SAPO-34分子筛骨架稳定性的研究

利用差热分析，原位ＸＲＤ技术，高温条件下的焙烧和水蒸气处理并关联其催化性能变化，研究了ＳＡＰＯ－３４分子筛的热及水热稳定性，差热分析结果表明，ＳＡＰＯ－３４的骨架破坏温度高于１３００Ｋ，原位ＸＲＤ跟踪研究证实，ＳＡＰＯ－３４分子筛原粉在高温焙烧以除掉有机胺及随后的降温过程中无明显的骨架破坏；而焙烧型ＳＡＰＯ－３４在空气中放置一定时间后，水分子吸附微孔中明业降低样品的ＸＲＤ峰强度，且降低幅度随放置时     

Stopped-flow injection analysis. The influence of diffusion on dispersion of normal and reverse flow injection

A relationship is derived to enable the comparison of the dispersion heights of normal and reverse flow injection analysis (FIA). A single channel flow system is employed in the absence of a chemical reaction. The stopped-flow injection method is used to probe the influence of molecular diffusion on the overall dispersion of normal and reverse FIA, which appeared to demonstrate fundamentally different diffusion behaviors. Small discrepancies are observed between the dispersion heights, which are enhanced by the stopped-flow period, especially when unmatched matrix ionic compositions of the indicator and counter solutions were involved. For these conditions, the diffusion flux rate is enhanced considerably, displaying a peak, in addition to the transient, for both methods. The influence of diffusion on the dispersion characteristics of normal and reverse FIA is discussed theoretically. Diffusion in the proposed model is postulated to oppose dispersion by convection. The latter initiates concentration gradients in the injection zone and propagates it with flow time over the dispersion zone profile. The diffusion flux then reacts in order to confine the indicator dispersion for normal FIA and to enhance it for reverse FIA. This model is consistent with the experimental results and accounts for most of the phenomena encountered. Probably owing to the influence of secondary flow phenomena, the use of coiled tubes has suppressed the effects of diffusion on the overall dispersion behavior.Part of the experimental work was performed at IMI Institute for Research and Development, Haifa, Israel.     

Surface chemical analysis of raw cotton fibres and associated materials

The surface chemical composition of raw unscoured cotton was successfully investigated by the surface analytical techniques X-ray Photoelectron Spectroscopy (XPS) and Time of Flight Secondary Ion Mass Spectrometry (ToF-SIMS). The presence of non-cellulosic material at the fibre surface was established and determined to be a complex mixture of fatty acids, alcohols, alkanes, esters and glycerides. The effect of scouring and bleaching was to reduce the surface concentration of these materials but even after aqueous processing some non-cellulosic material residue was still detected at the fibre surface.     

Sample enrichment by using monolithic precolumns in microcolumn liquid chromatography

An on-line sample enrichment system was designed using monolithic precolumns in microcolumn LC. The monolithic ODS capillary columns were prepared via in situ sol-gel processes. The enrichment efficiency of the monolithic columns was tested by using phthalates as the analytes. The relative standard deviations (n = 6) for the retention time, peak area and peak height were between 0.4 and 1.2%, 0.9 and 5.5% and 0.4 and 3.9%, respectively. The system was linear (R2 > 0.99) within the working sample concentration and sample volume ranges. Comparing to 0.2 microl injection with a typical sample injector, the theoretical plate number of a same separation column was increased by 3-6-fold when the precolumn unit was used for sample injection. The recoveries of the analytes were between 88 and 120%, and the sample volume that could be injected into the system was increased up to 5000-fold. The limits of detection were improved by more than 2000-fold and were between 0.21 and 0.87 ng ml(-1) even with a UV absorbance detector. This system was applied to the determination of phthalates contained in laboratory distilled water and tap water samples.     

Isolation and purification of honokiol and magnolol from cortex Magnoliae officinalis by high-speed counter-current chromatography

High-speed counter-current chromatography was used to isolate and purify honokiol and magnolol from cortex Magnoliae Officinalis (Magnolia officinalis Rehd. et Wils.), a plant used in the traditional Chinese medicine. A crude sample, 150 mg, was successfully separated with a two-phase solvent system composed of n-hexane-ethyl acetate-methanol-water (1:0.4:1:0.4, v/v), and the fractions were analyzed by high-performance liquid chromatography. The separation produced 80 and 45 mg of honokiol and magnolol with purities of 99.2 and 98.2%, respectively, in 2.5 h.     

Analyzing functional similarity of protein sequences with discrete wavelet transform

This paper applies discrete wavelet transform (DWT) with various protein substitution models to find functional similarity of proteins with low identity. A new metric, 'S' function, based on the DWT is proposed to measure the pair-wise similarity. We also develop a segmentation technique, combined with DWT, to handle long protein sequences. The results are compared with those using the pair-wise alignment and PSI-BLAST.     

Study of cork (from Quercus suber L.)-wine model interactions based on voltammetric multivariate analysis

The cork from Quercus suber L. is the premium raw material used to produce wine-bottling stoppers; however, being a natural product, cork can be contaminated and attacked in different ways that could promote differences in its proprieties. A specific contamination is the defect known in the industry as “Mancha Amarela—Yellow spot” (MA). This cork shows modifications in its mechanical, structural and optical properties and is potentially able to cause off-flavours in wine. In this study, a new analytical approach is proposed for the rapid screening of cork-wine model interactions in order to determine if the cork were able to contaminate a wine. Cork samples classified as standard (S) and cork MA were put in contact with a wine model matrix. The model matrix was analysed by cyclic voltammetry and square wave voltammetry in function of different contact times. Considering that matrices in contact with cork S and MA exhibited different pH, the influence of this parameter on the distinction power was also evaluated. The data sets obtained from the different techniques were treated by principal component analysis (PCA) and PLS_Cluster. The major difference between samples S and MA is the occurrence of an important peak at ca. 580 mV in the MA voltammograms. This more positive peak may be assigned to lignin related phenolics; therefore, it can be proposed as a possible marker to follow lignin degradation.     

Characterisation of Sugar Cane Combustion Particles in the Araraquara Region, Southeast Brazil

Biomass burning is an important primary and secondary source of aerosol particles. The presence of carbonaceous particles in the respirable size range makes the study of this fraction important in view of possible health and climatic effects. The annual burning of sugar cane plantations causes emission of huge amounts of pyrogenic particles. Aerosol samples were collected in Araraquara city, São Paulo state, Brazil, during the harvest season for fine and coarse particles and bulk; they were analysed by electron-probe microanalysis, including facilities for low-Z element determination (low-Z EPMA) and by energy-dispersive X-ray fluorescence (EDXRF), in order to investigate the elemental composition of individual particles and bulk samples, respectively. Numerical analysis of the EPMA results by hierarchical clustering shows high contributions of carbonaceous particles that can be distinguished mainly in two different types: biogenic and carbon-rich. Additionally, two significant contributions of aluminosilicate particles were identified: as rather pure aluminosilicates or mixed with carbonaceous species. The EDXRF results are compatible with those of aerosol particles in Amazon, which is nowadays one of the main sources of biogenic particles in the world.     

主成份分析-偏最小二乘法分光光度法同时测定钴、镍、铜、锌四组份体系

用 PCA 及 PLS 分步处理分光光度数据,有效降低了计算的维数。以该法对不同酸度体系的5-Br-PADAP-钴、镍、铜、锌分光光度数据进行了处理,定量分析结果良好。