p型导电掺In的SnO2薄膜的制备及表征

采用溶胶-凝胶提拉法成功地制备了p型导电掺In的SnO2薄膜.x射线衍射测试结果表明，掺In的SnO2薄膜保持SnO2的金红石结构.吸收谱测试结果表明，掺In的SnO2禁带宽度为3.8eV.霍尔测量结果表明，空穴浓度与热处理温度有很大的关系，525℃为最佳热处 理的温度.铟锡原子比在0.05—0.20范围内，空穴的浓度与In的含量有直接的关系，并随In含量的增加而增加. 关键词： SnO2 溶胶-凝胶法 p型导电     

Mg,Al掺杂对LiCoO2体系电子结构影响的第一原理研究

为了研究Mg ,Al掺杂对锂二次电池正极材料LiCoO2 体系的电子结构的影响 ,进而揭示Mg掺杂的LiCoO2 具有高电导率的机理 ,对Li(Co ,Al)O2 和Li(Co,Mg)O2 进行了基于密度泛函理论的第一原理研究 .通过对能带及态密度的分析 ,发现在Mg掺杂后价带出现电子态空穴 ,提高了电导 ,并且通过歧化效应 (disproportionation)改变了Co 3d电子在各能级的分布 ,而Al掺杂则没有这些作用 .O2 - 的离子性在掺杂后明显增强 .     

Yb:FAP和Yb:C_3S_2-FAP晶体光谱的温度特性和选择激发

报导了Yb :FAP和Yb :C3S2 _FAP晶体在不同温度下的吸收光谱和荧光光谱实验结果 ,研究发现由于电子_声子近共振耦合作用 ,Yb :FAP和Yb :C3S2 _FAP晶体均存在有明显的振动谱 ,Yb :FAP晶体的零声子线在低温下还劈裂为相差 10cm- 1 的两条线 .采用激光选择激发技术研究了Yb3 离子在FAP和C3S2 _FAP晶体中的格位特征 ,结果表明Yb3 离子在这两种基质中都只占据Ca(Ⅱ )格位 ,但由于CaF2 的挥发 ,导致了Ca(Ⅱ )格位的局部畸变 .     

Zn(BTZ)2白色有机电致发光材料的合成及其器件制备

以PCl₃为脱水剂,将邻氨基硫酚与水杨酸脱水环化合成出2-(2-羟基苯基)苯并噻唑,并进一步将所得产物与乙酸锌反应合成出2-(2-羟基苯基)苯并噻唑螯合锌(Zn(BTZ)₂)材料。以该配合物作为发光层制备出结构为ITO/PVK:TPD/Zn(BTZ)₂/Al近白色电致发光器件,其色坐标位于白场之内(x=0.242,y=0.359),在驱动电压为16V时,亮度达3200cdm²,对应的量子效率为0.32%。进一步在Zn(BTZ)₂中掺入橙红色染料Rubrene,制成ITO/PVK:TPD/Zn(BTZ)₂:Rubrene/Al结构器件,实现了纯白色发光(色坐标值:x=0.324,y=0.343),非常接近于白色等能点,且量子效率达0.47%。最后对上述器件的发光和电学性能进行了深入的研究和探讨。     

Cl/HN3/I2全气相化学激光体系的化学动力学模拟计算

 对Cl/HN₃/I₂产生NCl(a)/I激光的过程进行了化学动力学计算，主要考察了Cl,HN₃和I₂的初始粒子数密度及其配比对小信号增益系数的影响。结果发现,当温度为400K, 初始Cl粒子数密度为1×10¹⁵，1×10¹⁶和1×10¹⁷cm^-3时,小信号增益系数分别达到1.6×10^-4,1.1×10^-3和1.1×10^-2cm^-1，获得最佳小信号增益系数的HN₃和I₂的初始粒子数密度分别为初始Cl粒子数密度的1～2倍和2%～4%。同时，对Cl，HN₃和I₂配比对小信号增益系数和增益持续时间的影响进行了讨论。     

