甲基化的β-环糊精与十六烷基三甲基溴化胺的相互作用

环糊精与表面活性剂的相互作用已有许多研究,但多局限于β－环糊精（β－CD）,而修饰的β－环糊精与表面活性剂的相互作用研究较少[1－3]．分子内扭转电荷转移（TICT）激发态对介质极性高度敏感性,已成功地用于探针环糊精与表面活性剂的相互作用[4]．研究表明,β－CD能够诱     

聚丙烯酰胺与混合表面活性剂的相互作用

通过粘度和紫外吸收光谱的测定，研究了ＰＡＭ与Ｒ１２ＳＯ３Ｎａ－Ｒ１１ＣＯＯＮａ混合表面活性剂之间的相互作用，结果表明，ＰＡＭ可与混合表面活性剂形成复合物，从而使体系表现出典型聚电解质的粘度行为。可能的机理是，以疏水力形成的Ｒ１２ＳＯ３＾－—Ｒ１１ＣＯＯＨ（Ｎａ）预胶束或二聚体通过ＰＡＭ－Ｒ１１ＣＯＯＨ间的氢键力相结合。进而使大分子链上带有大量负电荷，静电斥力引起大分子链伸展，因而产生电粘效应。     

单扫描示波极谱法测定扑热息痛

扑热息痛与NaNO2在中性介质中发生反应，其亚硝化衍生物具有良好的电活性。在pH9．37的Britton-Robinson缓冲溶液中，于-0．56V(vs．SCE)产生灵敏的极谱还原峰，峰电流与扑热息痛质量浓度在0．007-0．4mg/L范围有良好的线性关系，检测下限为5μg/L。此法已用于测定小儿速效感冒灵。     

An investigation of the chemiluminescence reaction in the sodium hypochlorite–folic acid–emicarbazide hydrochloride system

A chemiluminescence method for the determination of folic acid by the sodium hypochlorite–folic acid–semicarbazide hydrochloride system with a new flow injection technique has been established. The new method can perform simple, sensitive and rapid determinations of folic acid. The response to the concentration of folic acid, in the range of 1.0×10⁻⁷5.0×10⁻⁵ g/ml, is linear. The relative standard deviation of the method is 2.3% (C_s=4.0×10⁻⁶ g/ml, n=11). The detection limit is 2.7×10⁻⁸ g/ml. This method is suitable for automatic and continuous analysis, and has been successfully tested for the determination of folic acid in a folic acid tablet.     

A new dodecylsulfate-selective supported liquid membrane electrode based on its N-cetylpyridinium ion-pair

A supported liquid and a poly(vinyl chloride) (PVC)-based membrane selective for dodecylsulfate (DS⁻) ion are described. The active element is a membrane containing a dissolved ion association complex of DS⁻ with cetylpyridinium (CP⁺) cation. The supported liquid membrane electrode (acetophenone as solvent) showed a Nernstian response towards the DS⁻ anion over the concentration range of sodium dodecylsulfate (SDS) from 8.3×10⁻³ to 1.0×10⁻⁶ mol dm⁻³ at 25 °C. The proposed electrode also showed a super-Nernstian potential response (108±2 mV decade⁻¹) at low concentrations (1.0×10⁻⁹ to 1.0×10⁻⁶ mol dm⁻³). Moreover, this electrode showed good selectivity and precision (R.S.D.?2.0%), and was usable within the pH range 4.0-6.8. The proposed electrode revealed a lower limit of detection of 6.3×10⁻⁷ mol dm⁻³ and improved selectivity in comparison with the some previously reported DS⁻ ion selective electrodes. The isothermal temperature coefficient of this electrode amounted to −0.001 V °C⁻¹. The liquid membrane electrode may find application in the direct determination of SDS by the standard addition method at pH 5.0, and in the physicochemical studies of surfactant solutions.     

Decomposition of Gaseous Sulfide Compounds in Air by Pulsed Corona Discharge

The effectiveness of applying a pulsed corona discharge to the destruction of olfactory pollution in air was investigated. This paper presents a comparative study of the decomposition of three representative sulfide compounds in diluted concentrations: hydrogen sulfide (H₂S), dimethyl sulfide (DMS), and ethanethiol (C₂H₅SH), which could be completely removed when a sufficient but reasonable energy density was deposited in the gas. DMS showed the lowest energy cost (around 30 eV/molecules); C₂H₅SH and H₂S had an EC of respectively 45 eV and 115 eV. The efficiency of the non-thermal plasma process increased with decreasing the initial concentration of sulfide compounds, while the energy yield remained almost unchanged. SO₂ was the only identified byproduct of H₂S decomposition, but the sulfur balance suggests the formation of undetected SO₃. The byproducts analyzed during the degradation of DMS and C₂H₅SH enabled to propose a reaction mechanism, starting with radical attack and breaking of C–S bonds.     

