Vibrational EELS and DFT study of propionic acid and pyruvic acid on Ni(1 0 0): Effects of keto group substitution on room-temperature adsorption and thermal chemistry

The room-temperature adsorption and thermally induced processes of propionic acid and pyruvic acid on Ni(1 0 0) have been investigated by electron energy loss spectroscopy (EELS). Computational vibrational analysis of the optimized bidentate structures for acid-Ni model complexes (involving the organic acid and a Ni atom) has been performed by using the two-layer ONIOM method with the Density Functional Theory and used to interpret the vibrational EELS data. Dehydrogenation of the hydroxyl group is found to result in bonding of the carboxylate group in the propionate and pyruvate adspecies to either a single Ni surface atom in a bidentate configuration or two neighbouring Ni atoms in a bridge configuration. Given the similarities in the total energies and related vibrational frequencies obtained by the calculations in the case of pyruvate adspecies, it is difficult to differentiate the alternate adsorption structure, in which the keto O and hydroxyl O atoms are bonded to a Ni atom in a five-member chelate ring configuration. Furthermore, temperature-dependent EELS studies show that both the propionate and pyruvate adspecies could decompose upon annealing to above 400 K and further dissociate to CO adspecies above 550 K and to C and/or O above 600 K.     

Ag纳米颗粒的光吸收和透射电镜研究

用硼氢化钠作还原剂,制备出两种相对稳定的含银纳米颗粒的水溶胶,用透射电镜（TEM）和光学吸收谱对这些颗粒进行了表征.当被还原的银离子较少时,所形成的银纳米颗粒较小,吸收峰呈现二极等离子体共振吸收峰.当被还原的银离子较多时,银纳米颗粒尺寸变大,并出现二极和四极共振吸收峰.在Ag纳米颗粒形成后,对其溶液稀释,发现其峰形保持不变,而峰位会出现红移,最大红移量可达到10 nm.透射电镜研究表明,低浓度溶胶中的Ag纳米颗粒尺寸较为均匀,平均直径12 nm.高浓度溶胶中的纳米颗粒尺寸呈双尺寸分布特点,少量颗粒直径小于14 nm,大部分颗粒直径大于20 nm.     

Surface polarity of cellulose derivates observed by coumarin 151 and 153 as solvatochromic and fluorochromic probes

Solvent‐dependent ultraviolet–visible (UV–vis) absorption and Stokes shifts including strong hydrogen‐bond‐donating (HBD) solvents such as 2,2,2‐trifluoroethanol and 1,1,1,3,3,3‐hexafluoro‐2‐propanol of two coumarine dyes (Co 151 and Co 153) were analyzed with multiple‐square analyses of linear solvation energy relationships and the Kamlet–Taft solvent parameter set to α (HBD capacity), β (hydrogen‐bond‐accepting capacity), and π* (dipolarity/polarizability). The UV–vis absorption and emission spectra of Co 151 and Co 153 were measured when adsorbed on various polysaccharides such as different cellulose batches, carboxymethylcelluloses with different degrees of substitution, and chitine. As a result of this evaluation, Co 153 is recommended as an alternative UV–vis probe for evaluating the dipolarity/polarizability of cellulose and cellulose derivates. Multiple adsorption of Co 153 on Linters cellulose took place indicating a wide‐surface polarity distribution, which makes the determination of a rigid polarity parameter questionable. Thus, fluorescence measurements of adsorbed Co 153 are suitable to detect inhomogenities on a surface but not for the determination of empirical polarity parameters. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1210–1218, 2003     

Determination of ultra-trace gold in natural water by graphite furnace atomic absorption spectrophotometry after in situ enrichment with thiol cotton fiber

A simple method of determining ultra-trace Au in natural water was presented by using graphite furnace atomic absorption spectrophotometry (GFAAS) after in situ enrichment with thiol cotton fiber (TCF). The sample solution was adjusted to pH 1.5-2.0 with HCl, then the water sample was passed through a column packed with 0.10-0.20 g TCF and the flow rate was controlled at 20-40 ml min⁻¹. The effects of interferences, such as complexing and oxidizing agents and other elements adsorbed on TCF were overcome by chemical treatments prior to the desorption of Au. The adsorbed Au was adsorbed with 2.0 ml hot acid, then it was extracted with 1.00 ml methyl isobutylketone (MIBK). For a 5 l water sample, the detection limit of Au is 0.02 ng l⁻¹. The relative standard deviation (R.S.D.) for the determination of 1.44 ng l⁻¹ Au was 9.4%.The method was applied to determine ultra-trace Au both in suspended phase and soluble phase in natural water, the concentrations of total Au in natural water samples range from 0.51 to 67.82 ng l⁻¹. The recovery of added 0.50-6.00 ng l⁻¹ Au was 80-95%. The method is useful in prospecting for Au deposits by means of hydrogeochemical methods. The enrichment is carried out in the field, and then the determination of Au is completed later in the laboratory.     

