退火温度对TiO2/CdSe纳米片异质结薄膜光电性能的影响

采用水热法在FTO上制备（001）高活性晶面主导的TiO₂纳米片薄膜,利用循环伏安法在TiO₂纳米片薄膜上沉积CdSe颗粒,制备了TiO₂/CdSe纳米片异质结薄膜。分别在150、250、350、450 ℃,氩气保护气氛中对样品进行退火。利用X射线衍射仪（XRD）、场发射扫描电镜（FESEM）、X射线光电子能谱分析仪（XPS）、紫外-可见（UV-Vis）分光光度计以及电化学工作站对不同温度退火后的TiO₂/CdSe纳米片异质结薄膜的微观形貌、晶体结构、光电化学性能进行表征和测试。结果表明：六方相CdSe纳米颗粒均匀包覆在TiO₂纳米片表面,直径30 nm左右;随着退火温度的升高CdSe纳米颗粒长大,形成光滑的CdSe薄膜,且晶化程度提高;TiO₂纳米片表面的Se元素与Cd元素发生氧化;TiO₂/CdSe纳米片异质结薄膜对可见光的吸收光谱发生红移,禁带宽度逐渐减小。光电化学性能测试表明随着退火温度的升高,TiO₂/CdSe纳米片异质结薄膜的光电流密度显著提高,开路电压减小,但由于SeO2和CdO的出现,导致填充因子减小,影响光电转换效率的提高。在本实验条件下,TiO₂/CdSe纳米片异质结薄膜的最佳退火温度为150 ℃,填充因子为0.77,光电转换效率达到3.12%。     

Statistical discrimination of steroid profiles in doping control with support vector machines

Due to their performance enhancing properties, use of anabolic steroids (e.g. testosterone, nandrolone, etc.) is banned in elite sports. Therefore, doping control laboratories accredited by the World Anti-Doping Agency (WADA) screen among others for these prohibited substances in urine. It is particularly challenging to detect misuse with naturally occurring anabolic steroids such as testosterone (T), which is a popular ergogenic agent in sports and society.     

煤中痕量元素在循环流化床锅炉中的迁移行为与富集特性

对天津市某电厂循环流化床(CFB)锅炉燃用的原煤及燃烧产物底灰、飞灰、细飞灰(≤50 μm)进行痕量元素含量的测定,分析了Be、Zn、Hg、V、Cr、Mn、Co、Ni、Cu、As、Se、Cd、Pb 13种痕量元素在燃烧过程中的迁移行为,揭示了痕量元素在CFB锅炉中的分配、富集特性。结果表明,CFB锅炉中,较低的炉温对于痕量元素的迁移富集产生了较大的影响。由相对富集系数得知,Be、V、Co、Se在底灰中耗散,在飞灰中富集,Zn、Mn倾向于在底灰中富集,元素Cd、Pb、Ni、Cu挥发性较强,在底灰和飞灰中均是耗散。As受钙氧化物影响,挥发性表现并不明显。Hg在底灰和飞灰中相对富集系数均很低,表明Hg在整个燃烧过程中以气态形式排放;Hg、As、Se、V、Cr、Mn、Co、Ni、Cu、Zn、Pb均有向小颗粒物中富集的趋势。根据相对富集系数以及研究的13种元素在低温CFB锅炉中的迁移行为,将这些元素分为三类:A类(E_R<0.1),主要是以气态形式排放元素Hg;B类(0.1R≤0.85),较易挥发元素As、Be、Ni、Cu、Se、Cd、Pb、Co、V;C类(E_R>0.85),主要残留在固体产物中元素Zn、Mn、Cr。     

蒸汽活化生物质焦吸附模拟烟气中SO2和NO的研究

以麦秆和稻壳生物质为研究对象,在不同的热解温度、热解速率以及蒸汽活化温度条件下制备了生物质焦,采用比表面积与孔隙度分析仪测定生物质焦的比表面积和孔隙结构参数。利用固定床吸附装置,研究了热解温度、热解速率、活化温度和模拟烟气中SO₂和NO浓度等因素对生物质焦吸附SO₂和NO性能的影响。结果表明,蒸汽活化可以显著提高生物质焦的BET比表面积、D-R比表面积、D-R微孔容积和总孔容,降低其平均孔径,并显著增加蒸汽活化生物质焦对SO₂与NO吸附的起始穿透时间和吸附量。快速热解下制得的蒸汽活化焦对SO₂和NO的吸附效果优于慢速热解,热解温度为873 K的蒸汽活化焦的吸附性能明显好于热解温度为673与1 073 K的蒸汽活化焦。在973~1 173 K下,随着蒸汽活化温度的提高,蒸汽活化生物质焦对SO₂和NO的吸附量呈现先上升后下降的趋势。随着模拟烟气中SO₂与NO浓度的降低,蒸汽活化生物质焦对SO₂与NO吸附的起始穿透时间延长,但相应的SO₂和NO吸附量下降。在873 K、快速热解和1 073 K条件下制得的蒸汽活化麦秆焦对SO₂和NO吸附量最大,其值分别为109.02和21.77 mg/g。     

