Effect of polarization on the electrode behavior and microstructure of (La,Sr)MnO<Subscript>3</Subscript> electrodes of solid oxide fuel cells

The electrode behavior and microstructure of freshly prepared (La_0.8Sr_0.2)_0.9MnO₃ (LSM) electrodes were investigated under various polarization conditions. The original, large agglomerates in freshly prepared LSM electrodes were broken down into sphere-shaped grains when exposed to cathodic or anodic current passage of 200 mA cm^–2 at 800 °C in air for 3 h. Microstructural changes under cathodic polarization could be related to the pronounced diffusion and migration of oxygen vacancies and Mn ions on the LSM surface and lattice expansion, while lattice shrinkage under oxidation conditions most likely contributes to the structural changes under anodic polarization. Such morphological changes were irreversible and were found to be beneficial to the performance of freshly prepared LSM electrodes. Freshly prepared LSM electrodes behaved very differently with respect to the cathodic and anodic current passage treatment.     

Speciation of selenium(IV) and selenium(VI) in environmental samples by the combination of graphite furnace atomic absorption spectrometric determination and solid phase extraction on Diaion HP-2MG

A simple solid phase extraction procedure for speciation of selenium(IV) and selenium(VI) in environmental samples has been proposed prior to graphite furnace atomic absorption spectrometry. The method is based on the solid phase extraction of the selenium(IV)-ammonium pyrrolidine dithiocarbamate (APDC) chelate on the Diaion HP-2MG. After reduction of Se(VI) by heating the samples in the microwave oven with 4 mol l⁻¹ HCl, the system was applied to the total selenium. Se(VI) was calculated as the difference between the total selenium content and Se(IV) content. The experimental parameters, pH, amounts of reagents, eluent type and sample volume were optimized. The recoveries of analytes were found greater than 95%. No appreciable matrix effects were observed. The adsorption capacity of sorbent was 5.20 mg g⁻¹ Se (IV). The detection limit of Se (IV) (3sigma, n = 11) is 0.010 μg l⁻¹. The preconcentration factor for the presented system was 100. The proposed method was applied to the speciation of selenium(IV), selenium(VI) and determination of total selenium in natural waters and microwave digested soil, garlic, onion, rice, wheat and hazelnut samples harvested various locations in Turkey with satisfactory results. In order to verify the accuracy of the method, certified reference materials (NIST SRM 2711 Montana Soil, NIST SRM 1568a Rice Flour and NIST SRM 8418 Wheat Gluten) were analyzed and the results obtained were in good agreement with the certified values. The relative errors and relative standard deviations were below 6 and 10%, respectively.     

Syntheses of macrocyclic bisbibenzyls on solid support

We describe a route for the polymer supported total synthesis of the cyclic bisbibenzyls of the isoplagiochin type found in liverworts. TentaGel^® resins were used as solid support for a sequence involving Suzuki, Wittig and hydrogenation protocols. The polymer linked intermediates could be characterized by HR-MAS NMR. This route is to be extended to the synthesis of small libraries of differently halogenated derivatives.     

High extraction efficiency fiber coated with calix[4] open-chain crown ether for solid-phase microextraction of polar aromatic and aliphatic compounds

