Angle-resolved desorption and removal of surface nitrogen in deNOx

This paper reports on recent progress on angle-resolved desorption leading to structure-sensitive desorption dynamics. The sensitivity is exemplified in NO and N₂O reduction on Pd and Rh surfaces. The energy partitioning in the repulsive desorption of hyper-thermal products into their rotational and translational modes is an indispensable concept to examine the structure of a reaction site from desorbing molecules because it connects the structure of a transition state with each energy of desorbed products. The extent of the energy partitioning will be derived from the desorption-angle dependences of both the rotational and translational energies at each vibrational state. Such energy analysis has never been completed for any thermal reactive desorption. A new type of measurement is thus proposed. Additionally, we discuss the inadequate use of the detailed balance principle in desorption dynamics, which has prevented desorption dynamics from being sensitive to surface structures.     

A relativistic quark model for mesons with an instanton-induced interaction

We present new results of a relativistic quark model based on the Bethe-Salpeter equation in its instantaneous approximation. Assuming a linearly rising confinement potential with an appropriate spinorial structure in Dirac space and adopting a residual interaction based on instanton effects, we can compute masses of the light mesons up to highest observed angular momenta with a natural solution of the U _A(1) problem. The calculated ground states masses and the radial excitations describe the experimental results well. In this paper, we will also discuss our results concerning numerous meson decay properties. For processes like π⁺/K ⁺↦e ⁺υ_eγ and 0^-↦γγ at various photon virtualities, we find a good agreement with experimental data. We will also comment on the form factors of the K _?3 decay and on the decay constants of the π, K and η mesons. For the sake of completeness, we will furthermore present the electromagnetic form factors of the charged π and K mesons as well as a comparison of the radiative meson decay widths with the most recent experimental data. Received: 28 August 2000 / Accepted: 12 September 2000     

合肥国家同步辐射光源软X射线束空间相干性实验研究

本文从实验角度对合肥国家同步辐射实验室软X射线束的空间相干性进行了研究.利用放置在物面上的高分辨正性光刻胶,记录了中心波长为3.2nm的波带片和针孔直径为30μm组合的光场分布(光斑),获得相应条件下的爱里斑及空间相干直径实验数据;完成了一个双缝干涉实验.所得的这些结果与理论计算相一致.     

Light Emission and Scanning Electron Microscopic Characterization of Porous Silicon

Optical emission resulting from sputtered species during ion bombardment of porous and oxidized porous silicon targets has been studied. Samples were bombarded with 5‐keV Kr⁺ ions at an incidence angle of 70 degrees, and the light emitted was analyzed over the wavelength range 200–300 nm. The surface morphology was investigated, and the micrographs revealed grooves parallel to the plane of incidence when the porosity was surprisingly observed in the grooves under each pore. The results are discussed as a function of the incidence angle and the porosity of the silicon targets.     

基于量子级联激光器和长光程气室的甲烷传感器

根据中红外光谱吸收原理,利用甲烷(CH₄)气体分子在7.5 μm处的基频吸收特性,设计了一种基于量子级联激光器(QCL)和新型多反射长光程气体吸收气室(MPC)的甲烷气体传感器。该仪器使用了可进行热电冷却、工作在脉冲方式下、中心波长为7.5 μm的QCL,通过在室温条件下调节其注入电流(500 mA～1.6 A调节范围),其出射光波长可以扫过CH₄(1 332.8 cm-1)气体吸收线。同时使用了一种紧凑型MPC(40 cm长,800 mL采样容积),使得系统有效总光程达到16 m。此外,系统中使用了参考气室,并加入了空间滤波光学结构以满足MPC对入射光束的要求,配合差分吸收光谱检测原理,有效地改善了光束质量,降低了由光源波动引起的噪声,提高了仪器的检测灵敏度。通过对不同浓度的甲烷气体进行多次检测,该仪器的稳定性能良好,按信噪比为1计算,可实现对甲烷气体的检测下限为1 μmol·mol-1。     

基于正弦光栅调制的相位恢复

提出一种基于正弦光栅调制的相位恢复方法.首先,在空间光调制器上加载两个不同方向的正弦光栅对光场复振幅进行调制;然后,推导强度信息和相位偏导数之间的关系式;最后由强度信息计算相位偏导数,进而恢复相位.实验分别测试了该方法对简单图像、复杂图像以及含噪声图像的恢复能力.实验结果表明,该方法可以通过方便地控制图像移动量来有效恢复相位信息,适用于不同尺度的相位物体的计算.     

圆柱形光声池结构及环境因素对声学本征频率的影响

以典型的圆柱形光声池为研究对象,建立光声池声学仿真有限元模型,并在此基础上,研究了光声池中谐振腔、缓冲腔、进出气孔结构参数以及温度、湿度因素对其声学本征频率的影响规律.研究结果表明:圆柱形光声池的进、出口孔对其声学本征频率影响极不敏感,设计计算中可以忽略不计,谐振腔的长度影响最为敏感,其次为谐振腔的直径.此外缓冲腔的长度与直径对其亦有一定影响,因而在准确计算时需要加以考虑.温度与湿度对光声池声学本征频率的影响均呈现正线性增长规律,温度的影响随着谐振腔长度的增大而减小,湿度的影响随着温度的升高而增大,仅计算光声池的声学本征频率时,湿度的影响在室温环境下且湿度变动较小的条件下可以忽略.     

融合插值点优化的多项式结构宽带波束形成器设计方法

多项式结构设计方法是主瓣指向可调宽带波束形成器设计的一类重要方法。多项式结构的阶数是有限的,导致主瓣实际指向与期望指向之间存在偏差,因而影响了波束形成器的指向性指数。针对这一问题,该文提出了一种基于插值点优化的多项式结构宽带波束形成器设计方法。首先,引入多项式结构插值点处阵列响应的空间导数约束,以减小主瓣指向偏差;进而利用粒子群优化算法对多项式结构中的插值点进行优化,以充分利用插值点位置提供的自由度进一步提升多项式结构宽带波束形成器的性能。优化设计结果表明,与现有设计方法相比,该文提出的方法不仅降低了主瓣的指向偏差,同时也提高了指向性指数,有效改善了多项式结构宽带波束形成器的性能。     

Synthesis and Polymerization of Spiro Oxyphosphoranes

Novel methods of synthesis of spiro acyloxyphosphoranes are described emphasizing the significance of the first isolated instance of these new species. Then, the no-catalyst alternating copolymerizations of the combinations of cyclic phosphorus(III) compounds (serving as nucleophilic monomer, M_N) with acrylic acid derivatives and with α-keto acids (electrophilic monomer, M_E) are mentioned. These copolymerizations proceed without added initiator. Spiro oxyphosphoranes play an important role in the copolymerization scheme in the equilibrium with the ⁺M_N - M_E ^? zwitterion, the key intermediate of the copolymerization. Finally, new reactions of spiro acyloxyphosphoranes with nucleophiles, alcoholysis and aminolysis polymerizations are presented.