MR-untreated plants. The maximum increase in Cd accumulation was observed in the range of 14–629% in the roots, 15–2964% in the stems, and 26–4020% in the leaves; the accumulation of Cu was 18–2757% in the roots, 15–4506% in the stems, and 23–4605% in the leaves; and the accumulation of Pb was 13–4122% in the roots, 21–3588% in the stems, and 21–4990% in the leaves under 10 mM GA and MR-treated plants. These findings confirmed that MR-treated sorghum plants had a higher capacity for HMs uptake under GA and could be used as a potential candidate for wastewater treatment.