Absolute line intensity measurements of hot bands for carbonyl sulfide at 12 microm

Using diode-laser spectroscopy, the intensities of 58 lines of the v(1) + v(1/2) - v(1/2) band and 36 lines of the 2v(1) - v(1) band of OCS have been measured. The corresponding band strengths S(0)(v) and the vibrational transition dipoles micro(v) have been derived through least squares fitting of these individual intensities. The band strengths values have been determined with a precision better than 2.5%.     

Boiling Temperature and Reversed Deliquescence Relative Humidity Measurements for Mineral Assemblages in the NaCl + NaNO3 + KNO3 + Ca(NO3)2 + H2O System

Boiling temperature measurements have been made at ambient pressure for saturated ternary solutions of NaCl + KNO₃ + H₂O, NaNO₃ + KNO₃ + H₂O, and NaCl + Ca(NO₃)₂ + H₂O over the full composition range, along with those of the single salt systems. Boiling temperatures were also measured for the four component NaCl + NaNO₃ + KNO₃ + H₂O and five component NaCl + NaNO₃ + KNO₃ + Ca(NO₃)₂ + H₂O mixtures, where the solute mole fraction of Ca(NO₃)₂, x{Ca(NO₃)₂}, was varied between 0 and 0.25. The maximum boiling temperature found for the NaCl + KNO₃ + H₂O system is ≈134.9 ^∘C; for the NaNO₃ + KNO₃ + H₂O system is ≈165.1 ^∘C at x(NaNO₃) ≈ 0.46 and x(KNO₃) ≈ 0.54; and for the NaCl + Ca(NO₃)₂ + H₂O system is 164.7 ± 0.6 ^∘C at x{NaCl} ≈ 0.25 and x{Ca(NO₃)₂} ≈ 0.75. The NaCl + NaNO₃ + KNO₃ + Ca(NO₃)₂ + H₂O system forms molten salts below their maximum boiling temperatures and the temperatures corresponding to the cessation of boiling (dry-out temperatures) of these liquid mixtures were determined. These dry-out temperatures range from ≈300 ^∘C when x{Ca(NO₃)₂} = 0 to ≥ 400 ^∘C when x{Ca(NO₃)₂} = 0.20 and 0.25. Mutual deliquescence/efflorescence relative humidity (MDRH/MERH) measurements were also made for the NaNO₃ + KNO₃ and NaCl + NaNO₃ + KNO₃ salt mixture from 120 to 180 ^∘C at ambient pressure. The NaNO₃ + KNO₃ salt mixture has a MDRH of 26.4% at 120 ^∘C and 20.0% at 150 ^∘C. This salt mixture also absorbs water at 180 ^∘C, which is higher than expected from the boiling temperature experiments. The NaCl + NaNO₃ + KNO₃ salt mixture was found to have a MDRH of 25.9% at 120 ^∘C and 10.5% at 180 ^∘C. The investigated mixture compositions correspond to some of the major mineral assemblages that are predicted to control brine composition due to the deliquescence of salts formed in dust deposited on waste canisters in the proposed nuclear repository at Yucca Mountain, Nevada.     

Facile and practical enantioselective synthesis of propargylic alcohols by direct addition of alkynes to aldehydes catalyzed by chiral disulfide–oxazolidine ligands

The enantioselective alkynylation reaction of aldehydes with alkynes and diethylzinc, catalyzed by chiral disulfide–oxazolidine ligands, provides a simple, practical and inexpensive method to access chiral propargylic alcohols in good yields and satisfactory ee's.     

Computational examination of the electrophilic reaction on oxidative polymerization of phenyltrimethylsilane with sulfur chloride

Phenyltrimethylsilane possesses a higher HOMO energy (–9.34 eV) than nonsubstituted benzene (>0.41 eV). The π electron of the phenyltrimethylsilane localizes on the benzene ring at the ipso position rather than at the para position. Two center energies calculated by the MNDO-PM3 method indicate that the C? Si bond is facilitated to cleave in comparison with the C? H (para position) one of the benzene ring. Phenyltrimethylsilane and phenyl bis(trimethylsilane) were polymerized with sulfur chloride through the cationic oxidative polymerization. The product is isolated as oligo(p-phenylene sulfide), with a melting point of 150–190°C. An electrophile attacks the carbon atom linked to the Si atom in phenyltrimethylsilane. The new synthetic route of PPS can be established on the basis of the computational calculation.