Electrokinetic and contact angle measurements of grafted carbon fibers

 The grafting method that has successfully been applied to methacrylic acid and liquid crystalline monomers was expanded to prepare amphoteric carbon fiber surfaces using 2-(N,N-dimethylamino)ethyl methacrylate as monomer. The obtained carbon fiber surfaces were characterized by contact angle and ζ-potential measurements. The expected basic behavior was not observed, instead an amphoteric character of the modified carbon fiber surface was found. The fiber surfaces display a basic character in the acidic pH-range, while they are acidic in the alkaline part of the pH-scale. An important influence is derived from the amount of initiator used to graft the monomers onto the fibers. The smaller the initiator concen-tration used during polymerization, the larger the amount of amino functionalities introduced to the carbon fiber surface. The wetting behavior versus water depends on the overall conformation of the immobilized polymer. During immersion into water the polymer acts hydrophobic, while during emersion, a hydrophilic character is observed, probably derived from conformational changes and swelling during the contact angle measure-ments in water. Received: 9 June 1998 Accepted: 13 August 1998     

阴极支撑型固体氧化物燃料电池的制备与测试

采用固相反应法合成A缺位的(La_0.8Sr_0.2)_0.95MnO₃(LSM95)作为阴极材料,Zr_0.9Sc_0.1SO_1.95(SSZ)商业粉体作为电解质材料,溶胶-凝胶法合成的La_0.8Sr_0.2Cr_0.5Mn_0.5O₃-(LSCrM)作为阳极电催化材料,利用流延、共烧结及浸渍法得到结构为LSCrM-CeO₂|SSZ|3YSZ-LSM95的阴极支撑型固体氧化物燃料电池,分别在氢气气氛和甲烷气氛中进行电化学性能测试. 结果表明,浸渍0.11 g·cm ^-2 CeO₂的LSCrM-CeO₂|SSZ|3YSZ-LSM95单电池在以CH₄为燃料时,600、650、700、750和800 ^oC下的功率密度分别为1.68、4.70、12.40、28.08和54.78 mW·cm ^-2,表现出一定的电化学性能和较好的稳定性.     

碳纳米管的共价修饰

碳纳米管(carbon nanotubes, CNTs)的溶解性和分散性较差是目前制约其广泛应用及在一些有特殊要求的领域(如生物技术)应用的主要原因之一. 对CNTs进行共价修饰是改善其溶解性和分散性的有效方法之一. 目前CNTs的共价修饰主要通过两类反应来实现: 羧基的衍生反应和直接加成反应. 介绍了基于这两种反应的几种共价修饰方法, 比较了各种修饰方法的优缺点及其对CNTs的溶解性和分散性的改善效果.     

不同孔径的介孔碳分子筛对VB12的吸附性质研究

摘要利用SBA-15为模板, 在不同温度下合成了孔径大小在3.7(CMK-3-100)和6-3 nm(CMK-3-150)之间的介孔碳， 以其作为吸附剂, 研究了它们在水溶液中对VB12的吸附作用. 结果表明, CMK-3-130与CMK-3-100和CMK-3-150相比， 表现出对VB12最大的吸附能力(吸附能力为412.5 mg/g), 这是因为它有比较高的有序结构和比较大的孔容.     

多壁碳纳米管负载铂的甲苯加氢脱芳催化剂

以多壁碳纳米管(CNTs)为载体制备了负载型Pt催化剂Pt/CNTs并将其用于催化甲苯加氢脱芳(HDA)反应.结果表明,在1.0%Pt/CNTs催化剂上,在0.4MPa,373K,PhCH3/H2摩尔比=6/94和GHSV=120L/(h.g)的反应条件下,甲苯转化率可达100%,比反应速率为0.0523mmol/(s.m2),分别是γ-Al2O3和AC负载各自最佳Pt负载量催化剂1.4%Pt/γ-Al2O3和2.4%Pt/AC上相应值的1.17和1.18倍.甲苯加氢产物全部为甲基环己烷,其他可能的加氢产物均在气相色谱检测限以下.催化剂的表征研究揭示,用CNTs代替γ-Al2O3或AC作为载体并不会引起所负载Pt催化剂上甲苯HDA反应的表观活化能发生明显变化.与γ-Al2O3或AC负载的相应催化剂相比,一方面,CNTs负载的Pt催化剂易于在较低温度下还原活化,并且其工作态催化剂表面催化活性Pt物种(Pt0)所占表面Pt摩尔分率有所提高;另一方面,CNTs负载的Pt催化剂对H2具有较高的吸附/活化和储存能力.这些促进效应对催化剂HDA活性的提高都有重要贡献.     