The calix[4] open-chain crown ether, 5,11,17,23-tetra-tert-butyl-25,27-di(2-allyloxyethoxyl)-26,28-dihydroxycalix[4]arene was synthesized and used for preparation of solid-phase microextraction (SPME) fibers of enhanced extraction efficiency. The new SPME coating made from calix[4] open-chain crown ether and hydroxyl-terminated silicone oil was developed with the aid of vinyltriethoxylsilane as bridge using sol-gel method and cross-linking technology. The efficiency of the novel fiber in the extraction of polar aromatic and aliphatic compounds, such as phenols, alcohols, and volatile fatty acids, was also investigated. Due to the introduction of the polar open-chain crown ether in calix[4]arene molecules, the calix[4] open-chain crown ether fiber showed much better selectivity and sensitivity to these polar compounds in comparison with calix[4]arene fiber. It also had superior extraction efficiency when compared to commercial poly(dimethylsiloxane)-divinylbenzene and polyacrylate fibers. Parts per billion to parts per trillion level detection limits were achieved for most of the analytes through SPME in conjunction with GC and flame ionization detector. The linear ranges were two to four orders of magnitude, and the RSD values were below 7% for all analytes. The novel fiber was applied to determine volatile alcohols and fatty acids in wine samples. The volatile-free wine prepared in this work was used to assure similar chemical environment for analytes in both calibration solutions and in real wine samples, thus compensating for possible matrix interferences. The established internal standard method using 4-methyl-2-pentanol as internal standard showed satisfactory accuracy and precision.     

Influence of molecular weight on the thermal decomposition of hydroxyl terminated polybutadiene

Thermogravimetric analysis of hydroxyl terminated polybutadiene (HTPB) and its fractions of different molecular weights separated by preparative GPC shows two major stages of weight loss of different nature in a nitrogen atmosphere. The first stage is primarily depolymerisation, cyclisation and crosslinking of molecules and the second stage is mainly the decomposition of the residue from the first stage. The kinetic parameters, viz. activation energy E and pre-exponential factor A using four different non-isothermal integral equations show a systematic increase with increase in molecular weight for the first stage, whereas for the second stage, the effect of molecular weight on E and A values is not prominent. The increase in E and A values for the first stage is attributed to the formation of greater number of cyclised and crosslinked products from molecules of higher dimensions. Quantitative correlations between the kinetic constants and the molecular weight parameters were derived for the first stage as a quadratic curve following the equation: E or ln A = K₁ − K₂/M (where K₁ and K₂ are empirical constants whose values are different for the different molecular weight averages, viz. M_n, M_w and M_z and for the different equations).     

Determination of Hormones and Non-ionic Surfactant Degradation Products in Small-Volume Aqueous Samples from Soil Columns Using LC-ESI-MS-MS and GC-MS

The leaching of two estrogens, 17β-estradiol and estrone, and two degradation products of non-ionic surfactants, octylphenol and nonylphenol, through a soil column were studied to estimate their transport behavior. Different concentration methods (lyophilization, solid phase extraction, and liquid–liquid extraction) were evaluated for analyzing these compounds in small effluent fractions (30–50 mL) collected. Liquid chromatography-mass spectrometry (LC-MS-MS) and gas chromatography-mass spectrometry (GC-MS) were employed for quantitative analysis of these compounds. After comparison, the lyophilization-LC-MS-MS method was found to be best suited for the analysis of the two estrogen hormones and the liquid–liquid extraction-GC-MS method best for the analysis of the two phenols in small samples in the soil column study. Because of their high sorption capacity, these compounds were mostly sorbed in the upper part of the soil column and were difficult to detect in column effluent.     

Closed tube sample introduction for gas chromatography-ion mobility spectrometry analysis of water contaminated with a chemical warfare agent surrogate compound

Ion mobility spectrometry (IMS) is a proven technology for detection of vapor phase chemical warfare agents. The technology is suitable for field portable instrumentation due to its small size, high sensitivity, speed of analysis, and low power consumption. However, it suffers from a limited dynamic range and potential difficulties in identifying compounds in complex matrices. The use of gas chromatography (GC) coupled to IMS can overcome the difficulty of chemical identification in mixtures by separating the sample into individual components before detection. Using this approach, IMS technology has previously been adapted to detect biological aerosols using an open tube pyrolyzer and a short GC column (Py-GC-IMS). The open sample introduction tube of a Py-GC-IMS instrument would be a convenient configuration to accept aerosol particulates, and while viewed as needed for aerosol trapping, is not optimal for liquid chemical analyses. To examine the usefulness of an existing Py-GC-IMS system for analysis of chemicals in water, an existing open-port sample interface was replaced with a septum-equipped closed tube injector to contain analyte vapors resulting from liquid injection. Tributylphosphate (TBP) was used as a surrogate chemical warfare agent, and aqueous injections into both closed and open tube assemblies were performed. Sample introduction into the closed tube inlet was also accomplished using solid phase microextraction (SPME) preconcentration. The limit of detection for TBP using an open tube, closed tube, and closed tube configuration with SPME sample introduction was 0.980, 0.196, and 0.0098 mg/L, respectively.     

