密封罐微波消化法序列ICP-AES测定环境试样中多元素

本文采用密闭罐微波消化方法快速分解生物、土壤、沉积物等环境样品。按样品性质,分别采用HNO3/H_2O_2或HNO_3/H_2O_2/HF在聚四氟乙稀密闭罐中于500W微波功率分解0.1～0.2g样品2～3min,溶液(或在其中加入10ml硼酸饱和溶液)稀释至2.5～5.0ml后,直接用序列ICP-AES法测定。方法准确度经分析6个生物、土壤、沉积物标准参考物质验证,10个元素的均值均与定值吻合。     

Molar mass distributions by gradient liquid chromatography: predicting and tailoring selectivity

Interactive liquid chromatography (iLC) for polymer analysis is usually applied to the characterisation of distributions other than molar mass. In particular, its use for the determination of chemical-composition, functionality-type and tacticity distributions has been demonstrated. The application of iLC for the determination of molar mass distributions (MMDs), however, has not yet been fully explored. An expanded version of the reversed-phase liquid chromatography model has been developed to describe and predict how the retention behaviour of polydisperse polystyrene samples changes with molar mass. The relationship between molar mass and the parameters of the model has been investigated in some detail and non-linear correlations were found. From the model and the relationships between the model parameters and molar mass, calibration curves (retention time versus molar mass) were constructed to predict changes in chromatographic selectivity across a given molar mass range. These calibration curves were compared to experimentally obtained curves and, in most cases, excellent agreement was found. The dramatic enhancement in selectivity that can be obtained with iLC in comparison to size-exclusion chromatography (SEC) was illustrated by measuring matrix-assisted laser desorption ionisation (MALDI) MS spectra of fractions collected during a gradient-LC separation. In the low-molar mass range, essentially monodisperse fractions were obtained. Calibration curves, predicted by the model and validated experimentally using narrow-dispersity standards and MALDI-MS spectra of fractions, were used to determine the molar mass distribution of some narrowly distributed polystyrene samples. Molar mass distributions for such standards were found to be somewhat lower than the values reported by the manufacturers. The results also deviated from those obtained by MALDI-MS.     

Nutritional parameters of commercially available milk samples by FTIR and chemometric techniques

A chemometric study on the prediction of the main nutritional aspects of milk has been carried out by using fourier transform infrared spectroscopy (FTIR) attenuated total reflectance (ATR) measurements of commercially available milk samples of different types. Whole, semi and skimmed milks, enriched or not with calcium, vitamins or modified by alteration of lipid or sugar composition were considered. After evaluating different strategies for data acquisition and ATR cleaning between samples, hierarchical cluster analysis (HCA) was carried out for classification of samples in order to choose the calibration set. The prediction capabilities of partial least squares (PLS) data treatment were evaluated in order to obtain information about total fat, total protein, total carbohydrates (CH), calories and calcium. On using the mean square error of cross-validation and prediction as control variables, a critical evaluation were made about the calibration set to be used, the spectral range to be considered and the data treatment (PLS-1 or PLS-2) to be performed. By selecting a calibration set of 33 samples the properties of 48 samples were predicted with relative precision of triplicates of 0.062, 0.040 and 0.039% w/v for total fat, protein and carbohydrates, and 0.66 kcal/100 ml for calories, and 2.1 mg of Ca/100 ml. The mean difference (d_x−y) between predicted and actual values and standard deviation of mean differences (s_x−y), were of 0.06 (0.38), 0.03 (0.18) and −0.15 (0.41), being s_x−y values between brackets, for total fat, proteins and carbohydrates, 0.06 (3.8) kcal/100 ml for calories and −4.5 (9) mg/100 ml for calcium.The sensitivity and selectivity of the methodology developed were evaluated on terms of the net analyte signal. Selectivity factors ranging from 2 to 7.6% have been calculated for the five parameters considered.     

土壤中绿黄隆残留量分析方法的研究

本文确立了土壤中绿黄隆残留量的间接气相色谱分析方法，用０．１５ｍｏｌ／Ｌ ＮａＨＣＯ３提取土样，二氯甲烷洗涤初步纯化后，在水浴上加热水解，再用二氯甲烷萃取，弗罗里硅土柱净化，最后用气相色谱－电子捕获检测器检测水解产物邻氯苯磺酰胺。土壤中添加回收率７８．５％－９０．８％，检测极限０．３ｎｇ／ｇ。     

Recent contributions of high resolution gas chromatography to the analysis of environmental hydrocarbons

Analyses of hydrocarbon fractions from different areas of the marine environment are described to illustrate the possibilities and limitations of high resolution gas chromatography (HRGC) in the analysis of environmental samples. Examples are given of dissolved, particulate, and sedimentary hydrocarbons and organochlorine compounds; the importance of an adequate sampling of the marine environment is stressed. HR chromatographic profiles obtained in two columns of low and high polarity (SE-52 and PEG 20M) permit the sources and transport pathways of both natural and anthropogenic hydrocarbons to be traced. Analysis of tissues of marine mammals, which metabolize or excrete many of the biogenic and petrogenic hydrocarbons present in other areas of the marine environment, may provide an opportunity to obtain relatively clean profiles of many anthropogenic compounds of interest. The plotting of mass chromatograms from data compiled by COM-GC-MS remains the most appropriate method for the conclusive indentification of these compounds.     