闪烁光纤在γ射线辐照下部分特性的蒙特卡罗模拟

 闪烁光纤在射线成像方面的应用越来越广泛。为了进一步了解闪烁光纤在射线辐照下的基本特性，基于蒙特卡罗方法，利用计算机模拟分析了γ射线在闪烁光纤中的好事例率与光纤长度及射线能量的关系，能量沉积效率与光纤长度及射线能量的关系。此项工作对于闪烁光纤阵列在射线成像，剂量场测量等方面的研究很有价值。     

Synthesis and characterization of N-3-phenyl-2-propenoyl amino acids

Three N-3-phenyl-2-propenoyl amino acids were synthesized through interaction between 3-phenyl-2-propenoyl chloride and amino acids in alkaline with a high Yield.Structure of the products were identified by elemental analysis,IR and NMR spectroscopy.     

Syntheses, Characterization and Crystal Structures of Two-dimensional 4,4''-Bipyridyl Lead Halides,PbI2 (4,4'' -bpy) and PbBr2 (4,4'' -bpy)

Two-dimensional 4,4-bipyridyllead halides, PbI2 (4,4'-bpy) (1) and PbBr2 (4,4'-bpy) (2), were synthesized. The structures were determined by means of X-ray single crystal diffraction.The structure shows a distorted octahedral configuration with six-coordinated central lead atoms. In crystals 1 and 2, the molecules are packed in a two-dimensional network structure through bridging halide atoms and 4,4'-bipyridine ligands between the adjacent lead atoms.     

Synthesis under Micromave Irradition and Crystal Structure of 4''-Acetylbenzo-15 -crown-5thiosemicarbazone

The title compound is a bifunctional receptors including a thiourea group and a crown ether ring. Due to many possible potentials as a new class of reagents for membrane transports,ion-selective electrodes as well as reaction catalysts, the design and synthesis of bifunctional receptors for simultaneous binding of cations and anions is of ongoning interest in srprarnolecular chemistry1-5. In bifunctional receptors, the binding sites for anions and cations are covalently linked so as to exhibit allosteric or cooperative complexation where the binding affinity for anions(cations)is modified as a result of the cation(anion) complexation.Literature[6] reported that the ability of the thiourea group to bind anions is significantly enhanced when Na+ is bound to the crown moiety. To date, however only a few receptors of this class have been reported.6-8In this paper, we report an improved procedure under microwave irradiation that gives higher yields of title compound and needs fewer reaction times than traditional method.The structure of this compound was determined by IR ,element analysis and X-ray analysis.Scheme 1 The reaction equationThe crystal belongs to triclinic crystal system, P-1 space group, a=0.9547(0)nm, b=1.3637(3)nm,c=1.6029(3)nm, α =75.33(3) , β =83.62(3) , γ =70.99(3) ,Z=4,Dc=1.335g/cm3,F(000)=816,R1= 0.0557 ,wR2=0.1281. It is assembled into a three-dimensionalsupramolecule by intermolecular hydrogen bonds.     

Microcalorimetric Adsorption of Alumina Oxide Catalysts for Combination of Ethylbenzene dehydrogenation and carbon Dioxide Shift-reaction

Styrene (STY) is now produced industrially in fairly large quantities by the dehydrogenation of ethylbenzene (EB) using promoted iron oxide catalyst with superheated steam.In this case, small amount of carbon dioxide formed as a by-product was known to inhibit the catalytic activity of commercial catalyst. Recently, there have been some reports which carbon dioxide showed positive effects to promote catalytic activities on the reaction over several catalysts.In this study, we attempted to combine the dehydrogenation of EB to STY with the carbon dioxide shift-reaction. The combine reaction (EB + CO2 → STY + H2O + CO) can be considered as one of the ways of using CO2 resources and can yield simultaneously STY and Carbon oxide.Alumina oxide catalysts such as Al2O3, Na2O/Al2O3 and K2O/Al2O3 were prepared by the usual impregnation method with an aqueous solution of NaNO3 and KNO3, and then calcined at 650℃ for 5 h in a stream of air. The reaction condition is 600℃, flow of CO2 38ml/mon and space velocity (EB) 1.28h-1.