Effects of Moisture and Stresses on the Structure and Properties of Polyester Resin

The results of a complex study of structural changes in a cured Norpol 440 polyester resin under the action of damp environment and mechanical loading are presented. A considerable effect of absorbed moisture on the structure and some characteristics of the material is revealed by using thermophysical methods and X-ray diffractometry. The joint effect of moisture and mechanical stress is estimated by investigating the creep in stationary and nonstationary moisture conditions. The anisotropy of the material structure formed during creep is evaluated from the results of dilatometric measurements. It is found that the degree of anisotropy of the material after creep accompanied by moisture sorption is higher than that after creep in the conditions of moisture equilibrium with atmosphere. It is established that the aftercure and relaxation of the residual creep deformation come to an end at heating to 80-85°C. At a further rise in temperature and repeated heating, changes in the material structure are not observed.     

CuPc molecules adsorbed on Au(1 1 0)-(1 × 2): growth morphology and evolution of valence band states

We present the growth morphology, the long-range ordering, and the evolution of the valence band electronic states of ultrathin films of copper phthalocyanine (CuPc) deposited on the Au(1 1 0)-(1 × 2) reconstructed surface, as a function of the organic molecule coverage. The low energy electron diffraction patterns present a (5 × 3) reconstruction from the early adsorption stages. High-resolution UV photoelectron spectroscopy data show the disappearance of the Au surface states related to the (1 × 2) reconstruction, and the presence of new electronic features related to the molecule-substrate interaction and to the CuPc molecular states. The CuPc highest occupied molecular orbital gradually emerges in the valence band, while the interface electronic states are quenched, upon increasing the coverage.     

Multilayer optics for XUV spectral region: technology fabrication and applications

We present research investigations in the field of multilayer optics in X-ray and extreme ultra-violet ranges (XUV), aimed at the development of optical elements for applications in experiments in physics and in scientific instrumentation. We discuss normal incidence multilayer optics in the spectral region of “water window”, multilayer optics for collimation and focusing of hard X-ray, multilayer dispersing elements for X-ray spectroscopy of high-temperature plasma, multilayer dispersing elements for analysis of low Z-elements. Our research pays special attention to optimization of multilayer optics for projection EUV-lithography (ψ-13nm) and short period multilayer optics.     

Influence of annealing and chain defects on the melting behaviour of poly(vinylidene fluoride)

The melting behaviour of poly(vinylidene fluoride) (PVDF) was investigated by differential scanning calorimetry (DSC) and small- and wide-angle X-ray scattering in order to study the influence of the chain defects content and of the temperature of annealing on the crystallization and melting behaviour.All the DSC scans show a double endotherm and the analysis of the data suggests that the low temperature endotherm is due to the melting of a population of thin lamellae, whose thickness increases during the annealing, but a high content of chain defects prevents the lamellar thickening and the main effect in this case is the crystallization of thin lamellae from a portion of polymer which did not crystallize during the quenching from the melt. Furthermore, the two melting endotherms, which are observed, can be partially ascribed to a melting-recrystallization process.Furthermore, stepwise isothermal cooling was performed in a differential scanning calorimeter followed by melting scans of fractionated PVDF samples to point out the possible presence of a series of endothermic peaks.     

石墨炉原子吸收法测定化妆品中的砷

在过氧化氢溶液及硝酸镍存在下，用石墨炉原子吸收法测定化妆品中砷的含量，砷的浓度在0-1mg/L时与吸光度线相关，线性方程为A=0.838c 0.003，相关系数为0.99994。对液体和固体化妆品中的砷进行测定，砷的加标回收率为98.3%-98.7%，测定结果的相对标准偏差为0.65%-1.50%。     

Charge density study under high pressure

The experimental and analytical method of the high-pressure powder experiment at BL10XU, SPring-8, is described. There is no doubt that BL10XU must be one of the most appropriate beam lines for high pressure X-ray diffraction experiment taking advantage of third generation synchrotron source. As an example of the advanced charge density study under high pressure, the structural change of Cs₂Au₂Br₆ by applying pressure is studied by Rietveld/MEM analysis. It reveals that the structural change of Cs₂Au₂Br₆ by applying pressure occurs basically at electron level, such as valence state change and chemical bonding, which may be called the electronic phase transition.