The Role of Binary and Many-centre Molecular Interactions in Spin Crossover in the Solid State. Part II. Non-ideality Parameters Defined via Binary Molecular Potentials

Summary. Parameters of the formalism [1–6] describing spin crossover in the solid state have been defined via molecular potentials in model systems of neutral and ionic complexes. In the first instance Lennard-Jones and electric dipole–dipole potentials have been used whereas in ionic systems Lennard-Jones and electric point-charge potentials have been used. Electric dipole–dipole interaction of neutral complexes brings about a positive excess energy controlled by the difference of electric dipole moments of HS and LS molecules. Differences of the order of Δμ = 1–2 D cause an abrupt spin crossover in systems with T_1/2 = 100–150 K. Magnetic coupling contributes both to the excess energy and excess entropy, however the overall effect is equivalent to a modest positive excess energy. Ionic systems in the absence of specific interactions are characterised by very small excess energies corresponding to practically linear van’t Hoff plots. Detectable positive and negative excess energies in these systems may arise from interactions of ligands belonging to neighbouring complexes. The HOMO–LUMO overlap in HS–LS pairs can bring about a nontrivial variation of the shape of transition curves. Examples of regression analysis of experimental transition curves in terms of molecular potentials are given.     

Voltammetric Behavior of Osmium‐Labeled DNA at Mercury Meniscus‐Modified Solid Amalgam Electrodes. Detecting DNA Hybridization

The complex of osmium tetroxide with 2,2′‐bipyridine has been utilized as a probe of DNA structure and an electroactive marker of DNA in DNA hybridization sensors. It produces several voltammetric signals, the most negative of them has been observed only at mercury electrodes. This signal is of catalytic nature affording a high sensitivity of DNA determination. The catalytic current due to evolution of hydrogen in voltammetry of DNA modified by complex of osmium tetroxide with 2,2′‐bipyridine (DNA‐Os,bipy) was studied. Solid amalgam electrodes (modified with mercury menisci) of silver (m‐AgSAE), copper (m‐CuSAE), gold, and of combined bismuth and silver, were used as possible substitutes for mercury electrodes. Besides the hanging mercury drop electrode (HMDE), the catalytic current was observed only on m‐AgSAE and m‐CuSAE. Electrodes of gold and bismuth amalgams did not give the catalytic current. The detection limit of DNA‐Os,bipy on HMDE was 0.1 ng mL^?1 (RSD=2.3 %, N=11), and on m‐AgSAE 0.2 ng mL^?1 (RSD=3.1%, N=11). The m‐AgSAE was successfully applied as a detection electrode in double‐surface DNA hybridization experiments offering highly specific discrimination between complementary (target) and nonspecific DNAs, as well as determination of the length of a repetitive DNA sequence. The m‐AgSAE has proved a convenient alternative to the HMDE or carbon electrodes used for similar purposes in previous work.     

Solid phase extraction and analysis of horse urine for aminocaproic acid

Summary A rapid and efficient procedure is described for extraction and determination of aminocaproic acid in horse urine. Urine was extracted by passing through a bonded silica column (Bond-Elut). The adsorbed drug was washed free of endogenous materials before being eluted. The extract was then examined by thin-layer chromatography and HPLC. The purity of the extract was determined by gas chromatography-mass spectrometry.