Combined effect of PMD and PDL on four-wave-mixing-induced crosstalk in WDM system

We derive an explicit autocorrelation function (ACF) formula of state of polarization for a fiber transmission system with polarization mode dispersion (PMD) and polarization dependent loss (PDL), which is found to agree well with Monte Carlo simulation. Then we use the new ACF to investigate the combined effect of PMD and PDL on the polarization multiplexed scheme. We find the performance of the polarization multiplexed scheme can be deteriorated more severely than the case without PDL.     

滤波器对偏振模色散的补偿

根据耦合非线性薛定谔方程 ,本文研究了偏振模色散如何影响各种码型的频谱 ,分析了滑频滤波器和固定滤波器对偏振模色散的补偿作用。研究结果表明 :偏振模色散对不同码型的频谱影响是不一样的 ,对色散管理孤子的频谱影响最大 ,产生新的频率分量也最多 ,而且每个新频率分量都较强 ,比入射频谱展宽许多 ;滑频滤波器和固定滤波器对偏振模色散都具有补偿作用 ,使最大可传输距离成倍增加 ,两种滤波器对偏振模色散的补偿作用相差较小 ;但是对色散管理孤子系统中的偏振模色散补偿效果最佳。     

Density-Functional Theory Calculations of Normal Modes and Raman Intensities for Tetraazaporphin

The structure, harmonic frequencies, and nonresonance Raman intensities for porphin, tetraazaporphin (TAP), and three of its isotopomers are calculated by the density-functional theory of B3LYP/6-31G(d). Scaling of force constants for porphin in nonredundant natural coordinates is performed. The scaling factors obtained were used to predict the force field and normal modes of TAP and three of its isotopomers. Two alternative methods are used to carry out reliable assignment of the TAP frequencies: wavenumber-linear scaling method and frequency-shift method. There is good agreement between the frequencies predicted within the framework of the three methods used. The conservativeness of the out-of-plane B _2g - and B _3g -modes for porphin and TAP is examined. The Raman spectrum for TAP is simulated. A refinement of the assignment of the experimental frequencies for TAP of even symmetry types on the basis of the calculations performed is made.     

LINEAR ACTIVE STRUCTURES AND MODES (Ⅱ)--DISCRETE SYSTEMS AND BEAMS

The basic concepts about the active structures and some attributes of the modes were presented in paper "Liner Active Structures and Modes ( Ⅰ ) ". The characteristics of the active discrete systems and active beams were discussed, especially, the stability of the active structures and the orthogonality of the eigenvectors. The notes about modes were portrayed by a model of a seven-storeyed building with sensors and actuators. The concept of the adjoint active structure was extended from the discrete systems to the beams that were the representations of the continuous structures. Two types of beams with different placements of the measuring and actuating systems were discussed in detail. One is the beam with the discrete sensors and actuators, and the other is the beam with distributed sensor and actuator function. The orthogonality conditions were derived with the modal shapes of the active beam and its adjoint active beam. An example shows that the variation of eigenvalues with feedback amplitude for the homo-configuration and non-homo-configuration active structures.     

滤片-XRD探测系统响应时间测量

 研究了软X射线能谱仪探测道系统(系统包括X射线二极管（XRD）、SUJ-50-10电缆和不同频带示波器)的响应时间。实验利用上海激光联合实验室的20TW激光器激光(激光能量约20J，脉冲宽度约1ps)打金箔靶产生的X光，用XRD探测系统测量，记录示波器有TK684C，TK694C和WM8500等。将实验数据进行了线性拟合和比对分析。滤片XRD探测系统的响应时间随偏压升高而加快，随传输电缆长度的增加而变慢，因此测量快信号过程时，应提高探测器偏压，缩短传输电缆，选择宽频带高采样率示波器，以便减少系统的响应时间，减小信号失真程度。     

反射式微光机电系统(MOEMS)的研究现状与展望

反射式微光机电系统是微光机电系统中的重要组成部分,近年来得到了较快的发展。介绍了反射式微光机电系统(MOEMS)的研究现状和最新进展。根据反射式微光机电系统的分类,列举了一些具有代表性的反射式MOEMS器件。简要介绍了反射式MOEMS的加工工艺;阐述了反射式MOEMS的应用领域;展望了发展前景。     

一种新颖的用于光腔模式及光束传输模拟的特征向量法

根据有限元法单元划分的思想，提出了一种新颖的模拟光腔模式及光束传输的特征向量法. 该方法的关键之处在于基于衍射积分理论构造了一种新的光束传输矩阵，通过求解特征矩阵方程可一次性得到谐振腔的一系列特征向量，每一列特征向量即代表了腔镜上光场的一个确定模式的振幅及相位分布. 并可采用该方法模拟光场传输到腔内或腔外任意地方的场分布. 该方法将传统方法中大量的迭代过程转化成为本征积分方程特征向量的求解过程，并与初值取值无关，且可一次性求得多个模式分布，从而可方便地分析谐振腔的模式鉴别能力. 特征向量法对圆形镜共焦 关键词： 谐振腔 特征向量法 模式分布     

基于径向基函数神经网络的Lorenz混沌系统滑模控制

针对受参数不确定和外扰影响的混沌Lorenz系统，提出一种基于径向基函数（RBF）神经网 络的滑模控制方法.基于被控系统在不稳定平衡点处状态误差的可控规范形，设计滑模切换 面并将其作为神经网络的唯一输入.单入单出形式的RBF控制器隐层只需7个径向基函数，网 络的权值则依滑模趋近条件在线确定.仿真表明该控制器对系统参数突变和外部干扰具有鲁棒性，同时抑制了抖振. 关键词： 混沌控制 滑模 径向基函数神经网络 Lorenz系统     

利用普通视频CCD作为紫外激光和软X射线探测器的研究

 介绍了利用价格便宜的普通视频CCD来获取紫外激光和软X射线图像的方法和应用结果，以代替价格昂贵的紫外CCD、使用不方便的X光胶片或者昂贵的X光CCD，其关键点是：（1）去除CCD相机的自动增益校正；（2）将相机的校正系数γ值设置为1；（3）去除CCD相机前面的保护窗。作为一种简易的装置，可以用于紫外激光测量及激光与等离子体相互作用研究。结果表明，采用改造后的普通视频CCD测量紫外激光光斑，准确可靠，其灵敏度比科学级紫外CCD的低一个量级，它还可以测量软X射线的二维分布，作为X光针孔相机使用非常方便。     

微模塑法制备PMMA/SiO2二氧化硅杂化材料微结构

以摩尔比为 1∶1的甲基丙烯酸甲酯 (MMA)、甲基丙烯酸 (3 三乙氧基硅烷基 )丙酯 (ESMA)单体、0 .2 %(单体总量的质量分数 )的偶氮二异丁腈AIBN引发剂和四氢呋喃 (THF)溶剂 ,及 2 0 % (总质量分数 )的正硅酸乙酯TEOS合成出PMMA/SiO2 有机 无机杂化的杂化溶胶 .将溶胶在洗净的普通光学玻璃基片表面甩膜 .利用软刻蚀中的微模塑法 ,把有机硅弹性印章复制有精细图纹一面轻放在杂化溶胶膜上进行微模塑 ,外加 1N压力于12 0℃下处理 2h使溶胶凝胶化 .印章剥离后在基片表面就形成了PMMA/SiO2 有机 无机杂化材料的微图纹结构 .从微图纹的光学显微镜照片可以看出微模塑方法制备杂化材料复制的图纹精细度高 ,操作简单易行 ,是一类比较理想的微细图纹结构加工的方法 .