Effect of Ultra High Pressure Processing on the Particle Characteristics of Lotus-seed Starch

In this paper, the time dependent effects of various pressure treatments on the characteristics of lotus-seed starch which was modified by ultra-high pressure (UHP) were investigated. The results showed that the polarization cross of lotus-seed starch granules was weakening gradually with increasing the treatment time, which indicated the termination of their ordered crystallite structures. The morphologies of granules were collapsed once the UHP was kept at 500 MPa for 60 minutes. The particle size analysis demonstrated that the granule size and distribution of lotus-seed starches increased as the treatment time was prolonged. X-ray diffraction studies showed that the intensity of the feature diffraction peaks of starch decreased and eventually disappeared with increasing the treatment time, and B-type transformation pattern was observed. The Fourier transform infrared spectra (FTIR) analysis of starch showed that the UHP is a physical modification processing because no new groups formed. The research showed that UHP processing at certain degree is capable to achieve the modification of lotus-seed starch. It is of significance for the deep processing of lotus-seed products.     

A re-examination of platinum-group element concentrations in the environmental certified reference material BCR-723

A detailed statistical examination of replicated data used to certify platinum-group elements (PGEs) in environmental reference material BCR-723 is presented. Certification of Pt, Pd, and Rh concentrations in BCR-723 was based on 16, eight, and nine accepted data sets, respectively. Each accepted data set contained six replicated measurements for each PGE, and the statistical properties of these concentration data were examined, i.e. 96 for Pt, 48 for Pd, and 54 for Rh. This level of investigation has received limited attention but is critical in furthering our understanding of PGE variability and representativeness. Concentrations of Pt, Pd, and Rh were shown to differ significantly between accepted data sets. Palladium and Pt differed in their quantification between detection techniques. Additionally, Pd and Pt concentrations varied significantly between laboratories using a similar definitive method (inductively coupled plasma-isotope dilution mass spectrometry). The distribution of Pd concentrations was found to be bimodal, with a secondary population exhibiting a contamination signal of about 15%. The secondary population, not previously reported in BCR-723, is likely a measurement artifact and not due to a nugget effect. Comparisons of BCR-723 with other environmental media from Europe, i.e. airborne particulate matter, tunnel dust, and road-deposited sediment, indicated that Pd is uncommonly low in BCR-723 (6.0?ng?g^?1) and is generally not representative in terms of its distribution relative to Pt and Rh. Serious consideration should be given to developing a new PGE certified environmental reference material.     

Effect of Experimental Variables on the Combustion Characteristics of Water-in-Diesel Emulsion Fuels

Water-in-diesel (W/D) emulsion fuels were prepared through an ultrasonic processor by using high energy emulsification method. Accordingly, the physical and chemical properties were analyzed. A decrease in viscosity was found in the emulsion fuel in contrast to the neat diesel which signifies the enhanced fluidity of the fuel. The emulsion fuel was then used to carry combustion tests in an internal combustion engine. A decrease in exhaust temperature was observed when a high surfactant to water ratio was used, which lead to minimal heat loss. As water is emulsified with diesel, effectiveness of combustion is improved rather than neat diesel fuel. It was also explored that the addition of water-in-diesel is influential in terms of reduction in exhaust gas emission such as carbon dioxide, carbon monoxide, ammonia from the internal combustion engine. Therefore, this type of emulsion fuel would be a useful contribution in the fuel economy, but also in making it environmentally friendly since diesel fuel is now considered one of the leading fuels causing ecological contamination.     

增压O_2/CO_2气氛下煤燃烧特性实验研究

增压O2/CO2燃烧是一种可高效分离回收CO2的新兴燃烧技术,其燃烧机理与常压空气、常压O2/CO2燃烧存在较大差异。在加压热重分析仪上研究了增压条件下总压、氧浓度、气氛及粒径等反应参数对美国烟煤和淮北无烟煤燃烧特性的影响,确定了煤的着火温度,并对其进行燃烧动力学分析。结果表明,增压O2/CO2气氛下,随着压力或氧浓度的增加,DTG曲线向低温区移动,煤样整体燃烧速率加快。压力提升、氧浓度增加及煤粉细化均可改善O2/CO2气氛下煤样的着火特性。常压O2/CO2气氛下煤粉燃烧基本属于一级反应;增压O2/CO2气氛下,低温区属于0.5级反应,而高温区属于1.5级反应。     

The Enrichment of Stale Tailings of Bom-gorhon Tungsten Ore Deposits

The results of mineralogical studies of technogenic tungsten raw material (stale tailings of Bom-Gorhon deposit) are represented. Its particle size distribution as well as tungsten and accompanying element distribution among the fractions were determined. The necessity of grinding the heaps down to 0.2-0.25 mm in size was established. It allows increasing the recovery rate of two or more times in comparison with the traditional pattern of tailing processing.