Anodic Stripping Voltammetry of Heavy Metals at Nanocrystalline Boron‐Doped Diamond Electrode

Boron‐doped Diamond (BDD) electrode has become one of the important tools for heavy metal detection. By studying some analytical parameters of DPASV method, like deposition time and potential in different electrolyte concentrations (acetate buffer), the conditions for detecting very low metal ion levels (Zn, Cd, Pb, and Cu) could be chosen. Diluted electrolyte (0.01 M buffer) was one of the factors favoring low detection and quantification limits, but its quantification range is short in comparison to more concentrated media. For ?1.7 V deposition potential, the detection of single metal at ppb levels was reached in 60 s deposition time. Understanding different metal‐metal interactions shows the limits to the simultaneous determination of heavy metals at BDD. Quantification was possible for the simultaneous determination of Zn, Cd and Pb despite the overlapping of Zn and Cd peaks. The performance of the BDD was compared with that of another C‐based solid electrode: the glassy carbon electrode (without mercury plating). A lower base line current, wider potential range, higher sensitivity (3 to 5 times higher than GC) and longevity of the material were noticed for the BDD.     

甲亚胺与姜黄素测定土壤有效硼方法的对比研究

土壤有效硼是决定土壤供硼能力的重要指标，目前中国多以沸水浸提土壤，并用姜黄素比色测硼值作为作物硼营养丰缺诊断指标．但在长期实践中，发现作物硼营养状况与热水溶性硼的相关性不稳定，同时测定值重现性不良。为提高作物硼营养诊断和预测的准确性，本研究通过０．０１ｍｏｌ／ＬＣａＣｌ２在２６０℃、３５ｍｉｎ浸提土壤条件下，用甲亚胺比色与沸水浸提，姜黄素比色法测定土壤有效硼的对比研究，证明甲亚胺法测定结果稳定，操作方法简便，适用于低硼土壤的大批量试样的自动分析。为甲亚胺测硼方法的推广应用，本研究已研制甲亚胺粉状试剂获得成功，与进口甲亚胺比较，性能完全一致。     

具有平整表面的定向纳米碳管膜的制备

为了获得表面平整的定向纳米碳管，通过化学及物理的方法将纳米碳管膜进行反转，使其原来的AAO模板底面成为新的表面，用溶液逐步去除表面的铝和氧化铝后，获得了平整的定向纳米碳管膜表面，从而可将其作为工作面使用. 还比较了5％NaOH和6%H₃PO₄＋1.8%H₂CrO₄溶液去除氧化铝的效果.     

Carbyne — the third allotropic form of carbon

The history of the discovery of carbyne, the chemical and physical methods used to obtain it, the analysis of its structure, and some of its properties are briefly considered. The prospects for its practical applications are discussedThis publication is based on a number of works on carbyne submitted for the Russian State Prize in the field of science and technology in 1993; performed at the A. N. Nesmeyanov Institute of Organoelement Compounds, Russian Academy of Sciences and the M. V. Lomonosov Moscow State University.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 3, pp. 450–463, March, 1993.     

盐酸氨溴索在碳糊电极上阳极伏安法的研究

在０．５ ｍｏｌ／Ｌ Ｈ２ＳＯ４底液中，用碳糊电极阳极伏安法测定盐酸氨溴索，被测的阳极峰电位为１．１０Ｖ（ｖｓ．ＳＣＥ），另外，在０．４６Ｖ处还产生一对可逆的氧化还原峰。１．１０ Ｖ处的峰电流与盐酸氨溴索的浓度在３．９８×１０~（－７）～６．３４ × １０~（－５）ｍｏｌ／Ｌ范围内呈良好的线性关系，该方法的检出下限为３．０ × １０~（－８）ｍｏｌ／Ｌ。用标准加入法测得回收率范围为９２．８％～１０２％，ＲＳＤ为２．９％（ｎ＝１０）。对电极响应机理进行了初步探讨，氨溴索在１．１０ Ｖ处的氧化为不可逆过程，其氧化产物在０．４６０Ｖ处产生一对２电子２质子受扩散控制的可逆波，用该波也可进行定量测定并且干扰较少，但灵敏度略低。