火花激发原子发射光谱分析不锈钢线材

火花激发原子发射光谱法应用于直径小于8mm的不锈钢线材的分析，对此类试样应用了一种特制的夹具，用块状标准样品制作工作曲线。由于线状试样和块状标准样品之间的形状差异所产生的系统不确定度借采用同类型标样作校正，对共存元素的相互干扰也采用了相应的校正方法。其它分析条件，包括严格的制样工序，氩气的纯度要求及其流量控制，以及光源的最佳条件等，作了深入的试验。按所提出的方法测定了不锈钢线材试样中碳、硅、锰、磷、硫、铬、镍及钛等8个元素。经校正后的结果与化学法测得结果相符。     

毛细管电泳-电感耦合等离子体原子发射光谱法对田七提取液中Fe、Cu和Mg存在状态的研究

提出了以水作溶剂微波萃取提取,并以毛细管电泳电感耦合等离子体原子发射光谱(CE-ICP-AES)法测定田七提取液中Mg、Cu和Fe的形态的分析方法。实验结果表明:Mg仅以游离态存在;而Cu和Fe除了游离态以外,还存在其它三种未知的形态。此外,还测定了田七中20个微量元素的总含量,并得到了上述待测元素在水提取液中的提取率。     

2，4，6－三苯基氧鎓盐分子内旋转受阻对其发光行为的影响

研究了４－位苯基取代基旋转受阻和旋转自由的２，４，６－三苯基氧盐的光物理性质。实验结果表明，当４－位苯基取代基旋转受阻时，氧盐化合物在激发态时引起的分子内极化程度比４－位取代基旋转自由的氧盐化合物大，即在激发态时旋转受阻氧盐化合物发生的分子内电荷转移能力较强；４－位取代基旋转自由的化合物的荧光量子产率随溶剂粘度的增大而有所增大，但旋转受阻化合物在相同的条件下则出现相反的结果。实验结果还表明，４－位取代苯基旋转受阻对化合物的荧光发射不利。     

La2O3,Y2O3-Mo次级发射材料研究

采用粉末冶金方法制备了La2O3，Y2O3-Mo次级发射材料，测试了各种材料的次级发射系数。结果表明在钼中加入稀土氧化物可以具有很好的次级发射性能。经过激活处理后，材料的最大次级发射系数均高于2．0，达到了材料使用要求的发射水平。应用扫描电镜(SEM)和光电能谱仪(XPS)研究了稀土元素在烧结体断口和发射前后在试样表面的分布情况。分析结果表明稀土元素易于在晶界处偏聚，且发射后试样表面稀土元素的相对浓度明显高于发射前的浓度。     

用TMS—2型热机分析仪测量热释蠕变

对已经商品化的Perkin-Elmer TMS-2型热机分析仪进行改进,用来测量聚合物材料的热释蠕变行为。按照7SCr分步加载的程序,用弯曲法测量了-83～300℃温度范围内低密度聚乙烯的玻璃化转变松弛过程,并从TSCr谱上计算其相应的分子参数,实验结果与用扭转的TSCr方法所得结果相等,因此这是一种研究聚合物材料松弛行为的方便可行的技术。     

Slurry nebulization ICP-AES spectrometry method for the determination of tin in organotin(IV) complexes

This paper proposes a quick, novel method for tin determination in organotin chemicals by slurry nebulization inductively coupled plasma atomic emission (ICP-AES) spectrometry. The method was tested by the measurement of five organotin carboxylate complexes of known composition for obtaining simple stoichiometric data. The slurries were prepared by first dissolving the organotins in an adequate solvent (methanol, pyridine or acetone) well miscible with water and then adding this solution drop-by-drop to a 0.005% TX-100 tenzide solution while maintaining intensive mixing. Dynamic laser light scattering experiments showed that the average equivalent particle size in the resulting slurry was ≈0.3 μm for all samples and solvents. Under suitable ICP-AES measuring conditions, the signal recoveries were found to be between 101.8 and 106.6%, which allowed direct nebulization and calibration against aqueous solutions. Typically, 70 μg l⁻¹ detection limit and 1–5% relative S.D. on five replicates can be achieved by the described method.     

Study on the Phase Diagram of CsCl-CeCl3-HCl(11%)-H2O System and the Properties of the Compounds

The equilibrium solubility of CsCl-CeCl3-HCl(11%)-H2O qua-ternary system at 25℃ has been determined by the physicchemical analysis method ,and the phase diagram was plotted, Two new double salts 3CsCl.CeCl3.3H2O and CsCl.CeCl3.4H2O obtained from the complicated system were identified and characterized by XRD,TG-DTA ,DSC,UV and fluorescence spectroscopy, Studies on the fluorescence excitation and emission show that 3CsCl.CeCl3.3H2O and CsCl.CeCl3.4H2O have upconversion luminescence of infrared-visible range,and the upconversion emission intensity increases with the increase of ratio of CeCl3 in CsCl.     

盐酸浸提-电感耦合等离子体发射光谱法测定烟草中的多元素

研究了用5mol/L盐酸煮沸提取烟叶中的部分金属元素，用ICP－AES测定浸提液，K、Ca、Mg、Cu、B、Ba、Zn获得了较满意的结果，P、Fe、Mn的测定结果稍微偏低。此方法操作简便、快速安全，特别适合大批量烟草样的快速检测。与硝酸－高氯酸湿消化法进行对照，结果吻合得较好。并测定了国家烟草标准样品GBW08514和GBW08515，其结果与标准值相符。     

Determination of chloride ion in aqueous samples by isotope-dilution Fourier-transform flame infrared emission (ID-FIRE) spectrometry

An isotope dilution method for the determination of chloride ion in aqueous samples is described. The method makes use of the isotopic shift in the rotational lines of the 1–0 band of HCl emitted in the near infrared region of the spectrum by vibrationally excited HCl molecules present in a hydrogen/entrained air flame. Chloride ion in the sample is converted to chlorine gas by electrolysis and swept into a hydrogen/entrained air flame where it is converted into HCl. Because isotope dilution is an absolute method of analysis, matrix effects are minimized, and the chlorine generation step need not be quantitative. With the system described in this paper, samples must contain at least 9 mg of chloride ion per ml, and a 2-ml sample is required. Over the range from 10 to 30 mg Cl⁻ ml⁻¹, the average error was −0.96%, and the average relative standard deviation was 3.3% for seven samples using seven of the more intense lines in the P branch. Compared with standard silver nitrate titrations, the isotope dilution procedure was not affected by such common interferences as bromide ion and iodide ion. The technique was applied to several seawater samples from different regions.     

光谱实验室的建设和管理

阐述冶金、铸造等行业用于金属成分分析的直读发射光谱仪实验室的建设和管理。从仪器的调研、选型，实验室选址，基础设施设备的准备，仪器的安装、调试、验收、日常分析，实验室管理等几个方面，分别作了介绍。