Semi-micro solvent extraction as a rapid and efficient preconcentration technique for the determination of n-alkanes in oil-contaiminated water and soil samples by capillary gas chromatography

Summary In this study, a rapid and efficient semi-micro extraction procedure is presented for the extraction of some higher n-alkanes from water and soil samples. In the case of water samples n-hexane was used as the organic phase in a phase volume ratio (volume of aqueous phase/volume of organic phase) higher than 285, while in the case of soil samples, extraction with n-hexane was carried out in the presence of an excess of 2 M NaCl solution. The extraction rate from soil samples is very high and is better than Soxhlet extraction, comparable with supercritical fluid extraction. High preconcentration factor in water samples allows the limits of detection to be in the ng.mL⁻¹ level with the use of gas chromatographic analysis. Flame ionization detector was used for monitoring the analytes. The obtained recoveries of all studied compounds from both water and soil samples are higher than 90%. This method was successfully used to determine some n-alkanes in municipal wastewater and contaminated soil.     

Determination of the diastereomers of vitamin K1

A method is described for the gas-chromatographic determination of the diastereomers of vitamin K₁ (phylloquinone) in the form of their dihydro dimethyl ethers. The reported method of derivatization and chromatographic analysis in conjunction with optical rotation measurements are useful approaches for characterization of vitamin K₁ samples with respect to their origin.     

Resonance Rayleigh scattering determination of trace amounts of Al in natural waters and biological samples based on the formation of an Al(III)-morin-surfactant complex

A novel method for the determination of trace amounts of Al(III) based on resonance Rayleigh scattering (RRS) has been developed. In the presence of some surfactants, Al(III) can react with morin and form an Al(III)-morin-surfactant complex, which results in the enhancement of RRS intensity and the appearance of the corresponding RRS spectral characteristics. Their maximum scatter peaks are at 476 nm for the cetyltrimethylammonium bromide (CTAB) system, 489 nm for the cetylpyridinium chloride (CPC) system, 474 nm for the Triton X-100 system, and 473 nm for the Tween-20 system. The enhanced RRS intensity is directly proportional to the concentration of Al(III). The detection limits are in the range of (0.50-1.2)×10⁻⁷ mol l⁻¹ depending on the surfactant. The characteristics of RRS spectra of the complexes, the optimum conditions of these reactions and the influencing factors have been investigated. The method has high selectivity, and was successfully applied to the determination of Al(III) in natural and biological samples. Furthermore, according to different complexation capacity of Al(III)-morin-CTAB system under two pH conditions, speciation analysis of Al(III) in natural waters was explored. The labile monomeric Al fraction (mainly inorganic Al, Al_i) is determined at acidic pH and the total monomeric Al fraction (Al_a) is determined at alkaline pH. The results are in agreement with those obtained by Driscoll’s 8-hydroxyquinoline extraction-ion exchange method.     

Ion-exchange method for separation and concentration of platinum and palladium for analysis of environmental samples by inductively coupled plasma atomic emission spectrometry

An ion-exchange procedure is proposed for determination of Pt and Pd in environmental samples, using a Dowex 1-X10 anion-exchange resin. Pt and Pd were separated from the matrix elements in the sample by selective retention on the column as anionic chloro complexes and subsequent elution by circulated thiourea at 60 °C. The eluent, containing Pt and Pd was analyzed by inductively coupled plasma (ICP) atomic emission spectrometry (AES). Average recoveries of 98% and detection limit of 15 ng/g for both metals were achieved. Analysis of Pt and Pd concentrations in road dust, sampled from several sites in Germany was performed. The comparison of the obtained data with the concentrations of Pt and Pd in the same samples, determined by ICP-MS showed a very good agreement.     

Voltammetric Behavior of Arsenic(III) in the Presence of Sodium Diethyl Dithiocarbamate and Its Determination in Water and Highly Saline Samples by Adsorptive Stripping Voltammetry

This paper describes the voltammetric behavior of As(III) at the hanging mercury drop electrode (HMDE) in the presence of sodium diethyl dithiocarbamate (SDDC) and a new voltammetric method for the determination of As(III) at trace levels. The method is based on the adsorptive deposition of a As(III) complex with SDDC at ?0.45 V (vs. Ag/AgCl) on the HMDE in acidic medium of 0.01 mol L^?1 HCl (pH 2.0) and its cathodic stripping during the potential scan (100 mV s^?1). The linear range for the determination of As(III) in the presence of SDDC (4 μmol L^?1) in water samples was between 1 and 10 μg L^?1 for a deposition time of 300 s (r=0.994) and between 10 and 100 μg L^?1 for a deposition time of 60 s (r=0.999). For the determination of As(III) in dialysis concentrate samples, the linear range was between 5 and 25 μg L^?1 for a deposition time of 180 s (r=0.992) and between 10 and 100 μg L^?1 for a deposition time of 60 s (r=0.996). Detection limits of 0.3 and 2.2 μg L^?1 in water and dialysis concentrate samples were calculated for the method using a deposition time of 300 and 180 s, respectively. Recovery values between 93.0 and 110.0% for As(III) added to deionized, mineral, seawater (synthetic and real) and dialysis concentrate samples prove the satisfactory accuracy and applicability of the procedure.