Novel fixed‐site–carrier polyvinylamine membrane for carbon dioxide capture

Fixed‐site–carrier membranes were prepared for the facilitated transport of CO₂ by casting polyvinylamine (PVAm) on various supports, such as poly(ether sulfone) (PES), polyacrylonitrile (PAN), cellulose acetate (CA), and polysulfone (PSO). The cast PVAm on the support was crosslinked by various methods with glutaraldehyde, hydrochloric acid, sulfuric acid, and ammonium fluoride. Among the membranes tested, the PVAm cast on polysulfone and crosslinked by ammonium fluoride showed the highest selectivity of CO₂ over CH₄ (>1000). The permeance of CO₂ was then measured to be 0.014 m³ (STP)/(m² bar h) for a 20 μm thick membrane. The effect of the molecular weight of PVAm and feed pressure on the permeance was also investigated. The selectivity increased remarkably with increasing molecular weight and decreased slightly with increased pressure in the range of 1 to 4 bar. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4326–4336, 2004     

Effects of poly[styrene‐b‐(ethylene‐co‐butylene)‐b‐styrene] on the charge distributions of low‐density polyethylene/polystyrene blends

The effect of the triblock copolymer poly[styrene‐b‐(ethylene‐co‐butylene)‐b‐styrene] (SEBS) on the formation of the space charge of immiscible low‐density polyethylene (LDPE)/polystyrene (PS) blends was investigated. Blends of 70/30 (wt %) LDPE/PS were prepared through melt blending in an internal mixer at a blend temperature of 220 °C. The amount of charge that accumulated in the 70% LDPE/30% PS blends decreased when the SEBS content increased up to 10 wt %. For compatibilized and uncompatibilized blends, no significant change in the degree of crystallinity of LDPE in the blends was observed, and so the effect of crystallization on the space charge distribution could be excluded. Morphological observations showed that the addition of SEBS resulted in a domain size reduction of the dispersed PS phase and better interfacial adhesion between the LDPE and PS phases. The location of SEBS at a domain interface enabled charges to migrate from one phase to the other via the domain interface and, therefore, resulted in a significant decrease in the amount of space charge for the LDPE/PS blends with SEBS. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2813–2820, 2004     

厚度对非极性聚合物薄膜驻极体电荷储存及电荷动态特性的影响

以Du Pont公司的商用Teflon FEP A型薄膜为例，通过热脉冲技术、等温表面电位衰减测量和开路热刺激放电电流谱分析等实验结果，讨论了经常温和高温电晕充电后样品厚度对薄膜驻极体的沉积电荷密度、薄膜驻极体的内电场、体电导率以及电荷储存稳定性的影响.通过热脉冲技术组合电导率温度曲线的测量，研究了在不同温度条件下样品厚度对沉积电荷层的平均电荷重心移动的影响.结果表明：在充电参数一定的条件下，随着膜厚的降低，储存电荷密度上升，但电荷稳定性有所下降.因此，合理地调控薄膜厚度，可以有效地优化驻极体的电荷储存能 关键词： 厚度 驻极体 电荷储存能力 电荷稳定性     

静电加速管中强流空间电荷效应的研究

 对一种工业用大功率电子加速器(450kW)的加速管中的空间电荷效应作了5点假设，建立了物理模型。对模型的束内外径向电位分布、空间电荷对轴上电位的影响，以及空间电荷力对束流传输的影响等进行了理论分析，得到了束内径向电位分布。结果表明：束流内部径向电位沿径向均呈抛物线变化，并在轴上达到最小值；而空间电荷产生的束内电场与半径呈线性变化；空间电荷不仅会引起轴上电位的跌落，而且对束流有发散作用，特别是在电子速度较低时更为明显。在考虑了空间电荷效应后，强流静电加速管的电场设计关键在加速管的前端，与弱流加速管相比，强流加速管的电场变化要大得多。     

The First Intramolecular Charge Transfer Transition Based on 2-Ureido-4[1H]-pyrimidinone Binding Module

The first intramolecular charge transfer transition based on 2-ureido-4[1H]-pyrimidinone binding module was reported.     

The Isoelectric Point and the Points of Zero Charge of Fe-Al-Mg Hydrotalcite-like Compounds

The relation of the isoelectric point (IEP) and the point of zero net charge (PZNC) of the hydrotalcite-like compounds was discussed. It was found that the IEP does not equal to the PZNC and the IEP is higher than the PZNC. The structural positive charges existing in the HTlc,which cause the difference between the IEP and the PZNC. The effects of the structural positive charges of the HTlc on its IEP and PZNC are the same as the specific adsorption of metal cations.     

Demand variability and incentives in inventory-based contracts

We present some results on the impact of demand variability on stocking policies and incentives to forecast, in the context of single period inventory-based contracts in a manufacturer-retailer channel.     

Robust linear optimization under general norms

We explicitly characterize the robust counterpart of a linear programming problem with uncertainty set described by an arbitrary norm. Our approach encompasses several approaches from the literature and provides guarantees for constraint violation under probabilistic models that allow arbitrary dependencies in the distribution of the uncertain coefficients.     

Modelling of an underground waste disposal site by upscaling

In this paper, we study the global behaviour of an underground waste disposal in order to have an accurate upscaled model suitable for the computations involved in safety assessment processes. We start from a detailed model describing the transport of pollutant leaking from a high number of units. Using the method of homogenization, going to the limit, we obtain first a macroscopic model where the sources are now appearing globally. Then we compute a first‐order matched asymptotic expansion and we give the error estimates for this approximation. Copyright © 2004 John Wiley & Sons, Ltd.     

Some Notes about Tanaka''''s Equation

ＳｏｍｅＮｏｔｅｓａｂｏｕｔＴａｎａｋａ＇ｓＥｑｕａｔｉｏｎＹａｎＺｈｉｂｉｎ（严质彬）（ＤｅｐａｒｔｍｅｎｔｏｆＭａｔｈｅｍａｔｉｃｓ，ＨａｒｂｉｎＩｎｓｔｉｔｕｔｅｏｆＴｅｃｈｎｏｌｏｇｙ，Ｈａｒｂｉｎ，１５０００１）ＡｂｓｔｒａｃｔＬｅｔ｛Ｗｔ...